Description : Which of the following fuels is the best for burning on chain grate stoker? (A) Non-caking coal (B) Caking coal (C) Coking coal (D) Pulverised coal
Last Answer : (A) Non-caking coal
Description : Caking coal is desirable for (A) Burning on travelling grate (B) Coke making (C) Burning on firebars (D) All (A), (B) and (C)
Last Answer : (B) Coke making
Description : The advantages of firing pulverised coal in the furnace lies in the fact that, it (A) Permits the use of high ash content coal (B) Permits the use of low fusion point ash coal (C) Accelerates the burning rate and economises on fuel consumption (D) All (A), (B) and (C)
Last Answer : (C) Accelerates the burning rate and economises on fuel consumption
Description : The advantage of firing pulverised coal in the furnace lies in the fact, that it (A) Permits the use of high ash content coal (B) Permits the use of low fusion point ash coal (C) Accelerates the burning rate and economises on fuel combustion (D) All (A), (B) and (C)
Last Answer : (C) Accelerates the burning rate and economises on fuel combustion
Description : Coal is pulverised before burning in large capacity boiler furnaces mainly to (A) Ensure its complete combustion (B) Facilitate easy ash removal (C) Enhance its calorific value (D) Provide trouble free operation
Last Answer : (A) Ensure its complete combustion
Description : Which of the following would require maximum amount of % excess air for complete combustion? (A) Coke oven gas (B) Furnace oil (C) Pulverised coal (D) Lump coal (fixed on chain grate)
Last Answer : (D) Lump coal (fixed on chain grate)
Description : Function of secondary air in pulverised coal firing is to (A) Transport the coal to the burner (B) Dry the coal (C) Ensure efficient burning of coal around the burner (D) Reduce primary air requirement
Last Answer : (C) Ensure efficient burning of coal around the burner
Description : Softening temperature of coal ash is a measure of the __________ of coal. (A) Caking tendency (B) Coking tendency (C) Clinkering tendency (D) Size stability
Last Answer : (C) Clinkering tendency
Description : During combustion of coal on grate, clinker formation is increased by the (A) Use of thick fire bed (B) Low fusion point of ash (< 1100° C) (C) Use of preheated primary air (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : Pick out the wrong statement. (A) Indian coals on an average contain 25-30% ash as against 10-12% ash in imported coking coal (B) Ammonia is recovered in the form of ammonium sulphate in direct ... indicates poor caking properties of coal (D) Wash oil is used for scrubbing Benzol from coke oven gas
Last Answer : (C) A high swelling index number of coking coal indicates poor caking properties of coal
Description : Which of the following accentuates clinkering troubles on furnace grate burning coal? (A) Low reactivity of carbonised residue containing high proportion of iron & sulphur (B) Low forced draft & fuel bed temperature (C) Thick firebed and preheated primary air (D) All (A), (B) and (C)
Last Answer : (D) All (A), (B) and (C)
Description : Which of the following accentuates clinkering trouble on furnace grate burning coal? (A) Low reactivity of carbonised residue containing high proportions of iron & sulphur (B) Low forced draught and fuel bed temperature (C) Thick fire bed and preheated primary air (D) All (A), (B) and (C)
Description : Which of the following is the most important deterrents to an extended use of pulverised coal in boiler firing? (A) Ash disposal problem (B) Excessive fly-ash discharge from the stack (C) High power consumption in its transportation (D) Erosion of induced draft fan blades
Last Answer : (A) Ash disposal problem
Description : Pulverised coal used in boiler firing need not have (A) Less moisture content (B) High fusion point of its ash (C) High bulk density (D) Lower ash conten
Last Answer : (B) High fusion point of its ash
Description : Limestone powder is injected during pulverised coal burning in boilers to __________ the flue gases. (A) Reduce SO2 content in (B) Catalytically convert SO2 to SO3 in (C) Increase the dew point of (D) None of these
Last Answer : (A) Reduce SO2 content in
Description : A coal having higher volatile matter content will necessarily have lower (A) Ash fusion temperature (B) Calorific value (C) Ignition temperature (D) Caking index
Last Answer : (C) Ignition temperature
Description : The weathering index of a coal (A) Gives an idea of the fusion temperature of ash (B) Is related to its calorific value (C) Is a measure of its size stability, when stored & exposed to weather (D) Is a measure of its caking tendency
Last Answer : (C) Is a measure of its size stability, when stored & exposed to weather
Description : Washing of coal decreases its (A) Caking index (B) Mineral matter content (C) Ash content (D) Both (B) and (C)
Last Answer : (B) Mineral matter content
Description : Which of the following is the most important deterrents to an extended use of pulverised coal in boiler firing? (A) Ash disposal problem (B) Excessive fly ash discharge from the stack (C) Higher power consumption in its transportation (D) Erosion of induced draft fan blades
Description : Use of pulverised coal in boiler furnace provides (A) High calorific value (B) Better combustion (C) Smokeless burning (D) Less erosion on furnace walls
Last Answer : (B) Better combustion
Description : Coal is finally pulverised to 200 mesh size for burning in boilers by a (A) Hammer crusher (B) Ball mill (C) Roll crusher (D) Gyratory crusher
Last Answer : (B) Ball mill
Description : Use of pulverised coal in boilers provides (A) Higher calorific value (B) Better combustion (C) Smokeless burning (D) Less erosion on furnace wall
Description : Coals used for the generation of producer gas should have (A) High caking index (B) Low fusion point of ash (C) High volatile matter content (D) Very low ash content (8-10%)
Last Answer : (C) High volatile matter content
Description : Fat coals' are those coals which have very high (A) Caking capacity (B) Volatile matter content (C) Fusion point of its ash (D) Inherent moisture conten
Last Answer : (A) Caking capacity
Description : A coal with high ash content is undesirable, as (A) It is abrasive to the coal pulveriser (i.e. ball mill) and the combustion chamber (B) The ash in molten condition gets absorbed in the pores of the ... and stick to the boiler tubes thereby reducing the heat transfer (D) All (A), (B) and (C)
Description : With increase in the oxygen content of the coal, its __________ decreases. (A) Calorific value (B) Caking power (C) Both (A) & (B) (D) Neither (A) nor (B)
Last Answer : (C) Both (A) & (B)
Description : __________ of the coal is the basis for Seylor's coal classification. (A) Proximate analysis (B) Ultimate analysis (C) Caking index (D) Calorific value
Last Answer : (B) Ultimate analysis
Description : A coal that softens and fuses on heating is (A) Classified (B) Carbonised (C) Caking (D) Non-caking
Last Answer : (C) Caking
Description : Combustion of pulverised fuel (A) Requires larger combustion chamber than rich gaseous fuel (B) In a metallurgical furnace does not contaminate the product in the furnace by ash from fuel (C) Suppresses the discharge of fine dust and grit into atmosphere (D) All (A), (B) and (C)
Last Answer : (A) Requires larger combustion chamber than rich gaseous fuel
Description : Equipment used for pulverizing the coal is known as (A) Ball mill (B) Hopper (C) Burner (D) Stoker.
