Please Log in or Register for more.

Explain DC coupled drive circuit with unipolar output.

515 views

1 Answer

Answer :

DC coupled drive circuit with unipolar output:

The figure shows the circuit and waveforms

image

Like 0 like

Please log in or register to answer this question.

Related Questions


Explain MOSFET gate drive circuit and totem pole configuration.
Last Answer : MOSFET gate drive circuit: The turning on and turning off of MOSFET can be controlled from gate to source voltage signal. If the gate to source voltage of MOSFET exceeds threshold ... this configuration, the two switches (transistors) are used in totem pole arrangement with a comparator.

Show More

348 views 1 answer







Explain open emitter BJT drive circuit.
Last Answer : open emitter BJT drive circuit:

Show More

262 views 1 answer







Explain thyristor gate drive circuit.
Last Answer : Thyristor Gate Drive Circuit: The thyristor can be turned on by pulse voltage signal at gate terminal and it does not require continuous drive signal like the transistor. The gate ... circuit provide required minimum gate voltage and gate current then the thyristor conducts properly.

Show More

3.0k views 1 answer








Last Answer : IGBT is a bipolar device.

Show More

322 views 1 answer







basic gate drive circuit of GTO
Last Answer : basic gate drive circuit of GTO

Show More

896 views 1 answer







What is the difference between AC and DC drive?
Last Answer : AC means alternating current It's Frequency is 50hz Dc means direct current ItsI Frequency is 0Hz

Show More

156 views 1 answer







Compare between BJT and FET on the basis of (i) Biolar/Unipolar (ii) Tharmal Runaway (iii) Noise (iv) Applications
Last Answer : Parameter BJT FET Bipolar/Unipolar It is bipolar device i.e. current in this device is carried by electrons and holes. It is unipolar device i.e. current ... in oscilloscopes, electronic voltmeters and other measuring and testing equipment because of their high input impedance.

Show More

757 views 1 answer







State the need of cascade amplifier and draw circuit diagram of 2-stage direct coupled amplifier.
Last Answer : Need:- The voltage (or power) gain, obtained from a single stage small signal amplifier, is limited. Therefore, it is not sufficient for all practical applications. Therefore, in order to obtain greater voltage and power gain, cascade amplifiers are used.

Show More

512 views 1 answer







Explain the pulse width modulation technique for control of AC output voltage.

Show More

101 views 0 answers







State maximum power transfer theorem for DC circuit.
Last Answer : Maximum power transfer theorem for DC circuit: The maximum power transfer theorem states that the source or a network transfers maximum power to load only when the load resistance is equal ... removed (disconnected) ii) All internal independent sources are replaced by their internal resistances.

Show More

110 views 1 answer







Define- (i) Node (ii) Loop for a DC circuit
Last Answer : Ans: i) Node: A point or junction at which two or more elements of network are connected is called as node. ii) Loop: A closed path for flow of current in an electrical circuit is called loop.

Show More

71 views 1 answer







For a DC circuit capacitor is
Last Answer : For a DC circuit capacitor is virtually an open circuit

Show More

93 views 1 answer







A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the
Last Answer : A DC voltage source is connected across a series RLC circuit. Under steady-state conditions, the applied DC voltage drops entirely across the C only

Show More

2.0k views 1 answer







A circuit that binds the upper or lower extreme of a waveform to a fixed DC voltage level is called ______ A) DC voltage restorer B) Clamping circuit C) Both A and B D) None of these
Last Answer : A circuit that binds the upper or lower extreme of a waveform to a fixed DC voltage level is called ______ A) DC voltage restorer B) Clamping circuit C) Both A and B D) None of these

Show More

106 views 1 answer







Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these
Last Answer : Consider a circuit with three parallel branches connected across a DC supply. What is the ratio of the branch currents I1 : I2 : I3 if the branch resistances are in the ratio of 2 : 3 : 4 respectively? A) 2 : 3 : 4 B) 6 : 4 : 3 C) 4 : 3 : 2 D) None of these

Show More

211 views 1 answer







What is DC analysis of a circuit?

