The most important property for a jet fuel is its
(A) Viscosity
(B) Freezing point
(C) Calorific value
(D) Flash poin

1 Answer

Answer :

(B) Freezing point

Related questions

Description : In cold countries ethylene glycol is added to water in car radiators. This helps to (a) Reduce the viscosity (b) Make water a better lubricant (c) Lower the freezing point (d) Lower the boiling poin

Last Answer : Lower the freezing point

Description : Which of the following is the most important property for a jet fuel? (A) Cloud point (B) Pour point (C) Colour (D) Freezing point

Last Answer : (D) Freezing point

Description : Which of the following is not an important property of fuel oil/furnace oil? (A) Sulphur content (B) Viscosity (C) Aniline point (D) Flash point

Last Answer : (C) Aniline point

Description : Paraffins are desirable in lubricating oil, as it has got high (A) Viscosity (B) Viscosity index (C) Smoke point (D) Pour poin

Last Answer : (C) Smoke point

Description : Which one is preferred for aircraft engine? (A) High viscosity index lube oil (B) Low viscosity index lube oil (C) High freezing point aviation fuel (D) None of these

Last Answer : (A) High viscosity index lube oil

Description : ick out the undesirable property for a good refrigerant. (A) High thermal conductivity (B) Low freezing point (C) Large latent heat of vaporisation (D) High viscosity

Last Answer : (D) High viscosity

Description : Cetane number is a measure of a. ignition quality b. addition in fuel c. calorific value of fuel d. viscosity of the fuel

Last Answer : ANSWER a. ignition quality

Description : __________ prohibits the use of alcohols directly in petrol engines. (A) Low octane number (B) High cost & availability (C) Low flash point (D) Low calorific value

Last Answer : (B) High cost & availability

Description : Pitch (a product of coal tar distillation) is always mixed with creosote oil, when it is to be burnt in a burner, because (A) Its calorific value is very less (B) Tar neutralises the residual acids ... for its transportation through pipelines at economic pressure drop (D) All (A), (B) and (C)

Last Answer : (C) It reduces viscosity and imparts fluidity for its transportation through pipelines at economic pressure drop

Description : Power alcohol as compared to straight run gasoline has lower (A) Calorific value (B) Octane number (C) Specific gravity (D) Viscosity

Last Answer : (A) Calorific value

Description : Pick out the wrong statement. (A) Surface tension of a liquid is because of the difference in magnitude of adhesive & cohesive forces (B) A hydrometer used for the determination of ... Turbulent fluid flow is characterised by the rapid fluctuation of instantaneous pressure & velocity at a poin

Last Answer : (C) In case of unsteady fluid flow, the velocity at any given point does not change with time

Description : Which of the following statement is incorrect?  A. The liquid fuels consist of hydrocarbons.  B. The liquid fuels have higher calorific value than solid fuels.  C. The solid fuels have higher calorific value than liquid fuels.  D. A good fuel should have low ignition point.

Last Answer : Answer: C

Description : A good solvent used for absorption should not have very high (A) Viscosity (B) Vapor pressure (C) Freezing point (D) All (A), (B) & (C)

Last Answer : (D) All (A), (B) & (C)

Description : Gross and net calorific value of a fuel will be the same (A) If its ash content is zero (B) If its carbon content is very low (C) If its hydrogen/hydrogen compound content is zero (D) Under no circumstances

Last Answer : (C) If its hydrogen/hydrogen compound content is zero

Description : Preheating of combustion air is done to (A) Increase the adiabatic flame temperature (B) Increase the calorific value of the fuel (C) Complete the combustion of fuel (D) Reduce its requirement for effecting the complete combustion

Last Answer : (A) Increase the adiabatic flame temperature

Description : Presence of __________ in a dry gaseous fuel does not contribute to its calorific value. (A) Sulphur (B) Oxygen (C) Hydrogen (D) Carbon

Last Answer : (B) Oxygen

Description : Pick out the wrong statement. (A) High concentration of oxygen in flue gas means high stack loss (B) Gaseous fuels require the least % excess air for complete combustion (C) The ratio of fixed carbon to ... coal is called its 'fuel ratio' (D) Calorific value of natural gas is more than that of LPG

