The FMC position will be at its most inaccurate:  
a. On take-off  
b. At TOC  
c. At TOD  
d. On final approach

1 Answer

Answer :

c. At TOD

Related questions

Description : The FMC navigational database can be accessed by the pilots: a. To update the database b. To read information only c. To change information between the 28 day updates d. To change the information to meet the sector requirements

Last Answer : b. To read information only

Description : An aeroplane is starting a non-precision approach with an MDH of 250ft and minimum visibility of 800 meters. ATC gives threshold, mid-runway and final third RVRs. When may the approach be started? ... than 800m. RVR is for precision approaches only. d. When threshold RVR is greater than 800m

Last Answer : d. When threshold RVR is greater than 800m

Description : A pilot suffering from hyperventilation during final approach in poor weather can combat the effects by: a. Go on 100% oxygen and go around b. Land regardless of the weather c. Regulate depth and rate of breathing d. Declare a mayday

Last Answer : c. Regulate depth and rate of breathing

Description : DOM 33,510kt; Traffic load 7,600kg; Trip fuel 2040kg; Final reserve 983kg Alternative fuel 1100kg; Contingency 5% of trip fuel Which of the following is correct? a. Estimated landing mass at destination ... 43,295kg c. Estimated take-off mass 43,295kg d. Estimated take-off mass 45,233kg

Last Answer : b. Estimated landing mass at destination 43,295kg

Description : If a landing is to be made without flaps, the landing speed must be: a. reduced b. increased c. the same as for landing with flaps d. the same as for landing with flaps but with a steeper approach

Last Answer : b. increased

Description : Lowering the flaps during a landing approach: a. Increases the angle of descent without increasing the airspeed b. Decreases the angle of descent without increasing power c. Eliminates floating d. Permits approaches at a higher indicated airspeed

Last Answer : a. Increases the angle of descent without increasing the airspeed

Description : A precautionary landing is a procedure that: a. Enables the aeroplane to land at the destination with unserviceabilities that prevent a normal instrument approach being carried out b. Enables a ... not properly lowered d. Is carried out in the event of landing at an alternate aerodrome

Last Answer : b. Enables a landing after the declaration of a state of emergency or urgency

Description : The method of alighting the aeroplane on water during a ditching is to: a. Carry out a normal approach with flaps and gear selected as normal but to calculate all speeds plus 10kts b. Reduce ... d. Fly a normal approach to stalling speed and then drop the aeroplane vertically onto the water

Last Answer : c. Fly a normal approach but keep the gear up and land at lowest possible speed with the nose raised for the tail to strike first

Description : On an ILS approach, you are told that the weather has dropped below company minima. When must you abort the approach? a. Start of the glide-slope descent b. FAF c. Inner marker d. Outer marker

Last Answer : d. Outer marker

Description : The minimum visibility for a Cat C aeroplane on a circling approach: a. 2400m b. 2500m c. 2600m d. 2700

Last Answer : a. 2400m

Description : What is the system minimum for an NDB approach? a. 200ft b. 250ft c. 300ft d. 350ft

Last Answer : c. 300ft

Description : What is the minimum RVR for a CAT IIIC approach? a. No minimum b. 50m c. 75m d. 100m

Last Answer : a. No minimum

Description : What is the minimum visibility for a Cat A aircraft during a circling approach? a. 1500m b. 1600m c. 2400m d. 3600m

Last Answer : a. 1500m

Description : The sequence of marker colours when flying an ILS approach is: a. White, blue, amber b. Blue, white, amber c. Blue, amber, white d. Amber, blue, white

Last Answer : c. Blue, amber, white

Description : How do misty/foggy conditions affect the pilot's judgment on the approach? a. Underestimating range due to illusionary effect through the cockpit glass b. Underestimating range due to the ... to illusionary effect through the cockpit glass d. Overestimating range due to the lights appearing dim

Last Answer : d. Overestimating range due to the lights appearing dim

Description : The callsign suffix for an airfield without radar would be: a. APPROACH b. CENTRE c. INFORMATION d. RADIO

Last Answer : a. APPROACH

Description : What action should be taken if contact is lost with the runway during a circling approach? a. Descend to Decision Height and if still no contact with the runway, initiate a missed approach b. Land on the instrument runway c. Initiate a missed approach d. Return to the FAF

Last Answer : c. Initiate a missed approach

Description : An instrument approach is made up of a number of segments. How many of them are there? a. 4 b. 5 c. 3 d. 6

