____are the conductors, which connect the consumer's terminals to the distribution.

by

1 Answer

Answer :

Service mains are the conductors, which connect the consumer's terminals to the distribution.

by

Related questions

The skin effect in conductors is due to non uniform distribution of current in it and major portion of current is

Description : The skin effect in conductors is due to non uniform distribution of current in it and major portion of current is near the _______ of conductor.  (1) Surface (2) Center (3) Complete cross section area (4) Axis

Last Answer : The skin effect in conductors is due to non uniform distribution of current in it and major portion of current is near the Surface of conductor. 

How to Clean Car Battery Terminals

Description : How to Clean Car Battery Terminals

Last Answer : How to Clean Car Battery Terminals How to Paint a Car One of the most common causes of false starts and poor performance in many automobiles is when car battery terminals get dirty or corroded. ... these simple steps, you never have to pay big money to replace your battery and terminals again.

The number of terminals present in IGBT is

Description : The number of terminals present in IGBT is A) 2 B) 3 C) 4 D) 5

Last Answer : The number of terminals present in IGBT is 3

If an unsymmetrical line to ground fault occurs at the secondary terminals of a delta/star, ungrounded

Description : If an unsymmetrical line to ground fault occurs at the secondary terminals of a delta/star, ungrounded transformer, then  (A) zero sequence currents are present on both sides of the transformer  (B) ... side  (D) zero sequence currents are present on the primary side but not on the secondary side

Last Answer : If an unsymmetrical line to ground fault occurs at the secondary terminals of a delta/star, ungrounded transformer, then zero sequence currents are absent on both sides of the transformer 

A network is said to be under resonance when the voltage and the current at the network input terminals are

Description : A network is said to be under resonance when the voltage and the current at the network input terminals are (A) in phase (B) out of phase (C) in phase quadrature (D) in phase, and have equal magnitudes

Last Answer : A network is said to be under resonance when the voltage and the current at the network input terminals are in phase

A MOSFET has how many terminals?

Description : A MOSFET has how many terminals?

Last Answer : A MOSFET having three terminals 1st one is Gate (insulated), 2nd one is Source and 3rd one is Drain.

BJT have how many terminals?

Last Answer : BJT have three terminals Base, emitter and collector.

thyristor have how many terminals?

Last Answer : Thyristor have three terminals anode, cathode and Gate.

Diode have how many terminals?

Last Answer : Diode have two terminals.

advantage and disadvantages of stranded conductors.

Description : advantage and disadvantages of stranded conductors. 

Last Answer : Advantage and disadvantages of stranded conductors  Advantages of Stranded Conductors:-  1. Conductor becomes flexible.  2. Its weight reduces.  3. Easy for handling.  4. Easy to ... Stranded Conductors:-  1. Due to stranding of conductor its resistance increases slightly about 2%. 

Which have more free electrons: conductors or insulators?

Description : Which have more free electrons: conductors or insulators? 

Last Answer : Conductors have many free electrons whereas insulators have very few or none at all.

Name two good conductors, two good insulators, and two semiconductors.

Description : Name two good conductors, two good insulators, and two semiconductors.

Last Answer : In general all metals are good conductors, with silver the best and copper second.

The function of steel wire in ACSR conductors is

Description : The function of steel wire in ACSR conductors is (A) To take care of surges. (B) To reduce corona. (C) To reduce inductance. (D) To provide additional mechanical strength

Last Answer : The function of steel wire in ACSR conductors is To provide additional mechanical strength

The induced e.m.f. in the armature conductors of a d.c. motor is?

Description : The induced e.m.f. in the armature conductors of a d.c. motor is?

Last Answer : The induced e.m.f. in the armature conductors of a d.c. motor is sinusoidal.

All good conductors have high?

Description : All good conductors have high?

Last Answer : All good conductors have high conductance.

Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other...

Description : Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be?

Last Answer : Two copper conductors have equal length. The cross-sectional area of one conductor is four times that of the other. If the conductor having smaller cross-sectional area has a resistance of 40 ohms the resistance of other conductor will be 10 ohms.

In any rotating machine that part which houses the conductors and in which e.m.f. induced is to be utilised is called?

Last Answer : In any rotating machine that part which houses the conductors and in which e.m.f. induced is to be utilised is called armature.

The commutator segments are connected to the armature conductors by means of?