Show More

93 views 0 answers







 applications of RC coupled amplifier
Last Answer : Applications of RC coupled amplifier: (i) Widely used as Voltage amplifiers. (ii) They are used in Public Address System. (iii) In Tape recorders. (iv) In stereo amplifiers (v) In T.V. V.C.R. and C.D. Players.

Show More

92 views 1 answer







advantages and disadvantages of direct coupled amplifier over RC coupled amplifier. 
Last Answer : Advantages:  Due to absence of coupling capacitors, the gain does not reduce on the lower frequency side.  This amplifier can amplify dc signals. Reduced cost and complexity due to absence of ...   The output waveform has a dc shift.  Poor frequency response at a higher frequency.

Show More

612 views 1 answer







 transformer coupled amplifier
Last Answer :  transformer coupled amplifier

Show More

94 views 1 answer







State the need of multistage amplifier. Draw frequency response of R-C coupled amplifier.
Last Answer : The need of multistage amplifier The voltage (or power) gain, obtained from a single stage small signal amplifier, is limited. Therefore, it is not sufficient for all practical applications. Therefore, in ... to use a MULTISTAGE AMPLIFIER .  Frequency response of R-C coupled amplifier.

Show More

168 views 1 answer







Compare RC coupled, transformer coupled and direct coupled amplifier based on four points.
Last Answer : Parameter RC coupled Transformer coupled Direct coupled  Coupling element Resistor and capacitor Transformer No element Impedance matching Poor Excellent good Frequency ... Low frequency amplifier,opamp Size and cost small Large and bulky least

Show More

3.0k views 1 answer







List the advantages of RC coupled amplifier.
Last Answer : Advantages: 1. The frequency response is excellent 2. The circuit is very compact and extremely light 3. Cost is low because it employ resistors and capacitors which are cheap 

Show More

110 views 1 answer








Last Answer : An alternator coupled to a hydraulic turbine runs at slow speed, as compared to others.

Show More

105 views 1 answer







Explain full wave bridged rectifier with the help of circuit diagram and input output waveform.
Last Answer : 1. In positive half cycle (0 to Π): The end A of the secondary winding becomes positive and end B negative. This makes diode D1 and D4 forward biased while diode D2 and D3 are reverse biased. These two diodes will ... D2 and D3 when it is conducting is as follows.  B - D2 - RL - D3 - A 

Show More

162 views 1 answer







Explain transformer isolated drive circuits providing both signal and power.

Show More

85 views 0 answers







State the need for reduction of harmonics in inverters. Enlist the various methods for reduction of harmonics in inverter output.

Show More

55 views 0 answers







What is the need for electrically isolated drive circuits?

Show More

65 views 0 answers







What are the fundamental requirements of gate drive ICs?

Show More

112 views 0 answers







A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is (A) 300 W (B) 150 W (C) 45 W (D) 20 W
Last Answer : A d.c. source has an open circuit voltage of 30 V and an internal resistance of 1.5 Ohm. A resistive load is connected to the source. Maximum power dissipated in the load is 150 W

Show More

289 views 1 answer







The power factor of a D.C. circuit is always?
Last Answer : The power factor of a D.C. circuit is always unity.

Show More

219 views 1 answer







All the rules and laws of D.C. circuit also apply to A.C. circuit containing?
Last Answer : All the rules and laws of D.C. circuit also apply to A.C. circuit containing resistance only.

Show More

245 views 1 answer








Last Answer : If a D.C. shunt motor is working at full load and if shunt field circuit suddenly opens this will make armature to take heavy current, possibly burning it.

Show More

158 views 1 answer







What Are Input & Output Devices?
Last Answer : Answer :Keyboards, Floppy disk are the examples of input devices. Printer, LED / LCD display, CRT Monitor are the examples of output devices.

Show More

24 views 1 answer







Analyze the effect of supply voltage on performance of LED as regards current, Lumen output, efficacy and life. 
Last Answer : 1) Effect on Current:- In LED current depends upon supply voltage, if voltage get changes then current also change but this change in current will be control by resistors which are connected in series.  2) ...   4) Effect on Life:- If supply voltage is not stable then life of LED get reduced. 

