Description : In a flooded evaporator refrigerator, an accumulator at suction of compressor is used to (a) collect liquid refrigerant and prevent it from going to compressor (b) detect liquid in vapour (c) superheat the vapour (d) increase refrigeration effect
Last Answer : Ans: a
Description : In vapour compression cycle using NH3 as refrigerant, initial charge is filled at (a) suction of compressor (b) delivery of compressor (c) high pressure side close to receiver (d) low pressure side near receiver
Last Answer : Ans: c
Description : The lower horizontal line of the refrigeration cycle plotted on pressure-enthalpy-diagram represents (a) condensation of the refrigerant vapour (b) evaporation of the refrigerant liquid (c) compression of the refrigerant vapour (d) metering of the refrigerant liquid
Last Answer : Ans: b
Description : For proper refrigeration in a cabinet, if the temperature and vapour pressure difference between cabinet and atmosphereis high, then (a) bigger cabinet should be used (b) smaller cabinet should ... tight vapour seal should be used (d) refrigerant with lower evaporation temperature should be used
Description : In vapour compression refrigeration system, refrigerant occurs as liquid between (a) condenser and expansion valve (b) compressor and evaporator (c) expansion valve and evaporator (d) compressor and condenser
Description : The suction pipe diameter of refrigerating unit compressor in comparison to delivery side is (a) bigger (b) smaller (c) equal (d) smaller/bigger depending on capacity
Description : The ratio of work done per cycle to the stroke volume of the compressor is known as A. Compressor capacity B. Compression ratio C. Compressor efficiency D. Mean effective pressure
Last Answer : ANSWER : D
Description : The general rule for rating refrigeration systems (excepting for CO2 system) is to approximate following h.p. per ton of Refrigeration (a) 0.1 to 0.5 h.p. per ton of refrigeration (b) 0.5 to 0.8 h.p. per ... (c) 1 to 2 h.p. per ton of refrigeration (d) 2 to 5 h.p. per ton of refrigeration
Description : In a refrigeration cycle, the flow of refrigerant is controlled by (a) compressor (b) condenser (c) evaporator (d) expansion valve
Last Answer : Ans: d
Description : Where does the lowest temperature occur in a vapour compression cycle ? (a) condenser (b) evaporator (c) compressor (d) expansion valve
Description : The higher temperature in vapour compression cycle occurs at (a) compressor discharge. (b) expansion valve (c) evaporator (d) condenser discharge
Description : Most of the domestic refrigerators work on the following refrigeration system (a) vapour compression (b) vapour absorption (c) carnot cycle (d) electrolux refrigerator
Description : Ammonia-absorption refrigeration cycle requires (a) very little work input (b) maximum work input (c) nearly same work input as for vapour compression cycle (d) zero work input
Description : Vapour compression refrigeration is some what like (a) Carnot cycle (b) Rankine cycle (c) reversedCamot cycle (d) reversed Rankine cycle
Last Answer : Ans: C
Description : A large clearance volume in a reciprocating compressor results in A. Reduced volume flow rate B. Increased volume flow rate C. Lower suction pressure D. Lower delivery pressure
Last Answer : ANSWER : A
Description : In a two stage reciprocating air compressor with a suction pressure of 2 bar and delivery pressure of 8 bar the ideal intercooler pressure will be A. 10 bar B. 6 bar C. 4 bar D. 3 bar
Last Answer : ANSWER : C
Description : In a single stage reciprocating air compressor, the work done on air to compressor is from suction pressure to delivery pressure will be minimum when the compression is A. Isothermal process B. Adiabatic process C. Polytropic process D. Constant pressure process.
Description : In a two stage reciprocating air compressor, the suction and delivery pressure are 1 and 4 bar respectively. For maximum efficiency the intercooler pressure is A. 1.5 bar B. 2 bar C. 2.5 bar D. 3 bar
Last Answer : ANSWER : B
Description : A large clearance volume in reciprocating compressor results in A. reduced volume flow rate B. Increased volume flow rate C. Lower suction pressure D. Lower delivery pressure
Description : Pick out the wrong statement. (A) A refrigeration cycle violates the second law of thermodynamics (B) Refrigeration cycle is normally represented by a temperature vs. entropy plot (C) In a refrigerator, ... (D) One ton of refrigeration is equivalent to the rate of heat absorption equal to 3.53 kW
Last Answer : (A) A refrigeration cycle violates the second law of thermodynamics
Description : In vapour compression cycle the condition off refrigerant is dry saturated vapour (a) after passing through the condenser (b) before passing through the condenser (c)before entering the expansion valve (d) before entering the compressor
Last Answer : Ans: D
Description : One ton of the refrigeration is (a) the standard unit used in refrigeration problems (b) the cooling effect produced by melting 1 ton of ice (c) the refrigeration effect to freeze 1 ton of water at ... ice at 0°C in 24 hours (d) the refrigeration effect to produce 1 ton of ice at NTP conditions
Description : In S.J. unit, one ton of refrigeration is equal to (a) 210 kJ/min (b) 21 kJ/min (c) 3.5 kJ/min (d) 2.4 kJ/min
Description : One ton of refrigeration is equal to the refrigeration effect corresponding to melting of 1000 kg of ice (a) in 1 hour (b) in 1 minute (c) in 24 hours (d) in 12 hours
Description : In a single acting reciprocating compressor, the suction, compression and delivery of air takes place in A. One stroke B. Two stroke C. Three stroke D. Four stroke
Description : In a refrigeration cycle, the super heating……..C.O.P (a)decreases (b)does not change (c) increases (d)none of the above
Description : Under-cooling in a refrigeration cycle (a) increases COP (b) decreases COF (c) COP remains unaltered (d) other factors decide COP
Description : Superheating in a refrigeration cycle (a) increases COP (b) decreases COP (c) COP remains unaltered (d) other factors decide COP
Description : A refrigerator is working on reversed carnot cycle between temperature of 30°C to –10°C with capacity of 10 tonnes. Calculate. (i) The COP (ii) Define ton of refrigeration (iii) Give the industrial application of refrigeration
Last Answer : (ii) Ton of refrigeration: It is defined as the quantity of heat required to be removed from 1Ton water at 0oC to get ice at 0oC in one day. (iii) Industrial applications of refrigeration ... food stuff such as meat, fruit, fruit juice, vegetables etc. 5. Ice cooling of concrete for dam.
