A nose wheel control system  
a. Prevents the nosewheel from castering at all times  
b. Allows the nosewheel to caster within preset limits about the neutral position  c. Allows the nosewheel to caster freely at all times  
d. Prevents the nose gear from lowering if the nosewheels are not centralised

1 Answer

Answer :

b. Allows the nosewheel to caster within preset limits about the neutral position

Related questions

Description : A nose wheel control system a. Prevents the nosewheel from castering at all times b. Allows the nosewheel to caster within preset limits about the neutral position c. Allows the nosewheel to caster freely at all times d. Prevents the nose gear from lowering if the nosewheels are not centralised

Last Answer : b. Allows the nosewheel to caster within preset limits about the neutral position

Description : At an aircraft taxiing speed of 10mph, the anti-skid braking system is: a. Inoperative b. Operative c. Operative only on the nosewheel brakes d. Operative only on the main wheel brakes

Last Answer : a. Inoperative

Description : A hand pump is usually fitted: a. For ground servicing purposes b. Lowering the landing gear in an emergency c. Pressurising the oleo struts in the air d. Retracting the gear after take-off

Last Answer : a. For ground servicing purposes

Description : The method of alighting the aeroplane on water during a ditching is to: a. Carry out a normal approach with flaps and gear selected as normal but to calculate all speeds plus 10kts b. Reduce ... d. Fly a normal approach to stalling speed and then drop the aeroplane vertically onto the water

Last Answer : c. Fly a normal approach but keep the gear up and land at lowest possible speed with the nose raised for the tail to strike first

Description : To cover the greatest distance when gliding, the gliding speed must be: a. Near to the stalling speed b. As high as possible within VNE limits c. About 30% faster than Vmd d. The one that gives the highest L/D ratio

Last Answer : d. The one that gives the highest L/D ratio

Description : To ensure some degree of longitudinal stability in flight, the position of the CG: a. Must always coincide with the AC b. Must be forward of the Neutral Point c. Must be aft of the Neutral Point d. Must not be forward of the aft CG limi

Last Answer : b. Must be forward of the Neutral Point

Description : At an aircraft taxiing speed of 10mph, the anti-skid braking system is: a. Inoperative b. Operative c. Operative only on the nosewheel brakes d. Operative only on the main wheel brakes

Last Answer : a. Inoperative

Description : Which statement best describes the operating principle of a constant-speed propeller? a. As throttle setting is changed by the pilot, the prop governor causes pitch angle of the propeller blades to ... the pilot, the RPM of the engines remains constant as the pitch angle of the propeller changes

Last Answer : b. The propeller control regulates the engine RPM and in turn the propeller RPM

Description : What is the rule concerning level or height the aircraft should maintain when flying IFR outside controlled airspace unless otherwise directed? a. 2,000 feet above the highest obstacle within 8kms of ... planned track d. 2,000 feet above the highest obstacle within 8kms of the planned track

Last Answer : b. 1,000 feet above the highest obstacle within 8kms of the estimated position of the aircraft

Description : Lowering the flaps during a landing approach: a. Increases the angle of descent without increasing the airspeed b. Decreases the angle of descent without increasing power c. Eliminates floating d. Permits approaches at a higher indicated airspeed

Last Answer : a. Increases the angle of descent without increasing the airspeed

Description : When does the first segment of the take-off climb begin? a. When V2 is reached b. When 35 feet is reached c. When flaps are up d. When gear and flaps are up

Last Answer : b. When 35 feet is reached

Description : What do three green lights represent when the landing gear is selected down? a. The gear is down b. The gear is down and locked c. The gear and doors are down and locked d. The gear is travelling between up and down

Last Answer : b. The gear is down and locked

Description : An aeroplane of 110,000kg has its CG at 22.6m aft of the datum. The CG limits are 18m to 22m aft of the datum. How much mass must be removed from a hold 30m aft of the datum to bring the CG to its mid point? a. 26,800 kg b. 28,600 kg c. 86,200 kg d. 62,800 kg

Last Answer : b. 28,600 kg

Description : What are the VMC limits for Class B airspace? a. 8km flight visibility, clear of cloud and in sight of the surface b. 8km flight visibility, 1000ft vertically and 1500m horizontally from ... . 5km flight visibility, 1000ft vertically and 1500m horizontally from cloud d. The same as Class D

Last Answer : d. The same as Class D

Description : When would the negative differential limits be reached/exceeded? a. Rapid descent when AC descends below cabin altitude b. During ground pressure testing c. Rapid ascent when aircraft climbs d. When changing to manual operation

