Description : Most of the domestic refrigerators work on the following refrigeration system (a) vapour compression (b) vapour absorption (c) carnot cycle (d) electrolux refrigerator
Last Answer : Ans: a
Description : Aqua ammonia is used as refrigerant in the following type of refrigeration system (a) compression (b) direct (c) indirect (d) absorption
Last Answer : Ans: d
Description : An important characteristic of absorption system of refrigeration is (a) noisy operation (b) quiet operation (c) very little power consumption (d) its input only in the form of heating.
Last Answer : Ans: D
Description : The lower horizontal line of the refrigeration cycle plotted on pressure-enthalpy-diagram represents (a) condensation of the refrigerant vapour (b) evaporation of the refrigerant liquid (c) compression of the refrigerant vapour (d) metering of the refrigerant liquid
Last Answer : Ans: b
Description : Vapour compression refrigeration is some what like (a) Carnot cycle (b) Rankine cycle (c) reversedCamot cycle (d) reversed Rankine cycle
Last Answer : Ans: C
Description : In vapour compression refrigeration system, refrigerant occurs as liquid between (a) condenser and expansion valve (b) compressor and evaporator (c) expansion valve and evaporator (d) compressor and condenser
Last Answer : Ans: c
Description : The COP of a vapour compression plant in comparison to vapour absorption plant is (a) more (b) less (c) same (d) more/less depending on size of plant
Description : In vapour compression cycle, the condition of refrigerant is very wet vapour (a) after passing through the condenser (b) before passing through the condenser (c) after passing through the expansion or throttle valve (d) before entering the expansion valve
Description : Reducing suction pressure in refrigeration cycle (a) lowers evaporation temperature (b) increases power required per ton of refrigeration (c) lowers compressor capacity because vapour is lighter (d) all of the above.
Description : The evolution of heat of solution takes place in ammonia absorption plant when (a) ammonia vapour goes into solution (b) ammonia vapour is driven out of solution (c) lithium bromide mixes with ammonia (d) weak solution mixes with strong solution
Description : Pick up the correct statement about giving up of heat from one medium to other in ammonia absorption system (a) strong solution to weak solution (b) weak solution to strong solution (c) strong solution to ammonia vapour (d) ammonia vapour to strong solution.
Description : In vapour compression cycle using NH3 as refrigerant, initial charge is filled at (a) suction of compressor (b) delivery of compressor (c) high pressure side close to receiver (d) low pressure side near receiver
Description : Where does the lowest temperature occur in a vapour compression cycle ? (a) condenser (b) evaporator (c) compressor (d) expansion valve
Description : The value of COP in vapour compression cycle is usually (a) always less than unity (b) always more than unity (c) equal to unity (d) any one of the above
Description : The higher temperature in vapour compression cycle occurs at (a) compressor discharge. (b) expansion valve (c) evaporator (d) condenser discharge
Description : In a vapour compression cycle, the refrigerant immediately after expansion valve is (a) liquid (b) sub-cooled liquid (c) saturated liquid (d) wet vapour
Description : Domestic refrigerator working on vapour compression cycle uses the following type of expansion device (a) electrically operated throttling valve (b) manually operated valve (c) thermostatic valve (d) capillary tube
Description : The vapour compression refrigerator employs the following cycle (a) Rankine (b) Carnot (c) Reversed Carnot. (d) Brayton
Description : In vapour compression cycle the condition off refrigerant is dry saturated vapour (a) after passing through the condenser (b) before passing through the condenser (c)before entering the expansion valve (d) before entering the compressor
Description : In vapour compression cycle the condition of refrigerant is superheated vapour (a) after passing through the condenser (b) before passing through the condenser (c) after passing through the expansion or throttle valve (d) beforeentering the expansion valve
Description : In vapour compression cycle, the condition of refrigerant is high pressure saturated liquid (a) after passing through the condenser (b) before passing through the condenser (c) after passing through the expansion or throttle valve (d) before entering the expansion valve
Description : In vapour compression cycle, the condition of refrigerant is saturated liquid (a) after passing through the condenser (b) before passing through the condenser (c) after passing through the expansion throttle valve (d) before entering the expansion valve
Description : Pick up the incorrect statement (a) lithium bromide used in vapour absorption cycle is nonvolatile (b) lithium bromide plant can't operate below 0°C (c) a separator is used in lithium ... of solution coming out of lithium bromide generator is more in comparison to that entering the generator
Description : For same compression ratio and heat input a. Otto cycle is more efficient b. Diesel cycle is more efficient c. Both are equally efficient d. None of the above
Last Answer : ANSWER a. Otto cycle is more efficient
Description : Which of the following is a widely used refrigerant in vapour compression refrigeration system (using large centrifugal compressor)? (A) Freon (B) Liquid sulphur dioxide (C) Methyl chloride (D) Ammonia
Last Answer : (A) Freon
Description : For proper refrigeration in a cabinet, if the temperature and vapour pressure difference between cabinet and atmosphereis high, then (a) bigger cabinet should be used (b) smaller cabinet should ... tight vapour seal should be used (d) refrigerant with lower evaporation temperature should be used
Description : In a flooded evaporator refrigerator, an accumulator at suction of compressor is used to (a) collect liquid refrigerant and prevent it from going to compressor (b) detect liquid in vapour (c) superheat the vapour (d) increase refrigeration effect
Description : What is the use of flash chamber in a vapour compression refrigeration cycle to improve the COP of refrigeration cycle ?
