Description : Which of the following is desirable in diesel and kerosene but is undesirable in gasoline? (A) Aromatics (B) Mercaptans (C) Paraffins (D) Naphthenic acid
Last Answer : (A) Aromatics
Description : Smoke point of a test sample of kerosene is found to be 15 mm. On removal of __________ from it, the smoke point rises to 25 mm. (A) n-paraffins (B) Olefins (C) Aromatics (D) None of these
Last Answer : (C) Aromatics
Description : Which of the following is desirable in petrol (gasoline) but undesirable in kerosene? (A) Paraffins (B) Aromatics (C) Mercaptans
Last Answer : (C) Mercaptans
Description : Which of the following has the highest octane number? (A) Aromatics (B) i-paraffins (C) Naphthenes (D) Olefins
Description : H/C ratio (by weight) for the same number of carbon atoms is the highest in case of (A) Aromatics (B) Paraffins (C) Olefins (D) Naphthenes
Last Answer : (D) Naphthenes
Description : Which of the following is the easiest to crack? (A) Paraffins (B) Olefins (C) Naphthenes (D) Aromatics
Last Answer : (A) Paraffins
Description : Reforming converts (A) Olefins into paraffins (B) Naphthenes into aromatics (C) Naphthenes into olefins (D) Naphthenes into paraffin
Last Answer : (B) Naphthenes into aromatics
Description : Which of the following has the lowest cetane number? (A) Aromatics (B) i-paraffins (C) Naphthene (D) Olefins
Description : For C.I. engines fuel most preferred are a) aromatics b) paraffins c) olefins d) napthenes
Last Answer : Answer: b Explanation: For C.I. engines fuel most preferred are paraffins and for S.I. engines fuel most preferred are aromatics.
Description : For S.I. engines fuel most preferred are a) aromatics b) paraffins c) olefins d) napthenes
Last Answer : Answer: a Explanation: For S.I. engines fuel most preferred are aromatics while for C.I. engines fuel most preferred are paraffins.
Description : In a SI engine, which one of the following is the correct order of the fuels with increasing detonation tendency? (a) Paraffins, olefins, naphthenes, aromatics (b) Aromatics, naphthenes, paraffins, olefins (c) Naphthenes, olefins, aromatics, paraffins (d) Aromatics, naphthenes, olefins, paraffins
Last Answer : Ans :d
Description : Pick out the wrong statement. (A) Lower boiling paraffins have higher octane number than higher paraffins (B) Dehydrogenation of naphthenes to aromatics is a desirable reaction in reforming ... is dearomatised kerosene (D) Catalyst used in catalytic reforming is platinum on silica-alumina base
Last Answer : (C) The most ideal feedstock for thermal reforming is dearomatised kerosene
Description : Which is the most desirable component of a good quality kerosene? (A) i-paraffins (B) Aromatics (C) n-paraffins (D) Naphthenes
Last Answer : (C) n-paraffins
Description : Which is the most undesirable component in kerosene? (A) Aromatics (B) i-paraffins (C) n-paraffins (D) Naphthenes
Description : Pick out the wrong statement about the smoking tendency of various hydrocarbon constituents of kerosene. (A) Smoking tendency of hydrocarbons increases in the order: paraffins → isoparaffins → naphthenes → aromatics (B) Smoking tendency of paraffins increases with decrease in its molecular weight
Last Answer : (B) Smoking tendency of paraffins increases with decrease in its molecular weight
Description : Extractor temperature is maintained at -20°C in Edeleanu process to reduce the __________ of kerosene. (A) Smoke point (B) Paraffins (C) Aromatics (D) Naphthenes
Last Answer : (B) Paraffins
Description : Good quality kerosene should have (A) Low smoke point (B) High smoke point (C) High aromatics content (D) Low paraffins content
Last Answer : (B) High smoke point
Description : Petroleum (A) Is optically active (B) Constitutes mainly of olefins (C) Does not contain asphalt (D) Does not contain aromatics
Last Answer : (A) Is optically active
Description : Visbreaking process is used mainly for making (A) High cetane diesel (B) High octane gasoline (C) Fuel oil (D) Smoke free kerosene
Last Answer : (C) Fuel oil
