Moisture in freon refrigeration system causes (a) ineffective refrigeration (b) high power consumption (c) freezing automatic regulating valve (d) corrosion of whole system

1 Answer

Answer :

Ans: c

Related questions

Description : The leaks in a refrigeration system using Freon are detected by (a) halide torch which on detection produces greenish flame lighting (b) sulphur sticks which on detection gives white smoke (c) using reagents (d) sensing reduction in pressure.

Last Answer : Ans: a

Description : Mass flow ratio of NH3 in comparison to Freon-12 for same refrigeration load and same temperature limits is of the orderof (a) 1 : 1 (b) 1 : 9 (c) 9 : 1 (d) 1 : 3

Last Answer : Ans: b

Description : Refrigeration in aeroplanes usually employs the following refrigerant (a) Co2 (b) Freon-11 (c) Freon-22 (d) Air

Last Answer : Ans: d

Description : Which of the following refrigerants has lowest freezing point (a) Freon-12 (b) NH3 (c) CO2 (d) Freon-22

Last Answer : Ans: d

Description : An important characteristic of absorption system of refrigeration is (a) noisy operation (b) quiet operation (c) very little power consumption (d) its input only in the form of heating.

Last Answer : Ans: D

Description : In vapour compression refrigeration system, refrigerant occurs as liquid between (a) condenser and expansion valve (b) compressor and evaporator (c) expansion valve and evaporator (d) compressor and condenser

Last Answer : Ans: c

Description : In a refrigeration cycle, the flow of refrigerant is controlled by (a) compressor (b) condenser (c) evaporator (d) expansion valve

Last Answer : Ans: d

Description : Presence of moisture in a refrigerant affects the working of (a) compressor (b) condenser (c) evaparator (d) expansion valve.

Last Answer : Ans: a

Description : The moisture in a refrigerant is removed by (a) evaporator (b) safety relief valve (c) dehumidifier (d) driers

Last Answer : Ans: d

Description : A certain refrigerating system has a normal operating suction pressure of 10 kg/cm gauge and condensing pressure ofabout 67 kg/cm. The refrigerant used is (a) Ammonia (b) Carbon dioxide (c) Freon (d) Brine

Last Answer : Ans: b

Description : Absorption system normally uses the following refrigerant (a) Freon-11 (b) Freon-22 (c) C02 (d) ammonia.

Last Answer : Ans: e

Description : In a refrigeration system, heat absorbed in comparison to heat rejected is (a) more (b) less (c) less for small capacity and more for high capacity. (d) more for small capacity and less for high capacity

Last Answer : Ans: b

Description : The freon group of refrigerants are (a) halo-carbon refrigerants (b) azeotrope refrigerants (c) inorganic refrigerants (d) hydro-carbon refrigerants

Last Answer : Ans: a

Description : Freon group of refrigerants are (a) inflammable (d) toxic (c) non-toxic and non-inflammable (d) non-toxic and inflammable

Last Answer : Ans: c

Description : Reducing suction pressure in refrigeration cycle (a) lowers evaporation temperature (b) increases power required per ton of refrigeration (c) lowers compressor capacity because vapour is lighter (d) all of the above.

Last Answer : Ans: d

Description : For proper refrigeration in a cabinet, if the temperature and vapour pressure difference between cabinet and atmosphereis high, then (a) bigger cabinet should be used (b) smaller cabinet should ... tight vapour seal should be used (d) refrigerant with lower evaporation temperature should be used

Last Answer : Ans: c

Description : The general rule for rating refrigeration systems (excepting for CO2 system) is to approximate following h.p. per ton of Refrigeration (a) 0.1 to 0.5 h.p. per ton of refrigeration (b) 0.5 to 0.8 h.p. per ... (c) 1 to 2 h.p. per ton of refrigeration (d) 2 to 5 h.p. per ton of refrigeration

Last Answer : Ans: c

Description : Most of the domestic refrigerators work on the following refrigeration system (a) vapour compression (b) vapour absorption (c) carnot cycle (d) electrolux refrigerator

Last Answer : Ans: a

Description : Aqua ammonia is used as refrigerant in the following type of refrigeration system (a) compression (b) direct (c) indirect (d) absorption

Last Answer : Ans: d

Description : Highest pressure encountered in a refrigeration system should be (a) critical pressure of refrigerant (b) much below critical pressure (c) much above critical pressure (d) near critical pressure

Last Answer : Ans: b

Description : In a refrigeration cycle, the super heating……..C.O.P (a)decreases (b)does not change (c) increases (d)none of the above

Last Answer : Ans: a

Description : Air refrigeration cycle is used in (a) domestic refrigerators (b) gas liquefaction (c)commercial refrigerators (d) Chillers

Last Answer : Ans: b

Description : The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P. (a) more (b) less (c) equally. (d) unpredictable

Last Answer : Ans: a

Description : The C.O.P. of a refrigeration cycle with lowering of condenser temperature, keeping the evaporator temperatureconstant, will (a) increase (b) decrease (c) may increase or decrease depending on the type of refrigerant used (d) remain unaffected

Last Answer : Ans: a

Description : The refrigeration effect in a dry evaporator compared to flooded evaporator in a similar plant is (a) same (b) more (c) less (d) more or less depending on ambient conditions

Last Answer : Ans: c

Description : The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature constant, will (a) increase (b) decrease (c) remain unaffected (d) may increase or decrease depending on the type of refrigerant used