Show More

106 views 1 answer







With the help of N-channel JFET describe the effect of input voltage VGS on output current ID.
Last Answer : Working of N channel FET: * When a voltage is applied between the drain and source with a DC supply (VDD), the electrons flows from source to drain through narrow channel ... where the channel gets completely blocked and the drain current becomes zero is called pinch- off voltage. 

Show More

231 views 1 answer







Define: i) Input Offset Voltage ii) Input offset Current iii) Input Bias Current iv) Output offset voltage
Last Answer : Definition of parameters of OPAMP is follows:  i) Input Offset Voltage: Input offset voltage is defined as the voltage that must be applied between the two input terminals of an OPAMP to null or ... to ground) and output voltage is obtained non zero such voltage is output offset voltage of opamp.

Show More

680 views 1 answer







A linear network has a current input 4cos(ω t + 20º)A and a voltage output 10 cos(ωt +110º) V. Determine the associated impedance.
Last Answer : Solution

Show More

158 views 1 answer







The largest change of input quantity for which there is no output of instrument is called ______ A) Dead time B) Dead input C) Dead output D) Dead zone
Last Answer : The largest change of input quantity for which there is no output of instrument is called Dead zone

Show More

859 views 1 answer







In a battery, the difference between the no-load voltage and the measured voltage output is called ________ A) Internal voltage B) Internal resistance C) External resistance D) All the above
Last Answer : In a battery, the difference between the no-load voltage and the measured voltage output is called Internal resistance

Show More

123 views 1 answer







2.6k views 0 answers







A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would  (1) increase progressively  (2 ... 0.5 and then increase  (4) increase to a maximum value at α = 0.5 and then decrease
Last Answer : A dc chopper is fed from a constant voltage mains the duty ratio of chopper is progressively increased while the chopper feeds an RL load. The per unit current ripple would increase to a maximum value at α = 0.5 and then decrease

Show More

523 views 1 answer







A 3 -phase, fully controlled, converter is feeding power into a DC load at a constant current of 150 A, the rms value of the current flowing through each thyristor of the converter is
Last Answer : Please show the solution for this question

Show More

515 views 2 answers







How is a thyristor used to convert AC to DC?
Last Answer : thyristor

Show More

123 views 1 answer








Last Answer : Yes ,it is one of the main advantage using thristors as a  switch in DC  circuit ,it has a high current gain

Show More

160 views 2 answers







Can transformer convert AC to DC?
Last Answer : No, Transformer cannot convert AC to DC.

Show More

3.0k views 9 answers








Last Answer : NO IT ONLY CONVERT FROM AC TO DC BECAUSE DIODE WHICH ARE USED IN IT, ARE UNIDIRECTIONAL.

Show More

148 views 2 answers








Last Answer : IT CHANGES NEGATIVE CYCLE IN TO POSITIVE CYCLE FROM AC CURRENT.

Show More

139 views 2 answers







A 40 W bulb is connected in series with a room heater. If now 40 W bulb is replaced by 100 W bulb, the heater output will?
Last Answer : A 40 W bulb is connected in series with a room heater. If now 40 W bulb is replaced by 100 W bulb, the heater output will increase.

Show More

195 views 1 answer







Will installing Ubuntu on my USB Drive hurt my Windows partition?
Last Answer : No, booting from a USB stick will in no way affect your Windows installation. You can, however, manipulate files on your Windows partition from within Linux, which is handy if you have a crash, or otherwise cannot access Windows.

Show More

1 view 1 answer







How to Drive Uphill Faster
Last Answer : How to Drive Uphill Faster Encountering steep hills when driving is very common, and while it looks easy, it can be very difficult, especially for a beginner. If you want to drive a car uphill at a ... how to do it properly, you can easily master it. Just remember to keep safe while doing this.

Show More

9 views 1 answer






Show More⇦ PreviousNext ⇨