The value memvar must be transferred to the ___:
a. Computer
b. CPU
c. Both A and B
d. None of these

1 Answer

Answer :

b. CPU

Related questions

Description : The information is transferred from the_____ and ____ specified register: a. MDR b. CPU c. Both A and B

Last Answer : c. Both A and B

Description : The CPU removes the ___ signal to complete the memory write operation: a. Read b. Write c. Both A and B d. None of these

Last Answer : a. Read

Description : The information on the data bus is transferred to the ______register: a. MOC b. MDR c. VAM d. CPU

Last Answer : b. MDR

Description : In 8279, a scanned sensor matrix mode, if a sensor changes its state, the ___ line goes ____ to interrupt the CPU. a) CS, high b) A0, high c) IRQ, high d) STB, high

Last Answer : c) IRQ, high

Description : SP of 8051 is of ___ wide and it is loaded with the default value of ___ after reset. a) 2 byte, 08H b) 8 bit, 07H c) 1 byte, 09H d) 8 bit, 06H

Last Answer : d) 8 bit, 06H

Description : A computer which has the microprocessor as______ is called as a microcomputer: a. CPU b. ALU c. RU

Last Answer : a. CPU

Description : Which is the components of computer: a. System Bus b. CPU c. Memory Unit d. All of these

Last Answer : d. All of these

Description : Where does a computer add and compare data? a. Hard disk b. Floppy disk c. CPU chip d. Memory chip

Last Answer : c. CPU chip

Description : Which computer memory is used for storing programs and data currently being processed by the CPU? a. Mass memory b. Internal memory c. Non-volatile memory d. PROM

Last Answer : b. Internal memory

Description : The brain of any computer system is a. ALU b. Memory c. CPU d. Control unit

Last Answer : c. CPU

Description : The use of spooler programs and/or …. Hardware allows personal computer operators to do the processing work at the same time a printing operation is in progress a. Registered mails b. Memory c. CPU d. Buffer

Last Answer : d. Buffer

Description : An error in computer data is called a. Chip b. Bug c. CPU d. Storage device

Last Answer : b. Bug

Description : What is the responsibility of the logical unit in the CPU of a computer? a. To produce result b. To compare numbers c. To control flow of information d. To do math’s works

Last Answer : b. To compare numbers

Description : a computer which CPU speed around 100 million instruction per second and with the word length of around 64 bits is known as a. Super computer b. Mini computer c. Micro computer d. Macro computer

Last Answer : a. Super computer

Description : A computer program that translates one program instructions at a time into machine language is called a/an a. Interpreter b. CPU c. Compiler d. Simulator

Last Answer : a. Interpreter

Description : In which form CPU provide output: a. Computer signals b. Digital signals c. Metal signals d. None of these

Last Answer : b. Digital signals

Description : Who is the brain of computer: a. ALU b. CPU c. MU d. None of these

Last Answer : b. CPU

Description : A microprocessor is a _______ chip integrating all the functions of a CPU of a computer.  A. multiple B. single C. double D. triple

Last Answer : A microprocessor is a single chip integrating all the functions of a CPU of a computer.

Description : Who is the represents the fundamental process in the operation of the CPU: a. The fetch-execute cycle and pipelining b. The assembly c. Both A and B d. None of these

Last Answer : a. The fetch-execute cycle and pipelining

Description : The ____ place the data from a register onto the data bus: a. CPU b. ALU c. Both A and B d. None of these

Last Answer : a. CPU

Description : The CPU sends out a ____ signal to indicate that valid data is available on the data bus: a. Read b. Write c. Both A and B

Last Answer : b. Write

Description : The upper red arrow show that CPU sends out the control signals____ and _____ indicate the data is read from the memory: a. Memory request b. Read c. Both A and B d. None of these

Last Answer : c. Both A and B

Description : When the RET instruction at the end of subroutine is executed, a. the information where the stack is iniatialized is transferred to the stack pointer b. the memory address of the RET instruction is ... two data bytes stored in the top two locations of the stack are transferred to the stack pointer

Last Answer : c. two data bytes stored in the top two locations of the stack are transferred to the program counter

Description : ___ memory system which is discussed later can improve matters in this respect: a. Data memory b. Cache memory c. Memory d. None of these

Last Answer : b. Cache memory

Description : Which point to the ___ of the stack: a. TOP b. START c. MID

Last Answer : a. TOP

Description : 80386 support overall ___ addressing modes to facilitate efficient execution of higher level language programs. a) 9 b) 10 c) 11 d) 12

Last Answer : 11

Description : The ___ bit decides whether it is a system descriptor or code/data segment descriptor a) P b) S c) D d) G

Last Answer : a) P

Description : In 8096, mode ____ of serial port are ___ modes commonly used for ____ communications. a) 1, 8bit, single processor b) 0, 7bit, multiple microcontroller c) 2, 9 bit, multiple processors d) 3, 8 bit, multiple microcontroller