Last Answer : Ans: a

Description : Under-cooling in a refrigeration cycle (a) increases COP (b) decreases COF (c) COP remains unaltered (d) other factors decide COP

Last Answer : Ans: a

Description : Superheating in a refrigeration cycle (a) increases COP (b) decreases COP (c) COP remains unaltered (d) other factors decide COP

Last Answer : Ans: b

Description : One ton of the refrigeration is (a) the standard unit used in refrigeration problems (b) the cooling effect produced by melting 1 ton of ice (c) the refrigeration effect to freeze 1 ton of water at ... ice at 0°C in 24 hours (d) the refrigeration effect to produce 1 ton of ice at NTP conditions

Last Answer : Ans: c

Description : The lower horizontal line of the refrigeration cycle plotted on pressure-enthalpy-diagram represents (a) condensation of the refrigerant vapour (b) evaporation of the refrigerant liquid (c) compression of the refrigerant vapour (d) metering of the refrigerant liquid

Last Answer : Ans: b

Description : A refrigeration cycle operates between condenser temperature of + 27°C and evaporator temperature of- 23°C. TheCarnot coefficient of performance of cycle will be (a) 0.2 (b) 1.2 (c) 5 (d) 6

Last Answer : Ans: c

Description : In a flooded evaporator refrigerator, an accumulator at suction of compressor is used to (a) collect liquid refrigerant and prevent it from going to compressor (b) detect liquid in vapour (c) superheat the vapour (d) increase refrigeration effect

Last Answer : Ans: a

Description : Highest temperature encountered in refrigeration cycle should be (a) near critical temperature of refrigerant (b) above critical temperature (c) atcritica. temperature (d) much below critical temperature

Last Answer : Ans: d

Description : Air refrigeration cycle is used in (a) domestic refrigerators (b) commercial refrigerators (c) air conditioning (d) gas liquefaction

Last Answer : Ans: d

Description : Air refrigeration operates on (a) Carnot cycle (b) Reversed Carnot cycle (c) Rankine cycle (d) Brayton cycle.

Last Answer : Ans: d

Description : In S.J. unit, one ton of refrigeration is equal to (a) 210 kJ/min (b) 21 kJ/min (c) 3.5 kJ/min (d) 2.4 kJ/min

Last Answer : Ans: a

Description : One ton of refrigeration is equal to the refrigeration effect corresponding to melting of 1000 kg of ice (a) in 1 hour (b) in 1 minute (c) in 24 hours (d) in 12 hours

Last Answer : Ans: c

Description : Ammonia-absorption refrigeration cycle requires (a) very little work input (b) maximum work input (c) nearly same work input as for vapour compression cycle (d) zero work input

Last Answer : Ans: a

Description : Vapour compression refrigeration is some what like (a) Carnot cycle (b) Rankine cycle (c) reversedCamot cycle (d) reversed Rankine cycle

Last Answer : Ans: C

Description : The condition of refrigerant before entering the expansion or throttle valve, in a vapour compression system (a) dry vapour (b) wet vapour (c)liquid-vapour mixture (d) high pressure saturated liquid

Last Answer : Ans: d

Description : The formation of frost on cooling coils in a refrigerator (a) increases heat transfer (b) improves C.O.P. of the system (c) increases power consumption (d) reduces power consumption

Last Answer : Ans: c

Description : Which of the following is a widely used refrigerant in vapour compression refrigeration system (using large centrifugal compressor)? (A) Freon (B) Liquid sulphur dioxide (C) Methyl chloride (D) Ammonia

Last Answer : (A) Freon

Description : In vapour compression cycle, the condition of refrigerant is high pressure saturated liquid (a) after passing through the condenser (b) before passing through the condenser (c) after passing through the expansion or throttle valve (d) before entering the expansion valve

Last Answer : Ans: d

Description : Differentiate induced draft and forced draft cooling towers based on (i) Location of fan (ii) Corrosion of blades (iii) Efficiency (iv) Fan size

Last Answer : Differentiate induced draft and forced draft cooling towers based on (i) Location of fan (ii) Corrosion of blades (iii) Efficiency (iv) Fan size

Description : Motoring test is conducted on IC engines to determine A. brake power B. indicated power C. friction power D. fuel consumption at full load

Last Answer : ANSWER : C

Description : In four stroke engine which of the following is also known as power stroke a. Suction stroke b. Compression stroke c. Expansion stroke d. Exhaust stroke (Ans:c) Measurements of fuel and air ... into IC engine,___________its efficiency A. increase B. decrease C. does not alter D. unpredictable on

Last Answer : ANSWER : B

Description : An engine produces 10 kW brake power while working with a brake thermal efficiency of 30%. If the calorific value of the fuel used is 40000 kJ/kg, then what is the fuel consumption? (a) 1.5 kg/hour (b) 3 kg/hour (c) 0.3 kg/hour (d) 1 kg/hour

Last Answer : Ans :b

Description : If the performance of diesel engine of different sizes, cylinder dimensions and power rating are to be compared, which of the following parameters can be used for such comparison? (a) Swept volume (b) Air fuel ratio (c) Specific brake fuel consumption (d) Volumetric efficiency

Last Answer : Ans :c

Description : For same power output and same r, as compared to 2- stroke engines, four stroke SI engines have (a) Higher fuel consumption (b) Lower thermal efficiency (c) Highest exhaust temperatures (d) Higher thermal efficiency

Last Answer : Ans :d

Description : Scavenging is usually done to increase the a. thermal efficiency b. speed c. power output d. fuel consumption

Last Answer : ANSWER c. power output