Last Answer : a. Rapid descent when AC descends below cabin altitude

Description : Shortly after take-off, the altitude of the aeroplane suffers an abrupt pitch-up and IAS rapidly decreases followed quickly by a decrease in altitude. Engine indications are normal. You should suspect what ... to gain airspeed d. Local clear air turbulence; reduce speed to VRA and ride it out

Last Answer : b. Loss of head wind or an increase in tail wind; apply full power

Description : Aircraft A flies in VMC with an ATC clearance within a control area. Aircraft B without ATC clearance approaches at roughly the same height on a converging heading. Who has the right of way? a. Aircraft A, regardless ... , if B is to the right of him d. Aircraft B, if A is to the left of him

Last Answer : d. Aircraft B, if A is to the left of him

Description : To recover from a spin, the elevators should be: a. Moved up to increase the angle of attack b. Moved down to reduce the angle of attack c. Set to neutral d. Allowed to float

Last Answer : b. Moved down to reduce the angle of attack

Description : In recovery from a spin: a. Ailerons should be kept neutral b. Airspeed increases c. Ailerons used to stop the spin d. Rudder and ailerons used against the direction of spin direction

Last Answer : a. Ailerons should be kept neutral

Description : A hardened firewall host on an intranet (i) has a proxy application gateway program running on it (ii)Allows specified internet users to access specified services in the intranet (iii) Initiates all internet activities requested by clients ... ii b. i, ii, iii c. i, ii, iii, iv d. ii, iii, iv

Last Answer : c. i, ii, iii, iv 

Description : From the flight deck you observe an aeroplane in the forward left position on an opposite parallel track. What Nav light will be used? a. Green b. Red c. White d. All of the above

Last Answer : b. Red

Description : The correct format for the input of position 50N 00527E to the CDU is: a. 5000.0N00527.0E b. N50E00527 c. N5000.0E00527.0 d. N5000E00527

Last Answer : c. N5000.0E00527.0

Description : The FMC position will be at its most inaccurate: a. On take-off b. At TOC c. At TOD d. On final approach

Last Answer : c. At TOD

Description : The IRS position can be updated: a. On the ground only b. At designated positions en-route and on the ground c. On the ground and overhead VOR/DME d. At selected waypoints and on the ground

Last Answer : a. On the ground only

Description : How is fuel consumption affect by the C of G position, in terms of ANM/kg? a. Increases with a forward C of G b. Decreases with an aft C of G c. Decreases with a forward C of G d. Fuel consumption is not affected by the C of G position

Last Answer : c. Decreases with a forward C of G

Description : The definition of the phrase “STANDBY” is: a. Consider the transmission as not sent b. Proceed with your message c. Wait and I will call you d. Hold your present position

Last Answer : c. Wait and I will call you

Description : An urgency message should include the following information: a. Name of station addressed, aircraft callsign, nature of urgency condition, intention of commander, position, level, heading b. Callsign ... , callsign, present positin, level, ETA destination d. Captain's number, rank and name

Last Answer : a. Name of station addressed, aircraft callsign, nature of urgency condition, intention of commander, position, level, heading

Description : What cannot be left out from a position report? a. Callsign, Flight Level and Time b. Callsign, Position and Time c. Position, Time, Flight Level, Next position and ETA d. Your signature

Last Answer : b. Callsign, Position and Time

Description : The loading limitations shall include: a. All limiting mass and centre of gravity b. All limiting mass, centre of gravity position, mass distribution and floor landing c. All limiting mass ... of gravity position and floor loading d. All limiting mass, mass distributions and centre of gravity

Last Answer : b. All limiting mass, centre of gravity position, mass distribution and floor landing

Description : A pressure head is subject to the following errors: a. Position, manoeuvre induced, temperature b. Position, manoeuvre induced c. Position, manoeuvre induced, density d. Position, manoeuvre induced, instrument

Last Answer : d. Position, manoeuvre induced, instrument

Description : CAS is IAS corrected for: a. Position and instrument error b. Instrument, pressure, and density error c. Relative density only d. Compressibility

Last Answer : a. Position and instrument error

Description : After an act of unlawful interference a report is to be made. When and to whom? a. Within 10 days and to the Authority of the State of Registry b. Immediately and to the Authority of ... d. Without delay, to the designated local authority and the Authority of the State of the Operator

Last Answer : d. Without delay, to the designated local authority and the Authority of the State of the Operator