Last Answer : The commutator segments are connected to the armature conductors by means of copper lugs.

are the conductors, which connect the consumer's terminals to the distribution (a) Distributors (b) Service mains (c) Feeders (d) None of the above

Description : are the conductors, which connect the consumer's terminals to the distribution (a) Distributors (b) Service mains (c) Feeders (d) None of the above

Last Answer : (b) Service mains

are the conductors, which connect the consumer's terminals to the distribution (a) Distributors (b) Service mains (c) Feeders (d) None of the above

Description : are the conductors, which connect the consumer's terminals to the distribution (a) Distributors (b) Service mains (c) Feeders (d) None of the above

Last Answer : (b) Service mains

TRANSMISSION AND DISTRIBUTION MCQ

Description : TRANSMISSION AND DISTRIBUTION MCQ

Last Answer : 51. It is difficult to maintain oil filled cables. (a) Yes (b) No Ans: a 51. In capacitance grading a homogeneous dielectric is used. (a) Yes (b) No Ans: b 52. In congested areas where excavation is ... The metallic sheath may be made of lead or lead alloy or of aluminium. (a) Yes (b) No Ans: b

Distribution Boards –

Description : Distribution Boards –

Last Answer : Ans. a. Sub & Main Distribution Boards b. Schedule Maintenance.

Grid distribution system

Description : Grid distribution system

Last Answer : Grid distribution system:-  In this system, when the feeder or loop or ring is charged (energized) by two or more than two substations from two or more than two different generating stations then it is known as “Grid distribution system. In this system only one feeder is utilized at a time. 

Define: primary and secondary distribution system

Description : Define: primary and secondary distribution system 

Last Answer : i) Primary Distribution:  It is a 3-phase, 3-wire transmission line connected in between receiving substation to Distribution substation. OR It is link between receiving substation & ... substation to consumer line. OR It is link between distribution transformer substation & consumer. 

State the condition for selecting site for distribution substation.

Description : State the condition for selecting site for distribution substation. 

Last Answer : Following condition should be considered while selecting site for distribution sub-station:-  1. Near load center :  Sub-station should be located near load center to reduce cost of Transmission and ... free from earthquake :  To avoid damage to sub-station area should be free earth quake. 

State the classification of distribution substation.

Description : State the classification of distribution substation. 

Last Answer : The classification of distribution substation. 1. Pole mounted distribution substation 2. Plinth mounted distribution substation 3. Compact/prefabricated distribution substation 4. ... Indoor distribution substation 6. Outdoor distribution substation 7. Mobile distribution substation 

State the losses in secondary distribution system.

Description : State the losses in secondary distribution system. 

Last Answer : The losses in secondary distribution system: a) Technical losses: 1. Due to poor voltage 2. Due to unbalance load 3. Due poor quality of transformer & its components 4. Due to poor quality ... of induction type of energy meter. 3. Lack of administration. 4. Energy theft 5. Unmetered supply

Advantages of Grid distribution scheme

Description : Advantages of Grid distribution scheme

Last Answer : Advantages of Grid distribution scheme 1. Supply to distribution transformer center is given through two different generating stations or major generating stations 2. It has highest reliability to ... highest reliability to maintain supply even when there was maintenance on any one feeder. 

different types of distribution scheme.

Description :  different types of distribution scheme.  

Last Answer : According to scheme of connection: -  a) Radial (Tree) distribution system  b) Ring mains (Loop) distribution system  c) Grid (interconnected) distribution system OR Types of ... distribution system  b) Ring mains (Loop) distribution system  c) Grid (interconnected) distribution system

comparison between Feeder and Distribution

Description : comparison between Feeder and Distribution

Last Answer : Sr.No Feeder Distributor 1 It is link between receiving substation & distribution transformer   It is link between distribution transformer substation & consumer  2 ... loading point is at substation only   Distributors loading point is throughout its length. 

requirements of a distribution system

Description : requirements of a distribution system

Last Answer : Following requirements of a distribution system.  1. Layout should be simple in design. 2. It should have less initial cost 3. The distribution system should have minimum distribution ... stability of existing distribution system. 15. Time required for completion of work should be less. 

Why radial distribution system used for short distance ?

Description : Why radial distribution system used for short distance ? 

Last Answer : Because of following disadvantages radial distribution system is not used for long distance:  Since there is only one feeder to DTC feed at one point so, 1) There is no reliability ... more time for fault finding & repairing Hence radial distribution system is used for short distance.

Explain following techniques related to energy conservation in transmission and distribution system. (i) By balancing phase currents (ii) Variable technical losses (I2R losses).

Description : Explain following techniques related to energy conservation in transmission and distribution system. (i) By balancing phase currents (ii) Variable technical losses (I2R losses).

Last Answer : (i) Balancing Phase currents: Proper (healthy balanced) three phase loads always draw equal currents in all lines but single phase loads in the 3 phase 4 wire system or loads connected between two ... . 11) Minimize I2R losses. 12) Balance the load currents. 13) Regulate the system voltages.