Last Answer : (D) Calorific value of natural gas is more than that of LPG

Description : Coke oven gas is a better fuel than blast furnace gas, because of its higher (A) Calorific value, cleanliness and relatively low distribution cost (due to its low specific gravity) (B) Adiabatic flame temperature ... release rate (thus requiring smaller combustion chamber) (D) All (A), (B) and (C)

Last Answer : (D) All (A), (B) and (C)

Description : Tar is a better fuel than furnace oil, because of its (A) Higher calorific value (B) Lower sulphur content (C) Higher emissivity (0.8-0.9) resulting in higher radiation heat transfer rate (D) Both (A) and (B)

Last Answer : (D) Both (A) and (B)

Description : Which of the following constituents of a fuel does not contribute to its calorific value on combustion? (A) Hydrogen (B) Sulphur (C) Carbon (D) None of these

Last Answer : (D) None of these

Description : Gasification of the solid fuel converts its organic part into combustible by interaction with air/oxygen and steam so as to obtain a secondary gaseous fuel of high calorific value having no ash. Gasification reactions are ... __________ °C. (A) 400-500 (B) 900-1000 (C) 1400-1500 (D) 1700-1800

Last Answer : (B) 900-1000

Description : A fuel containing carbon and carbon monoxide (but containing no hydrogen or its compounds) is burnt in pure oxygen at constant pressure. Its gross calorific value as compared to net calorific value will be (A) More (B) Less (C) Same (D) Data insufficient; can't be predicted

Last Answer : (C) Same

Description : Viscosity index of a lubricating oil (A) Is the measure of its flash point (B) Is the measure of variation of viscosity with temperature (C) Should be low (D) None of these

Last Answer : (B) Is the measure of variation of viscosity with temperature

Description : In case of liquid petrofuels, momentary combustion is observed at its (A) Flash point (B) Preheating temperature corresponding to viscosity of 25 centistokes (C) Flame temperature (D) Fire point

Last Answer : (A) Flash point

Description : Tetraethyl lead (TEL) is added to petrol to (a) prevent its freezing (b) increase its boiling point (c) increase its flash point (d) increase its anti-knocking rating

Last Answer : Ans:(d)

Description : Pick out the wrong statement. (A) Aromatics have higher specific gravity than paraffins (B) Gross calorific value (GCV) of petrofuels is equal to (12400 - 2100 ρ 2 ) where, ρ is the specific gravity ... volume basis (i.e., Kcal/litre) (D) Higher specific gravity of petrofuels means higher C/H ratio

Last Answer : (C) Heavier petrofuels have higher GCV on weight basis (i.e., Kcal/kg) but lower GCV on volume basis (i.e., Kcal/litre)

Description : Temperature of a furnace fired with low calorific value fuel gas (i.e. lean gas) can be increased by (A) Preheating the combustion air (B) Oxygen enrichment of combustion air (C) Preheating the fuel gas (D) All (A), (B) & (C)

Last Answer : (D) All (A), (B) & (C)

Description : Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace? (A) Increase in calorific value of the fuel (B) Increase in flame temperature (C) Reduction in scale losses (D) Saving in fuel consumption

Last Answer : (A) Increase in calorific value of the fuel

Description : Which of the following fuel gases has the highest calorific value? (A) Natural gas (B) Coal bed methane (CBM) (C) Liquefied petroleum gas (LPG) (D) Sewage gas

Last Answer : (C) Liquefied petroleum gas (LPG)

Description : Junker's calorimeter is used to determine the calorific value of (A) Pulverised coal (B) Gaseous fuels (C) Fuel oil (D) None of these

Last Answer : (B) Gaseous fuels

Description : A liquid/gaseous fuel containing hydrocarbons and high amount of sulphur is burnt with 40% excess air. The flue gas still contains large amount of carbon monoxide. This may be due to the (A) Presence of large ... fuel (C) High sulphur content in the fuel (D) Lack of thorough mixing of fuel with air

Last Answer : (D) Lack of thorough mixing of fuel with air

Description : Initial pressure of oxygen introduced into the 'bomb' of the bomb calorimeter for determination of calorific value of coal/fuel oil may be around __________ atm. (A) 3-5 (B) 25-30 (C) 60-65 (D) 95-100

Last Answer : (B) 25-30

Description : For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm3 ), while the C.V. is same on weight basis (i.e., kcal/kg)? (A) Propane and acetylene (B) Propane and LPG (C) Sewage gas and gobar gas (D) B.F. gas and coke oven gas