Last Answer : b. 5

Description : A precision Approach Procedure is defined as: a. An approach using bearing, elevation and distance information b. An approach with a crew of at least 2 pilots trained for such ... An instrument approach procedure utilizing azimuth and glide path information provided by an ILS or a PAR

Last Answer : c. An instrument approach procedure utilizing azimuth and glide path information provided by an ILS or a PAR

Description : An aircraft is allowed to descend below the MSA if: a. The pilot follows the published approach procedures b. The aircraft receives radar vectors c. The pilot has visual contact with the runway and surrounding terrain and is able to maintain visual contact d. All of the above

Last Answer : d. All of the above

Description : What action should be taken when, during an IFR flight in VMC, you suffer a radio failure? a. Return to the aerodrome from which you departed b. Continue flying in VMC and land as ... there are VMC conditions d. Continue flying at your assigned altitude and start your approach at your ETA

Last Answer : b. Continue flying in VMC and land as soon as possible

Description : At the alternate aerodrome, the commander of a turbojet engine aeroplane should have a fuel quantity (final reserve) sufficient for flying during: a. 30 minutes at holding flight speed at 1,500 ft b. 45 ... speed at 1,500 ft c. 30 minutes at cruising speed d. 45 minutes at cruising speed

Last Answer : a. 30 minutes at holding flight speed at 1,500 ft

Description : Refer to CAP697 MRJT1 Fig. 4.3.1 Given: Estimated zero fuel mass 50t; estimated landing mass at destination 52t; final reserve fuel 2t; alternate fuel 1t; flight to destination distance 720nm, true course 030, W/V ... b. 4,400kg / 02hr 02min c. 4,750kg / 02hr 00min d. 4,600kg / 02hr 05min

Last Answer : a. 4,800kg / 01hr 45min

Description : Who has the final authority as to the disposition of the aircraft? a. The State b. The Operator c. The Commander d. The Owner

Last Answer : c. The Commander

Description : To ensure some degree of longitudinal stability in flight, the position of the CG: a. Must always coincide with the AC b. Must be forward of the Neutral Point c. Must be aft of the Neutral Point d. Must not be forward of the aft CG limi

Last Answer : b. Must be forward of the Neutral Point

Description : From the flight deck you observe an aeroplane in the forward left position on an opposite parallel track. What Nav light will be used? a. Green b. Red c. White d. All of the above

Last Answer : b. Red

Description : The correct format for the input of position 50N 00527E to the CDU is: a. 5000.0N00527.0E b. N50E00527 c. N5000.0E00527.0 d. N5000E00527

Last Answer : c. N5000.0E00527.0

Description : The IRS position can be updated: a. On the ground only b. At designated positions en-route and on the ground c. On the ground and overhead VOR/DME d. At selected waypoints and on the ground

Last Answer : a. On the ground only

Description : How is fuel consumption affect by the C of G position, in terms of ANM/kg? a. Increases with a forward C of G b. Decreases with an aft C of G c. Decreases with a forward C of G d. Fuel consumption is not affected by the C of G position

Last Answer : c. Decreases with a forward C of G

Description : The definition of the phrase “STANDBY” is: a. Consider the transmission as not sent b. Proceed with your message c. Wait and I will call you d. Hold your present position

Last Answer : c. Wait and I will call you

Description : An urgency message should include the following information: a. Name of station addressed, aircraft callsign, nature of urgency condition, intention of commander, position, level, heading b. Callsign ... , callsign, present positin, level, ETA destination d. Captain's number, rank and name

Last Answer : a. Name of station addressed, aircraft callsign, nature of urgency condition, intention of commander, position, level, heading

Description : What cannot be left out from a position report? a. Callsign, Flight Level and Time b. Callsign, Position and Time c. Position, Time, Flight Level, Next position and ETA d. Your signature

Last Answer : b. Callsign, Position and Time

Description : The loading limitations shall include: a. All limiting mass and centre of gravity b. All limiting mass, centre of gravity position, mass distribution and floor landing c. All limiting mass ... of gravity position and floor loading d. All limiting mass, mass distributions and centre of gravity

Last Answer : b. All limiting mass, centre of gravity position, mass distribution and floor landing

Description : What is the rule concerning level or height the aircraft should maintain when flying IFR outside controlled airspace unless otherwise directed? a. 2,000 feet above the highest obstacle within 8kms of ... planned track d. 2,000 feet above the highest obstacle within 8kms of the planned track