Last Answer : Ans: A
Description : Equipment used for pulverizing the coal is known as (A) Ball mill (B) Hopper (C) Burner (D) Stoker
Last Answer : Ball mill
Description : Pulverised coal passing through 200 mesh screen has a diameter of 0.074 mm (74 micron). The same passing through 50 mesh screen will have a dia of __________ mm. (A) 0.007 (B) 0.30 (C) 50 (D) 0.014
Last Answer : (B) 0.30
Description : Bulk density of pulverised coal may be about __________ kg/m3 . (A) 100 (B) 500 (C) 1000 (D) 1500
Last Answer : (B) 500
Description : Black smoke coming out of the chimney of a furnace is an indication of the use of __________ in the furnace. (A) Low amount of excess combustion air (B) Large quantity of excess combustion air (C) Hydrocarbon fuel (D) Pulverised coal as fuel
Last Answer : (A) Low amount of excess combustion air
Description : The excess air required for the combustion of pulverised coal is of the order of about __________ percent. (A) 5 (B) 15 (C) 30 (D) 45
Last Answer : (B) 15
Description : Combustion of pulverised coal as compared to that of lump coal (A) Develops a non-luminous flame (B) Develops a low temperature flame (C) Can be done with less excess air (D) Provides a lower rate of heat release
Last Answer : (C) Can be done with less excess ai
Description : Efficient burning of anthracite coal requires (A) Low preheat of air (B) Fine grinding (C) High excess air (D) All (A), (B) and (C)
Last Answer : (B) Fine grinding
Description : Conditioners like finely divided peat are added to the fertiliser to (A) Counteract burning (B) Avoid caking & hardening (C) Produce bulk (D) Increase its solubility
Last Answer : (B) Avoid caking & hardening
Description : which is better burning red ash or white ash coal
Last Answer : Need Answer
Description : Higher percentage of ash in coal meant for the production of metallurgical grade coke (A) Decreases the hardness of coke (B) Decreases the abrasion resistance of coke (C) Causes brittleness in steel (D) None of these
Last Answer : (D) None of these
Description : Grindability index of a coal is 100. It implies that the (A) Coal can be pulverised with great difficulty (B) Coal can't be pulverised (C) Coal can be easily pulverised (D) Power consumption in grinding the coal will be very high
Last Answer : (C) Coal can be easily pulverised
Description : Pick out the wrong statement. (A) Pulverised fuel can be completely burnt with less percentage of excess air compared to lump coal (B) Low grade coal can be used, but generally high volatile ... and atmosphere (oxidising or reducing) is easily possible with pulverised fuel firing (D) None of these
Description : Improper storage condition results in the weathering of coal and spontaneous combustion, which increases its (A) Caking index (B) Yield of carbonised products (C) Friability & oxygen content (D) Calorific value
Last Answer : (C) Friability & oxygen content
Description : Which of the following is a measure of the agglutinating (i.e., binding) property of coal? (A) Thickness of plastic layer (B) Caking index (C) Swelling index (D) Gray-king index
Last Answer : (B) Caking index
Description : Low temperature oxidation of coal during storage does not decrease its (A) Oxygen content (B) Caking power (C) Calorific value (D) None of these
Description : Low temperature oxidation of coal resulting from bad storage conditions does not decrease its (A) Caking power (B) Calorific value (C) Hydrogen content (D) Oxygen content
Last Answer : (D) Oxygen content
Description : Weathering of coal during storage causes (A) Reduction in coal size (B) Increase in its friability (C) Decrease in its caking capacity (D) All (A), (B) and (C)
Description : Low temperature oxidation of stored coal results in the (A) Decrease in its caking power & calorific value (B) Decrease in its carbon & hydrogen content (C) Increase in its oxygen content (D) All (A), (B) and (A)
Last Answer : (D) All (A), (B) and (A)
Description : With increase in moisture content of coal, its (A) Calorific value increases (B) Caking properties diminish (C) Swelling during carbonisation becomes excessive (D) None of these
Last Answer : (B) Caking properties diminish
Description : Pick out the correct statement. (A) Oxygen content decreases from lignite to bituminous coal as the coalification increases (B) The less the oxygen content, better is the coal, as it reduces the calorific value (C ... capacity of coal increases and the caking power decreases (D) All (A), (B) and (C)