Description : One of the purposes of sub-cooling the liquid refrigerant is to (a) reduce compressor overheating (b) reduce compressor discharge temperature (c) increase cooling effect (d) ensure that only liquid and not the vapour enters the expansion (throttling) valve
Description : Which one of the following statement is not correct for the volumetric efficiency of a reciprocating air compressor? A. It decreases with increase in ambient temperature B. It increases with ... It increases with decrease in clearance ratio D. It decreases with increases in delivery pressure
Description : In four stroke engine which of the following is also known as power stroke a. Suction stroke b. Compression stroke c. Expansion stroke d. Exhaust stroke (Ans:c) Measurements of fuel and air ... into IC engine,___________its efficiency A. increase B. decrease C. does not alter D. unpredictable on
Description : The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P. (a) more (b) less (c) equally. (d) unpredictable
Description : The C.O.P. of a refrigeration cycle with lowering of condenser temperature, keeping the evaporator temperatureconstant, will (a) increase (b) decrease (c) may increase or decrease depending on the type of refrigerant used (d) remain unaffected
Description : The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature constant, will (a) increase (b) decrease (c) remain unaffected (d) may increase or decrease depending on the type of refrigerant used
Description : A refrigeration cycle operates between condenser temperature of + 27°C and evaporator temperature of- 23°C. TheCarnot coefficient of performance of cycle will be (a) 0.2 (b) 1.2 (c) 5 (d) 6
Description : Highest temperature encountered in refrigeration cycle should be (a) near critical temperature of refrigerant (b) above critical temperature (c) atcritica. temperature (d) much below critical temperature
Description : The power required to drive a turbo compressor for a given pressure ratio decreases when A. Air is heated at entry B. Air is cooled at entry C. Air is cooled at exit D. Air is heated at exit
Description : The volume of air delivered by the compressor is called A. Free air delivery B. Compressor capacity C. Swept volume D. Mean effective pressure
Description : In a reciprocating air compressor the compressor work per kg of air A. Increases as clearance volume increases B. Decreases as clearance volume increases C. Is independent of clearance volume D. Increases with clearance volume only of multistage compressor
Description : The capacity of the compressor will be highest when its intake temperature is A. Lowest B. highest C. Atmospheric D. Unpredictable
Description : Which one of the following statements are correct for reciprocating air compressor? A. Its volumetric efficiency increases with increasing clearance ratio B. Its volumetric efficiency increases ... ratio D. Its volumetric efficiency decreases with increasing clearance ratio and pressure ratio
Description : In a refrigeration system, heat absorbed in comparison to heat rejected is (a) more (b) less (c) less for small capacity and more for high capacity. (d) more for small capacity and less for high capacity
Description : In vapour compression cycle, the condition of refrigerant is high pressure saturated liquid (a) after passing through the condenser (b) before passing through the condenser (c) after passing through the expansion or throttle valve (d) before entering the expansion valve
Description : Air refrigeration cycle is used in (a) domestic refrigerators (b) gas liquefaction (c)commercial refrigerators (d) Chillers
Description : Air refrigeration cycle is used in (a) domestic refrigerators (b) commercial refrigerators (c) air conditioning (d) gas liquefaction
Description : Air refrigeration operates on (a) Carnot cycle (b) Reversed Carnot cycle (c) Rankine cycle (d) Brayton cycle.
Description : Formation of frost on evaporator in refrigerator (a) results in loss of heat due to poor heat transfer (b) increases heat transfer rate (c) decreases compressor power. (d) can be avoided by proper design
Description : The benchmarking parameter for a vapour compression refrigeration system is a) kW / kg of refrigerant used b) kcal / m3 of chilled water c) BTU / Ton of Refrigeration d) kW / Ton of Refrigeration
Last Answer : d) kW / Ton of Refrigeration
Description : The ratio of indicated power to shaft power of the engine required to drive the compressor is called A. Compressor efficiency B. Volumetric efficiency C. Isothermal efficiency D. Mechanical efficiency