Last Answer : b. 1,000 feet above the highest obstacle within 8kms of the estimated position of the aircraft

Description : A pressure head is subject to the following errors: a. Position, manoeuvre induced, temperature b. Position, manoeuvre induced c. Position, manoeuvre induced, density d. Position, manoeuvre induced, instrument

Last Answer : d. Position, manoeuvre induced, instrument

Description : A nose wheel control system a. Prevents the nosewheel from castering at all times b. Allows the nosewheel to caster within preset limits about the neutral position c. Allows the nosewheel to ... freely at all times d. Prevents the nose gear from lowering if the nosewheels are not centralised

Last Answer : b. Allows the nosewheel to caster within preset limits about the neutral position

Description : CAS is IAS corrected for: a. Position and instrument error b. Instrument, pressure, and density error c. Relative density only d. Compressibility

Last Answer : a. Position and instrument error

Description : If flaps are lowered during the take-off run: a. The lift would not change until the aircraft is airborne b. The lift would increase when the flaps are lowered c. The lift would decrease d. The acceleration would increase

Last Answer : b. The lift would increase when the flaps are lowered

Description : To give the best obstacle clearance on take-off, take-off should be made with: a. Flaps partially extended and at best rate of climb speed (Vy) b. Flaps partially extended and at best angle of climb ... at best rate of climb speed (Vy) d. Flaps retracted and at best angle of climb speed (Vx)

Last Answer : d. Flaps retracted and at best angle of climb speed (Vx)

Description : Shortly after take-off, the altitude of the aeroplane suffers an abrupt pitch-up and IAS rapidly decreases followed quickly by a decrease in altitude. Engine indications are normal. You should suspect what ... to gain airspeed d. Local clear air turbulence; reduce speed to VRA and ride it out

Last Answer : b. Loss of head wind or an increase in tail wind; apply full power

Description : When does a pilot apply the limitations of the MEL? a. At parking before commencement of taxi b. Prior to take-off c. At any time in flight d. Any time up to coming to a complete stop and applying the parking brake

Last Answer : d. Any time up to coming to a complete stop and applying the parking brake

Description : To act as co-pilot for take-off or landing, you must have: a. Acted as PIC or co-pilot on type in the last 90 days b. Acted as PIC or co-pilot on type in the last 30 days c. Acted as PIC or co-pilot on type in the last 60 days d. Been at the controls for landing in the same type recently

Last Answer : a. Acted as PIC or co-pilot on type in the last 90 days

Description : A flight is to depart from an airport with runway 09 and 27. Surface wind is 270/05; an inversion is reported at 300 feet with turbulence and wind shear. The wind just above the ... throttle during the passage through the inversion d. Depart runway 27 with as steep an ascent as possible

Last Answer : b. Depart on runway 09 with a tailwind

Description : Refer to CAP697 MRJT1 Fig. 4.2 & 4.5.3.2 Estimated take-off mass 57,000kg; ground distance 150nm; temperature ISA -10C; cruise at M0.74. What is the optimum cruise altitude and TAS? a. 25,000ft & 445kt b. 33,000ft & 420kt c. 25,000ft & 435kt d. 33,000ft & 430kt

Last Answer : c. 25,000ft & 435kt

Description : For a flight plan filed before flight, the indicated time of departure is: a. The time overhead the first reporting point after take-off b. The time at which the flight plan is filed c. The estimated off-block time d. The time of take-off

Last Answer : c. The estimated off-block time

Description : When does the first segment of the take-off climb begin? a. When V2 is reached b. When 35 feet is reached c. When flaps are up d. When gear and flaps are up

Last Answer : b. When 35 feet is reached

Description : For take-off performance calculations, what is taken into account? a. OAT, pressure altitude, wind, weight b. Standard temperature, altitude, wind, weight c. Standard altitude, standard temperature, wind, weight d. Standard temperature, pressure altitude, wind, weight

Last Answer : a. OAT, pressure altitude, wind, weight

Description : What is the Total Elapsed Time on a VFR flight plan? a. From take-off to overhead destination b. From take-off to overhead destination + 15 mins c. From take-off to landing d. From taxi to arrival on the gate

Last Answer : a. From take-off to overhead destination

Description : If a jet engine fails during take-off before V1: a. The take-off can be continued or aborted b. The take-off should be aborted c. The take-off should be continued d. The take-off may be continued if the aircraft speed is above VMCG and lies between VGO and VSTOP

Last Answer : b. The take-off should be aborted