Last Answer : (A) Propane and acetylene

Description : A fuel with high heat release rate will (A) Require smaller combustion chamber (B) Have high calorific value (C) Have high adiabatic flame temperature (D) None of these

Last Answer : (A) Require smaller combustion chamber

Description : Use of preheated air for combustion of fuel in the furnace, increases the (A) Scale losses of the furnace stock (B) Calorific value of the fuel (C) Flame temperature (D) None of these

Last Answer : (C) Flame temperature

Description : Pick out the wrong statement: (A) Carburetted water gas is also called blue gas (B) Coals are divided in four species according to their carbon content in Seylor's classification (C) Carbonisation time ... and net calorific value of a fuel is the same, if it does not contain hydrogen or hydrocarbons

Last Answer : (A) Carburetted water gas is also called blue gas

Description : Coal tar fuels (CTF) as compared to petroleum based fuel oils have higher (A) Calorific value (B) Higher C/H ratio (C) Sulphur content (D) Difference in gross & net calorific value

Last Answer : (B) Higher C/H ratio

Description : Out of the following fuels, the difference between the net and gross calorific value is maximum in case of (A) Pitch (B) Fuel oil (C) Blast furnace gas (D) Bituminous coal

Last Answer : (B) Fuel oil

Description : Calorific value of (A) Light paraffinic fuel oils is equal to that of equivalent olefins (B) n-paraffin is lower than that of iso-paraffins of the same compounds (C) Light paraffinic fuel ... than that of equivalent olefins (D) Light paraffinic fuel oils is lower than that of equivalent olefins

Last Answer : (C) Light paraffinic fuel oils is higher than that of equivalent olefins

Description : If the specific heat of gaseous products of combustion of a fuel is high, the abiabatic flame temperature will be (A) Low (B) High (C) Very high, if the fuel is of low calorific value (D) None of these

Last Answer : (A) Low(A) Low

Description : Which of the following is not increased by using preheated combustion air in place of ordinary air at room temperature? (A) Calorific value of the fuel (B) Flame temperature achieved (C) Speed of combustion of fuel (D) Heat transfer rate to the stock in the furnace

Last Answer : (A) Calorific value of the fuel

Description : The optimum percentage of excess air for combustion depends upon the__________ of the fuel. (A) Type (solid, liquid or gaseous) (B) Calorific value (C) Sulphur content (D) Ignition temperature

Last Answer : (A) Type (solid, liquid or gaseous)

Description : For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm3) while the C.V. is same on weight basis (i.e., kcal/kg)? (A ... and acetylene (B) Propane and LPG (C) Sewage gas and gobar gas (D) B.F gas and coke oven gas

Last Answer : D) B.F gas and coke oven gas

Description : Higher viscosity of lubricating oil usually signifies (A) Lower Reid vapour pressure (B) Higher acid number (C) Higher flash point and fire point (D) Lower flash point and fire point

Last Answer : (C) Higher flash point and fire point

Description : A multigrade lubricating oil means an oil having high (A) Viscosity index (B) Viscosity (C) Aniline point (D) Flash point

Last Answer : (A) Viscosity index

Description : At yield point' of a copper wire A. the load hasn't exceeded the elastic limit yet; so, Hooke's law applies B. the load has already exceeded the elastic limit and the material has become ... stage has passed and the wire has snapped already D. Like Brass and Bronze, Copper has no yield poin

Last Answer : the load has already exceeded the elastic limit and the material has become plastic

Description : By higher octane number of SI fuel, it is meant that the fuel has (a) Higher heating value (b) Higher flash point (c) Lower volatility (d) Longer ignition delay

Last Answer : Ans : d

Description : Define calorific value of fuel and state its unit.

Last Answer : “Calorific value” of fuel: It is defined as the amount of heat liberated during complete combustion of 1 kg of fuel. It is expressed in terms of KJ/kg.

Description : Linear polymers are normally (A) Thermosetting (B) Thermoplastic (C) Elastometric (D) Having extremely high softening poin

Last Answer : (B) Thermoplastic

Description : Which of the following is an undesirable property for an absorbingsolvent? (A) Low vapour pressure (B) Low velocity (C) Low freezing point (D) None of these

Last Answer : (D) None of these