Description : If the baudrate fora 64-QAM signal is 2000, what is the bit rate? A) 300 B) 400 C) 1000 D) 12000
Last Answer : 12000
Description : If the bit rate for an FSK signal is1200 bps, thebaud rate is ________. A) 300 B) 400 C) 600 D) 1200
Last Answer : 1200
Description : f the bit rate for an ASK signal is1200 bps, thebaud rate is ________. A) 300 B) 400 C) 600 D) 1200
Description : If the baudrate is400 for a QPSK signal, thebit rate is ________ bps. A) 100 B) 400 C) 800 D) 1600
Last Answer : 800
Description : An analog signal carries 4 bits in each signal unit. If 1000 signal units are sent per second, then baud rate and bit rate of the signal are ............... and .............. (A) 4000 bauds \ sec & ... (B) 2000 bauds \ sec & 1000 bps (C) 1000 bauds \ sec & 500 bps (D) 1000 bauds \ sec & 4000 bps
Last Answer : (D) 1000 bauds \ sec & 4000 bps Explanation: Bit rate is the number of bits per second. Baud rate is the number of signal units per second. Baud rate is less than or equal to the bit rate. Baud rate = 1000 bauds per second (baud/s) Bit rate = 1000 x 4 = 4000 bps
Description : What arethe most commonly used transmission speeds in BPS usedin datacommunication? A. 300 B. 1200 C. 2400 D. 9600 E. None of the above
Last Answer : 9600
Description : Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is __________. a. 400 bps b. 800 bps c. 1600 bps d. 3200 bps
Last Answer : d. 3200 bps
Description : If digitaldata rateof 9600 bps is encoded using 8-level phaseshift keying (PSK) method, the modulation rate is A. 1200 bands B. 3200 bands C. 4800 bands D. 9600 bands E. None of the above
Last Answer : 3200 bands
Description : If delaysare recorded as 10 bit numbers in a 50 router network, and delay vectorsare exchanged twicea second,how muchbandwidth per fill duplex line is occupied by the distributedrouting algorithm? A. 500 bps B. 1500 bps C. 5 bps D. 1000 bps
Last Answer : 1000 bps
Description : Usually, it takes10-bits to represent one character. How many characters can betransmittedat a speed of 1200 BPS? A. 10 B. 12 C. 120 D. 1200 E. None of the above
Last Answer : 120
Description : A device is sending out data at the rate of 2000 bps. How long does it take to send a file of 1,00,000 characters ? a. 50 b. 200 c. 400 d. 800
Last Answer : c. 400
Description : A terminal multiplexer has six 1200 bps terminals and ‘n’ 300 bps terminals connected to it. If the outgoing line is 9600 bps, what is the value of n ? (A) 4 (B) 8 (C) 16 (D) 28
Last Answer : (B) 8
Description : Four channels are multiplexed using TDM. If each channel sends 100 bytes/second and we multiplex 1 byte per channel, then the bit rate for the link is ............... (A) 400 bps (B) 800 bps (C) 1600 bps (D) 3200 bps
Last Answer : (D) 3200 bps Answer: D Explanation: The multiplexer is shown in the Figure. Each frame carries 1 byte from each channel; the size of each frame, therefore, is 4 bytes, or 32 bits. Because each ... channel, the frame rate must be 100 frames per second. The bit rate is 100 32 = 3200 bps.