Write selection criteria of distribution transformer with any four points.

Description : Write selection criteria of distribution transformer with any four points.

Last Answer : Selection Criteria for Distribution Transformer:  i) Ratings - The kVA ratings should comply with IS:2026 ( Part l )-1977*. The noload secondary voltage should be 433 volts for transformers to be ... is not necessary. vi) Cooling - The transformers covered in this group are generally ONAN, AN

Explain with schematic diagram direct distribution of solar energy.

Description : Explain with schematic diagram direct distribution of solar energy.

Last Answer : Explain with schematic diagram direct distribution of solar energy: Solar energy reaching earth's surface consists of two components: i) Direct solar energy, ii) Diffused solar energy. Direct solar energy ... radiation. It is very intense radiation and it can produce sun burns and shadows.

The permissible voltage variation in transmission and distribution system is:

Description : The permissible voltage variation in transmission and distribution system is:  (A) ± 0.1% (B) ± 1% (C) ±10% (D) ± 25%

Last Answer : The permissible voltage variation in transmission and distribution system is: ±10%

The main criterion for selection of the size of a radial distribution system is

Description : The main criterion for selection of the size of a radial distribution system is

Last Answer : The main criterion for selection of the size of a radial distribution system is voltage drop

Precise control of reactive current flow entering the transmission and distribution systems can be minimized

Description : Precise control of reactive current flow entering the transmission and distribution systems can be minimized by using (A) synchronous condenser (B) static VAR capacitor (C) capacitor bank (D) thyristor switched reactor in parallel with capacitor

Last Answer : Precise control of reactive current flow entering the transmission and distribution systems can be minimized by using (A) synchronous condenser (B) static VAR capacitor (C) capacitor bank (D) thyristor switched reactor in parallel with capacitor

In a distribution system, in order to improve power factor, the synchronous capacitors are installed?

Last Answer : In a distribution system, in order to improve power factor, the synchronous capacitors are installed at the receiving end.

In a power or distribution transformer about 10 percent end turns are heavily insulated?

Last Answer : In a power or distribution transformer about 10 percent end turns are heavily insulated to withstand the high voltage drop due to line surge produced by the shunting capacitance of the end turns.

Should we try to increase inflation to end the Great Recession?

Description : Should we try to increase inflation to end the Great Recession?

Last Answer : You know, I find it almost impossible to get involved in a theoretical debate when this Congress can’t or won’t do anything constructive.

Have you been screwed over as a consumer?

Description : Have you been screwed over as a consumer?

Last Answer : If its that important to you I would not take any crap from a company that was getting my money. You don’t have to be a jerk about it, but if you talk to the right person Im sure you can work it out. And, No Im not British…

How does one go about becoming a product tester/reviewer?

Description : How does one go about becoming a product tester/reviewer?

Last Answer : There are a couple companies I know that (after signing up) will send you products to test. Family Handyman is one. They have sent us everything from tools, gardening supplies, books. There is another one, it is strictly gardening supplies. I forget the name. If I remember it, I’ll let you know.

Why does buying a car from a dealership have to be such a huge ordeal?

Description : Why does buying a car from a dealership have to be such a huge ordeal?

Last Answer : I just bought a Scion Tc about three weeks ago. I traded in my truck on it. It was compleatly painless. I was there maybe an hour doing paperwork and whatnot. If I’d have know it was that simple, I’d have done it sooner! By the way, this was a big toyota dealership that I was dealing with.

The load of a consumer is generally measured in terms of :

Description : The load of a consumer is generally measured in terms of : (A) Volts (B) Amperes (C) Ampere hour (D) kW

Last Answer : The load of a consumer is generally measured in terms of : kW

The consumer of electricity could be :

Description : The consumer of electricity could be : (A) Domestic (B) Agricultural (C) Industrial and Commercial (D) All of the above 

Last Answer : The consumer of electricity could be : (A) Domestic (B) Agricultural (C) Industrial and Commercial (D) All of the above 

For a consumer the most economical power factor is generally?

Last Answer : For a consumer the most economical power factor is generally 0.95 lagging .

For any type of consumer the ideal tariff is?

Last Answer : For any type of consumer the ideal tariff is three part tariff.

A consumer has to pay lesser fixed charges in?

Last Answer : A consumer has to pay lesser fixed charges in maximum demand tariff.

How does one train to become a music conductor and how much do they earn?

Description : How does one train to become a music conductor and how much do they earn?

Last Answer : answer:Firstly, one must understand that conductors of orchestras are kind of like the rock stars of the classical music world. It's not impossible to become one, but it is a long hard road that ... , BTW, is essentially why I decided to drop the music major and opt for software engineering instead)