Description : ___ Connection and the _______ instruction will solve the problem of synchronization between processor and coprocessor. a) INT & NMI, WAIT b) RQ/GT0 & RQ/GT1, FWAIT c) BUSY & TEST, FWAIT d) S0 & QS0, WAIT
Last Answer : b) RQ/GT0 & RQ/GT1, FWAIT
Description : ______ input is available, so that another coprocessor can be connected and function in _________ with the 8087. . a) RQ/GT0, parallel b) RQ/GT1, parallel c) QS1 & QS0, parallel d) S0 & S1, parallel.
Last Answer : a) RQ/GT0, parallel
Description : One of the following signals belongs to the 8087 coprocessor is a. HOLD b. BUSY c. TEST d. NMI
Last Answer : c. TEST
Description : 8087 connection to 8086, to enable the _________ bank of memory _______pins are to be connected. a) Lower, BHE b) Upper, BHE c) Lower, INT d) Upper, INT.
Last Answer : a) Lower, BHE
Description : The external device is connected to a pin called the ______ pin on the processor chip. a. Interrupt b. Transfer c. Both d. None of these
Last Answer : a. Interrupt
Description : Why 8087 is referred to as Coprocessor? i) Because 8087 is used in parallel with main processor in a system, rather than serving as a main processor itself. ii) Because 8087 is used in serial with main processor in a ... math computations. a) i & iii b) ii & iii c) iii only. d) i only.
Last Answer : c) iii only.
Description : BHE of 8086 microprocessor signal is used to interface the a) Even bank memory b) Odd bank memory c) I/O d) DMA
Last Answer : b) Odd bank memory
Description : n 8086 microprocessor the following has the highest priority among all type interrupts. a) NMI b) DIV 0 c) TYPE 255 d) OVER FLOW
Last Answer : a) NMI
Description : Serial port vector address is of _______. And causes an interrupt when ________. a) 0013H, either TI or RI flag is set b) 0023H, either TI or RI flag is reset c) 0013H, either TI or RI flag is reset d) 0023H, either TI or RI flag is set
Last Answer : a) 0013H, either TI or RI flag is set
Description : In 8051 an external interrupt 1 vector address is of ________ and causes of interrupt if ____. a) 000BH, a high to low transition on pin INT1 b) 001BH, a low to high transition on pin INT1 c) 0013H, a high to low transition on pin INT1 d) 0023H, a low to high transition on pin INT1
Last Answer : a) 000BH, a high to low transition on pin INT1
Description : The interrupt vector table of 80386 has been allocated ______ space starting from _______ to _______. a) 1Kbyte, 00000H, 003FFH b) 2Kbyte, 10000H, 004FFH c) 3Kbyte, 01000H, 007FFH d) 4Kbyte, 01000H, 009FFH
Last Answer : c) 3Kbyte, 01000H, 007FFH
Description : RIM is used to check whether, ______ a) The write operation is done or not b) The interrupt is Masked or not c) a & b
Last Answer : b) The interrupt is Masked or not
Description : In 8087 coprocessor one of the following instructions is not valid a. FSIN b. FPTAN c. FIDIV d. FSQRT
Last Answer : a. FSIN
Description : Which of the following is of compare instruction in 8087? a) FTST b) FPREM c) FPATAN d) FLDI
Last Answer : a) FTST
Description : In 8087, which instruction is used for division real reversed______. a) FDIV b) FIDIVR c) FDIVR d) FDIVRP
Last Answer : c) FDIVR
Description : In 8087, _______ many register stack are there? And of _____ registers. These registers are used as _________ stack. a) 7, 40 bit, FIFO. b) 8, 60 bit, LILO. c) 8, 80 bit, LIFO d) 7, 80 bit, FILO.
Last Answer : b) 8, 60 bit, LILO.
Description : The microprocessor can read/write 16 bit data from or to ________ A. memory B. I /O device C. processor D. register
Last Answer : The microprocessor can read/write 16 bit data from or to memory
Description : L2 cache memory is places at ______ a. On Processor b. On Mother Board c. On Memory d. All of these
Last Answer : b. On Mother Board
Description : L1 cache memory is places at ______ a. On Processor b. On Mother Board c. On Memory d. All of these
Last Answer : a. On Processor
Description : The 8051 microcontroller is of ___pin package as a ______ processor. a) 30, 1byte b) 20, 1 byte c) 40, 8 bit
Last Answer : c) 40, 8 bit
Description : The coprocessors operate in ______ with a processor on the same buses and with the same instruction _______. a) Parallel, byte stream. b) Series, byte stream. c) Series, bite stream d) Parallel, bite stream.
Last Answer : a) Parallel, byte stream.