Description : If the frequency spectrum of a signal has a bandwidth of500 Hz with thehighest frequency at 600 Hz, what shouldbe the samplingrate, according to the Nyquist theorem? A) 200 samples/s B) 500 samples/s C) 1000 samples/s D) 1200 samples/s
Last Answer : 1200 samples/s
Description : An analog signal has a bit rate of 6000 bps and a baud rate of 2000 baud. How many data elements are carried by each signal element ? (A) 0.336 bits/baud (B) 3 bits/baud (C) 120,00,000 bits/baud (D) None of the above
Last Answer : (B) 3 bits/baud
Description : In________, the phase of thecarrier is varied to represent two or more different signal elements. Both peak amplitude and frequency remain constant. A) ASK B) PSK C) FSK D) QAM
Last Answer : PSK
Description : In_________, the frequencyof the carrier signal is varied to representdata. Both peak amplitudeand phase remain constant. A) ASK B) PSK C) FSK D) QAM
Last Answer : FSK
Description : In________, the amplitude of the carrier signal is varied to create signal elements. Both frequency and phase remainconstant. A) ASK B) PSK C) FSK D) QAM
Last Answer : ASK
Description : In an IPv4 datagram, the M bit is 0, the value of HLEN is 10, the value of total length is 400 and the fragment offset value is 300. The position of the datagram, the sequence numbers of the ... 2789 b. First fragment, 2400 and 2759 c. Last fragment, 2400 and 2759 d. Middle fragment, 300 and 689
Last Answer : c. Last fragment, 2400 and 2759
Description : The probability thata singlebit will be inerror on a typical public telephone lineusing 4800 bps modem is 10 to the power -3. If no error detection mechanism is used, the residual error ratefor a communicationline using 9-bit frames is ... to A. 0.003 B. 0.009 C. 0.991 D. 0.999 E. None of the above
Last Answer : 0.009
Description : In a token ring network the transmission speed is 10^7 bps and the propagation speed is 200 metres/micro second. The 1- bit delay in this network is equivalent to: a. 500 metres of cable. b. 200 metres of cable. c. 20 metres of cable. d. 50 metres of cable
Last Answer : c. 20 metres of cable.
Description : Saturated steam at 1 atm is discharged from a turbine at 1200 kg/h. Superheated steam at 300 0C and 1 atm is needed as a feed to a heat exchanger. To produce it, the turbine discharge ... amount of superheated steam at 300 0C produced and the volumetric flow rate of the 400 0C steam.
Last Answer : Solution 1. Mass balance of water 1200 + m1 = m2 ………………………………………… (1) …………………….1 mark 2. Energy balance (1200 kg/h)(2676 kJ/kg) + m1(3278 kJ/kg)
Description : Iridium satellites can provide data communications of up ____ bps data rate. A. 1200 B. 4800 C. 2400 D. 3840
Last Answer : C. 2400
Description : SONET sends ________ frames per second A) 1000 B) 2000 C) 4000 D) 8000
Last Answer : 2000
Description : How many 8-bit characters can be transmitted per second over a 9600 baud serial communication link using asynchronous mode of transmission with one start bit, eight data bits, two stop bits, and one parity bit ? a. 600 b. 800 c. 876 d. 1200
Last Answer : b. 800
Description : Hazardous/polluting chemical industries should have an 'exclusion zone' with a green belt and general public access prohibited around it, covering a radius of __________ metres. (A) 100 (B) 1000 (C) 400 (D) 4000
Last Answer : (B) 1000
Description : Two Pelton turbines A and B have the same specific speed and are working under the same head. Turbine A produces 400 kW at 1000 rpm. If turbine B produces 100kW, then its rpm is (a) 4000 (b) 2000 (c) 1500 (d) 3000
Last Answer : (b) 2000
Description : Infrared range for fiber optics ∙ a. 400 – 700 nm ∙ b. 700 – 1200 nm ∙ c. 300 – 2000 nm ∙ d. 400 – 7000 nm
Last Answer : b. 700 – 1200 nm
Description : ECE Board Exam March 1996 What is the transmission rate of a system for transmitting the output of a microcomputer to a line printer operating at a speed of 30 lines/minute? Assume that the line printer has 8 bits ... and prints out 80 characters/line. A. 800 bps B. 400 bps C. 320 bps D. 640 bps