Description : What is the currency requirement for a pilot? a. 3 take-offs and landings on an aeroplane of the same type within the last 90 days b. 3 take-offs and landings on an aeroplane of the same ... 3 take-offs and landings on an aeroplane of the same type or approved simulator within the last 60 days

Last Answer : c. 3 take-offs and landings on an aeroplane of the same type or approved simulator within the last 90 days

Description : The range indicated by DME is considered to be accurate within: a. 3% of range b. 1.25% of range c. 0.5nm d. ±0.25nm ±1.25% of range

Last Answer : d. ±0.25nm ±1.25% of range

Description : Where do you find the majority of the air within the atmosphere? a. Troposphere b. Stratosphere c. Tropopause d. Mesosphere

Last Answer : a. Troposphere

Description : You make a diversion from the route given in the flight plan and land at an uncontrolled airfield. Within what time after landing should you inform ATC? a. 10 mins b. 20 mins c. 30 mins d. 45 mins

Last Answer : c. 30 mins

Description : Following a communications failure, the time at which the aircraft should aim to leave the hold is: a. Within 10 minutes of the EAT or ETA b. Within 30 minutes of the EAT or ETA c. EAT or ETA d. Before it runs out of fuel

Last Answer : c. EAT or ETA

Description : The MSA provides 300m obstacle clearance within how many miles radius of the navigation facility at the aerodrome? a. 20nm b. 30nm c. 25nm d. 15nm

Last Answer : c. 25nm

Description : During a straight departure, the initial track is to be: a. Within 5° of runway centre-line b. Within 10 of runway centre-line c. Within 15° of runway centre-line d. Within 25° of runway centre-line

Last Answer : c. Within 15° of runway centre-line

Description : The Vertical Separation Minimum (VSM) for flights in accordance with IFR within controlled airspace below FL290 is: a. 500 feet (150m) b. 2500 feet (750 m) c. 1000 feet (300m) d. 2000 feet (600m)

Last Answer : c. 1000 feet (300m)

Description : When the aircraft carries serviceable Mode C transponder, the pilot shall continuously operate this mode: a. Only when directed by ATC b. Unless otherwise directed by ATC c. Only when the aircraft is flying within controlled airspace d. Regardless of ATC instructions

Last Answer : b. Unless otherwise directed by ATC

Description : Pilots are not allowed to use the indent function on their SSR, unless: a. They operate outside controlled airspace b. If asked by ATC c. Within controlled airspace d. They operate a transponder with mode C

Last Answer : b. If asked by ATC

Description : A DISTRESS message differs from an URGENCY message because: a. There is grave and imminent danger which requires immediate assistance b. The aeroplane has suffered damage that endangers the ... suitable aerodrome d. The situation concerns the safety of passengers on board or within sight

Last Answer : a. There is grave and imminent danger which requires immediate assistance

Description : If the track on an instrument departure is published, the pilot is expected to: a. Correct for the correct wind so as to stay within controlled airspace b. Ask ATC for another heading to steer ... proceed with a heading equal to the track d. Ask ATC for permission to correct heading for wind

Last Answer : a. Correct for the correct wind so as to stay within controlled airspace

Description : A radioactive element is preset in VIII group of the periodic table. If it emits one `alpha`particle, the new position of the nuclide will be

Last Answer : A radioactive element is preset in VIII group of the periodic table. If it emits one `alpha`particle, the new ... . VI B B. VIII C. VIIB D. I B

Description : In_ instructions are followed one after the other in the preset order in which they appear within program: a. Sequence b Selection c. Break d. Iteration

Last Answer : a. Sequence

Description : A hand pump is usually fitted: a. For ground servicing purposes b. Lowering the landing gear in an emergency c. Pressurising the oleo struts in the air d. Retracting the gear after take-off

Last Answer : a. For ground servicing purposes

Description : Which of the following precautions should be taken when a blown fuse, rated at 10 amperes, is replaced? A. Short out the fuse before removing it from the circuit. B. Use needle-nose pliers to ... D. Fuses of 10 ampere rating and less are virtually harmless when energized and may be handled freely.

Last Answer : Answer: C

Description : The control surface which gives longitudinal control is: a. The rudder b. The ailerons c. The elevators d. The flaps

Last Answer : c. The elevators

Description : By changing the angle of attack of a wing, the pilot can control the aeroplane’s: a. Lift and airspeed, but not drag b. Lift, gross weight and drag c. Lift, airspeed and drag d. Lift and drag, but not airspeed

Last Answer : c. Lift, airspeed and drag