Description : The 8051 microcontroller is of ___pin package as a ______ processor. a) 30, 1byte b) 20, 1 byte c) 40, 8 bit d) 40, 8 byte
Description : Match the following mechanisms for interrupting the execution of a process and their uses. i) Interrupt a) Call to an operating system function ii) Trap b) Reaction to an asynchronous external event iii) Supervisor Call c) Handling of a error ... -a, iii-b C) i-b, ii-c, iii-a D) i-a, ii-c, iii-b
Last Answer : C) i-b, ii-c, iii-a
Description : What is meant by interrupt?
Last Answer : Interrupt is an external signal that causes a microprocessor to jump to a specific subroutine.
Description : List the four instructions which control the interrupt structure of the 8085 microprocessor.
Last Answer : • DI ( Disable Interrupts ) • EI ( Enable Interrupts ) • RIM ( Read Interrupt Masks ) • SIM ( Set Interrupt Masks )
Description : Serial port interrupt is generated, if ____ bits are seta) IE b) RI, IE c) IP, TI d) RI, TI
Last Answer : d) RI, TI
Description : Which are the flags of status register: a. Over flow flag b. Carry flag c. Half carry flag d. Zero flag e. Interrupt flag f. Negative flag g. All of these
Last Answer : g. All of these
Description : In 8096 we have _____interrupt sources and _______ interrupt vectors. a) 18, 8 b) 21, 6 c) 21, 8 d) 16, 8
Last Answer : c) 21, 8
Description : In 8051 which interrupt has highest priority? a)IE1 b)TF0 c)IE0 d)TF1
Last Answer : a)IE1
Description : Serial port interrupt is generated, if ____ bits are set a) IE b) RI, IE c) IP, TI d) RI, TI
Last Answer : a) IE
Description : 8086 is interfaced to two 8259s (Programmable interrupt controllers). If 8259s are in master slave configuration the number of interrupts available to the 8086 microprocessor is a) 8 b) 16 c) 15 d) 64
Last Answer : a) 8
Description : In 8279, a scanned sensor matrix mode, if a sensor changes its state, the ___ line goes ____ to interrupt the CPU. a) CS, high b) A0, high c) IRQ, high d) STB, high
Last Answer : c) IRQ, high
Last Answer : c) 21,
Last Answer : c)IE0
Description : What is meant by Maskable interrupts? a) An interrupt which can never be turned off. b) An interrupt that can be turned off by the programmer. c) none
Last Answer : b) An interrupt that can be turned off by the programmer.
Description : What is SIM? a) Select Interrupt Mask b) Sorting Interrupt Mask c) Set Interrupt Mask.
Last Answer : c) Set Interrupt Mask.
Description : Which interrupt is not level sensitive in 8085? a) RST6.5 is a raising edge-trigging interrupt. b) RST7.5 is a raising edge-trigging interrupt. c) a & b.
Last Answer : b) RST7.5 is a raising edge-trigging interrupt.
Description : Which interrupt has the highest priority? a) INTR b) TRAP c) RST6.5
Last Answer : c) RST6.5
Description : Which is not the main feature of DEC Alpha: a. 64 Bit RISC processor b. Designed to replace 32 VAX(CISC) c. Seven stage split integer/floating point pipeline d. Variable Instruction length
Last Answer : d. Variable Instruction length
Description : Pentium Pro Processor contains: a. L1 Cache b. L2 Cache c. Both L1 & L2 d. None of these
Last Answer : c. Both L1 & L2
Description : Which processor provided 1 MB memory: a. 16-bit 8086 and 8088 b. 32-bit 8086 and 8088 c. 64-bit 8086 and 8088 d. 8-bit 8086 and 8088
Last Answer : a. 16-bit 8086 and 8088
Description : Which process information at a much faster rate than it can retrieve it from memory: a. ALU b. Processor c. Microprocessor d. CPU
Last Answer : d. CPU
Description : Motorola introduced 32 bit RISC processor called______: a. MC 88100 b. MC 81100 c. MC 80100 d. MC 81000
Last Answer : a. MC 88100
Description : Motorola introduced _____ processor: a. 2 bit-RISC b. 4 bit-RISC c. 8 bit-RISC d. 32 bit-RISC
Last Answer : d. 32 bit-RISC
Description : HMOS stands for: a. High performance metal oxide semiconductor b. High processor metal oxide semiconductor c. Both A and b d. None of these
Last Answer : a. High performance metal oxide semiconductor
Description : Which are some of popular processor: a. Motorola 6800 and 6809 b. Intel 8085 c. Zilog Z80 d. All the above
Last Answer : d. All the above
Description : Which is the parts of memory unit: a. Processor memory b. Main memory c. Secondary memory d. All of these
Last Answer : d. All of these
Description : A time sharing system imply a. more than one processor in the system b. more than one program in memory c. more than one memory in the system d. None of above
Last Answer : b. more than one program in memory
Description : The first processor to include Virtual memory in the Intel microprocessor familywas: a.)80286 b.)80386c.)80486d.)Pentium
Last Answer : a.)80286