Last Answer : a) 1, 8bit, single processor

Description : 8096 write-protected mode, no code can write to memory address between __. a) 2020 to 3FFFH b) 8000 to FFFFH c) 2000 to 3FFFH d) 2020 to 202FH 17. If the __ pin is ___ , then we have the option ... b) EA, low, internal, external c) EA, high, external, internal d) EA, low, external, internal

Last Answer : c) EA, high, external, internal

Description : 8096 has ___ general purpose I/O ports, Port 2 includes ______ of the following i) two quasi-bidirectional I/O lines ii) two output lines iii) four input lines iv) open drain outputs a) 4, i, iv b) 6, ii, iii c) 4, i,ii,iii d) 6, i, ii, iv

Last Answer : c) 4, i,ii,iii

Description : Intel 8096 is of ___ bit microcontroller family called as ______. a) 8, MCS51 b) 16, MCS51 c) 8, MCS96 d) 16, MCS96

Last Answer : d) 16, MCS96

Description : The SP is of ___ wide register. And this may be defined anywhere in the ______. a) 8 byte, on-chip 128 byte RAM. b) 8 bit, on chip 256 byte RAM. c) 16 bit,

Last Answer : a) 8 byte, on-chip 128 byte RAM.

Description : ___ Connection and the _______ instruction will solve the problem of synchronization between processor and coprocessor. a) INT & NMI, WAIT b) RQ/GT0 & RQ/GT1, FWAIT c) BUSY & TEST, FWAIT d) S0 & QS0, WAIT

Last Answer : b) RQ/GT0 & RQ/GT1, FWAIT

Description : In 8096, mode ____ of serial port are ___ modes commonly used for ____ communications. a) 1, 8bit, single processor b) 0, 7bit, multiple microcontroller c) 2, 9 bit, multiple processors d) 3, 8 bit, multiple microcontroller

Last Answer : c) 2, 9 bit, multiple processors

Description : If the __ pin is ___ , then we have the option of using the ____ ROM or EPROM together with _____ memory and devices. a) EA, high, internal, external b) EA, low, internal, external c) EA, high, external, internal d) EA, low, external, internal

Last Answer : a) EA, high, internal, external

Description : 8096 has ___ general purpose I/O ports, Port 2 includes ______ of the following i) two quasi-bidirectional I/O lines ii) two output lines iii) four input lines iv) open drain outputs a) 4, i, iv b) 6, ii, iii c) 4, i,ii,iii d) 6, i, ii, iv

Last Answer : c) 4, i,ii,iii

Description : Intel 8096 is of ___ bit microcontroller family called as ______. a) 8, MCS51 b) 16, MCS51 c) 8, MCS96 d) 16, MCS96

Last Answer : d) 16, MCS96

Description : PC’s use____ based on this architecture: a. CPU b. ALU c. MU

Last Answer : a. CPU

Description : Which process information at a much faster rate than it can retrieve it from memory: a. ALU b. Processor c. Microprocessor d. CPU

Last Answer : d. CPU

Description : Microprocessor is fabricated on single chip using: a. MOS b. ALU c. CPU d. All of these

Last Answer : a. MOS

Description : In immediate addressing the operand is placed a. in the CPU register b. after OP code in the instruction c. in memory d. in stack

Last Answer : b. after OP code in the instruction

Description : The most common addressing techiniques employed by a CPU is a. immediate b. direct c. indirect d. register e. all of the above

Last Answer : e. all of the above

Description : What is the control unit's function in the CPU? a. To transfer data to primary storage b. to store program instruction c. to perform logic operations d. to decode program instruction

Last Answer : b. to store program instruction

Description : CPU does not perform the operation a. data transfer b. logic operation c. arithmetic operation d. all of above

Last Answer : b. logic operation

Description : The ________ ensures that only one IC is active at a time to avoid a bus conflict caused by two ICs writing different data to the same bus.A.control busB.control instructionsC. address decoder D.CPU

Last Answer : C. address decoder

Description : Offline device is a. A device which is not connected to CPU b. A device which is connected to CPU c. A direct access storage device d. An I/O device

Last Answer : a. A device which is not connected to CPU

Description : What type of memory is not directly addressable by the CPU and requires special softw3are called EMS (expanded memory specification)? a. Extended b. Expanded c. Base d. Conventional

Last Answer : b. Expanded

Description : Which is an item of storage medium in the form of circular plate? a. Disk b. CPU c. Printer d. ALU

Last Answer : a. Disk

Description : . An online backing storage system capable of storing larger quantities of data is a. CPU b. Memory c. Mass storage d. Secondary storage

Last Answer : c. Mass storage

Description : Interface electronic circuit is used to interconnect I/O devices to a computer’s CPU or a. ALU b. Memory c. Buffer d. Register

Last Answer : b. Memory