Last Answer : C. 320 bps
Description : A device is sending out data at the rate of 2000 bps. How long does it take to send a file of 1,00,000 characters ? (A) 50 (B) 200 (C) 400 (D) 800
Last Answer : (C) 400 Explanation: 1,00,000 characters = 1,00,000 x 8 bits = 8,00,000 bits 8,00,000 bits/2000 bps = 400 seconds
Description : Conversion of yellow phosphorous to red phosphorous is done by heating it in covered retorts at __________ °C in absence of air. (A) 50-80 (B) 250-400 (C) 1000-1200 (D) 800-900
Last Answer : (B) 250-400
Description : Speed of the cutter bar in case of combine (grain) is :- a) 400 – 550 rpm b) 500 – 800 rpm C) 800 - 1000 rpm d) 1000 – 1200 rpm
Last Answer : a) 400 – 550 rpm
Description : For protection of level crossing gate in an emergency on BG double line the Gateman should place one detonator at one place and 3 detonators at a subsequent place at a distance of ------- a) and------ ... c) 500 meters and 1000 meters d) 600 meters and 1200 meters* e) 800 meters in 1500 meters
Last Answer : d) 600 meters and 1200 meters*
Description : Indication post for detonator should be provided at a distance of ---------meter and --------- meter for BG level crossing a) 400 meters in 800 meters b) 500 meters and 1200 meters c) 600 meters and 1200 meter * d)600 meters and 1000 meters
Last Answer : c) 600 meters and 1200 meter *
Description : In a digital transmission, the receiver clock is 0.1 percent faster than the sender clock. How many extra bits per second does the receiver receive if the data rate is 1 Mbps ? (A) 10 bps (B) 100 bps (C) 1000 bps (D) 10000 bps
Last Answer : (C) 1000 bps
Description : . The product of the bit rate and distance of a fiber-optic system is 2 Gbits-km/s. What is the maximum rate at 5 km? ∙ A. 100 Mbits/s ∙ B. 200 Mbits/s ∙ C. 400 Mbits/s ∙ D. 1000 Gbits/s
Last Answer : C. 400 Mbits/s
Description : The product of the bit rate and distance of a fiber-optic system is 2 Gbits km/s. What is the maximum rate at 5 km? ∙ a. 100 Mbits/s ∙ b. 200 Mbits/s ∙ c. 400 Mbits/s ∙ d. 1000 Gbits/s
Last Answer : c. 400 Mbits/s
Description : A multiplexer combines four 100-Kbps channels using a time slot of 2 bits. What is the bit rate? (A) 100 Kbps (B) 200 Kbps (C) 400 kbps (D) 1000 Kbps
Last Answer : (C) 400 kbps
Description : The data rate is sometimes calledthe ___ rate. A) baud B) bit C) signal D) none of the above
Last Answer : bit
Description : The signal rate is sometimes called the ____ rate. A) baud B) bit C) signal D) none of the above
Last Answer : baud
Description : The ________ rate defines thenumber of dataelements sent in1s; the______ rate is the numberof signalelements sent in 1s. A) data; signal B) signal; data C) baud; bit D) none of the above
Last Answer : data; signal
Description : Inan HFC network, the upstream data are modulated using the _______ modulation technique. A) QAM B) QPSK C) PCM D) ASK
Last Answer : QPSK
Description : Inan HFC network, the downstream data are modulated using the _______ modulation technique. A) PSK B) QAM C) PCM D) ASK
Last Answer : QAM
Description : DMT is a modulation technique that combineselements of _______ and _______. A) FDM; TDM B) QDM; QAM C) FDM; QAM D) PSK; FSK
Last Answer : FDM; QAM
Description : The constellation diagram of16-QAM has ______ dots. A) 4 B) 16 C) 8 D) none of the above
Last Answer : 16
Description : Which of the following is not an analog-to-analog conversion? A) AM B) PM C) FM D) QAM
Description : _______ uses twocarriers, onein-phase andthe otherquadrature. A) ASK B) PSK C) FSK D) QAM
Description : Quadrature amplitude modulation(QAM) isa combination of ___________. A) ASK and FSK B) ASK and PSK C) PSK and FSK D) none of the above
Last Answer : ASK and PSK
Description : In QAM,both ________ of acarrier frequencyare varied. A) frequencyand amplitude B) phase andfrequency C) amplitudeand phase D) none of the above
Last Answer : amplitudeand phase