Last Answer : When liquid refrigerant as obtained from condenser is throttled, there are some vapours. These vapours if carried through the evaporator will not contribute to refrigerating effect. Using a flash ... out in stages. Similarly compression process is also done in two separate compressor stages.
Description : Which of the following has the minimum value of COP for a given refrigeration effect? (A) Reverse Carnot cycle (B) Ordinary vapour-compression cycle (C) Vapour-compression process with a reversible expansion engine (D) Air refrigeration cycle
Last Answer : (D) Air refrigeration cycle
Description : Out of the following refrigeration cycles, which one has the minimum COP (Co-efficient of performance)? (A) Air cycle (B) Carnot cycle (C) Ordinary vapour compression cycle (D) Vapour compression with a reversible expansion engine
Last Answer : A) Air cycle
Description : Describe with a neat diagram the working of a simple vapour compression refrigeration system. Represent the cycle on P–V and T–S diagram.
Last Answer : Vapour compression refrigeration cycle: The vapor-compression uses a circulating liquid refrigerant as the medium which absorbs and removes heat from the space to be cooled and subsequently rejects that heat elsewhere. Figure shows ... the compressor. P-V Diagram T-S diagram:
Description : Domestic refrigerator usually works on the __________ refrigeration cycle. (A) Carnot (B) Air (C) Absorption (D) vapour-ejection
Last Answer : (C) Absorption
Description : Work input to the air compressor with n as index of compression A. Increases with increase in value of n B. Decrease with increase in value of n C. remains same whatever the value of n D. first increase and then decreases with increase of value of n.
Last Answer : ANSWER : A
Description : In a refrigeration cycle, the super heating……..C.O.P (a)decreases (b)does not change (c) increases (d)none of the above
Description : Air refrigeration cycle is used in (a) domestic refrigerators (b) gas liquefaction (c)commercial refrigerators (d) Chillers
Description : The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P. (a) more (b) less (c) equally. (d) unpredictable
Description : The C.O.P. of a refrigeration cycle with lowering of condenser temperature, keeping the evaporator temperatureconstant, will (a) increase (b) decrease (c) may increase or decrease depending on the type of refrigerant used (d) remain unaffected
Description : The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature constant, will (a) increase (b) decrease (c) remain unaffected (d) may increase or decrease depending on the type of refrigerant used
Description : Under-cooling in a refrigeration cycle (a) increases COP (b) decreases COF (c) COP remains unaltered (d) other factors decide COP
Description : Superheating in a refrigeration cycle (a) increases COP (b) decreases COP (c) COP remains unaltered (d) other factors decide COP
Description : In a refrigeration cycle, the flow of refrigerant is controlled by (a) compressor (b) condenser (c) evaporator (d) expansion valve
Description : A refrigeration cycle operates between condenser temperature of + 27°C and evaporator temperature of- 23°C. TheCarnot coefficient of performance of cycle will be (a) 0.2 (b) 1.2 (c) 5 (d) 6
Description : Highest temperature encountered in refrigeration cycle should be (a) near critical temperature of refrigerant (b) above critical temperature (c) atcritica. temperature (d) much below critical temperature
Description : Air refrigeration cycle is used in (a) domestic refrigerators (b) commercial refrigerators (c) air conditioning (d) gas liquefaction
Description : Air refrigeration operates on (a) Carnot cycle (b) Reversed Carnot cycle (c) Rankine cycle (d) Brayton cycle.
Description : The condition of refrigerant before entering the expansion or throttle valve, in a vapour compression system (a) dry vapour (b) wet vapour (c)liquid-vapour mixture (d) high pressure saturated liquid
Description : Cooling water is required for following equipment in ammonia absorption plant (a) condenser (b) evaporator (c) condenser and absorber (d) condenser, absorber and separator (rectifier).
Description : Absorption system normally uses the following refrigerant (a) Freon-11 (b) Freon-22 (c) C02 (d) ammonia.
Last Answer : Ans: e
Description : Allowable pressure on high-pressure side or ammonia absorption system is of the order of (a) atmospheric pressure (b) slightly above atmospheric pressure (c) 2-4 bars (d) 5-6 bars
Description : For minimum work input in a two stage compression process the intermediated pressure is the A. Arithmetic process of suction and discharge pressure B. Logarithmic mean of suction and discharge pressure C. Geometric mean of suction and discharge pressure D. Hyperbolic mean of suction and discharge
Last Answer : ANSWER : C