Description : The catalytic cracking of heavier petroleum fraction is done to produce mainly (A) Gasoline (B) Asphalt (C) Diesel oil (D) Tar
Last Answer : (C) Diesel oil
Description : Aromatics are desired constituents of (A) Lubricating oil (B) Diesel (C) Kerosene (D) Petrol
Last Answer : (D) Petrol
Description : Presence of aromatics in (A) Diesel increases its cetane number (B) Kerosene increases its smoke point (C) Petrol increases its octane number (D) All (A), (B) and (C)
Last Answer : (C) Petrol increases its octane number
Description : Which one of the following processes aims at producing higher yield of gaseous unsaturated hydrocarbons and aromatics like benzene & toluene? (A) Reforming (B) Pyrolysis (C) Alkylation (D) Hydrocracking
Last Answer : (A) Reforming
Description : Alkylation (A) Causes olefins to combine with each other (B) Causes olefins to combine with iso-paraffins (C) Converts iso-paraffin into olefin (D) Converts olefin into paraffin
Last Answer : (B) Causes olefins to combine with iso-paraffins
Description : Isomerisation converts the __________ tot-paraffins. (A) Paraffins (B) Olefins (C) Naphthenes (D) None of these
Description : Polymerisation (A) Produces i-octane from cracked gases containing i-butane and butene (B) Causes olefins to combine with each other (C) Causes aromatics to combine with each other (D) Is aimed at producing lubricating oil
Last Answer : (B) Causes olefins to combine with each other
Description : The main reaction in reforming is the (A) Dehydrogenation of naphthenes (B) Hydrogenation of naphthenes (C) Hydrocracking of paraffins (D) Saturation of olefins
Last Answer : (A) Dehydrogenation of naphthenes
Description : Feedstock for polymerisation is (A) Naphtha (B) Cracked gases rich in C2 & C4 olefins (C) Low boiling aromatics (D) None of these
Last Answer : (B) Cracked gases rich in C2 & C4 olefins
Description : Coal tar (produced by high temperature carbonisation) is the main source of (A) Aromatic compounds (B) Aliphatic compounds (C) Paraffins (D) Olefins
Last Answer : (A) Aromatic compounds
Description : Calorific value of (A) Light paraffinic fuel oils is equal to that of equivalent olefins (B) n-paraffin is lower than that of iso-paraffins of the same compounds (C) Light paraffinic fuel ... than that of equivalent olefins (D) Light paraffinic fuel oils is lower than that of equivalent olefins
Last Answer : (C) Light paraffinic fuel oils is higher than that of equivalent olefins
Description : Laboratory gas is obtained by the cracking of (A) Gasoline (B) Diesel (C) Fuel oil (D) Kerosene
Last Answer : (D) Kerosene
Description : Pick out the correct statement. (A) Paraffins have higher octane number than corresponding iso-paraffin (B) Paraffins have lower smoke point than aromatics
Last Answer : (B) Paraffins have lower smoke point than aromatics
Description : Choose the correct statement. (A) Octane number of i-octane is zero (B) Octane number of paraffins increases with increasing number of carbon atoms (C) Branched chain paraffins have higher octane ... atoms (D) The aromatics have lower octane number than naphthenes with same number of carbon atoms
Last Answer : (A) Octane number of i-octane is zero
Description : Which of the following has the highest gum forming tendency in gosoline? (A) Paraffins (B) Diolefins (C) Aromatics (D) Naphthenes
Last Answer : (B) Diolefins
Description : Which of the following hydrocarbons of same carbon atoms has minimum smoking tendency? (A) Paraffins (B) Naphthenes (C) Aromatics (D) Iso-paraffins
Description : Pick out the wrong statement. (A) Aromatics have higher specific gravity than paraffins (B) Gross calorific value (GCV) of petrofuels is equal to (12400 - 2100 ρ 2 ) where, ρ is the specific gravity ... volume basis (i.e., Kcal/litre) (D) Higher specific gravity of petrofuels means higher C/H ratio
Last Answer : (C) Heavier petrofuels have higher GCV on weight basis (i.e., Kcal/kg) but lower GCV on volume basis (i.e., Kcal/litre)
Description : Pick out the wrong statement. (A) Higher specific gravity of petroleum products means higher C/H ratio (B) Aromatics have lower specific gravity than corresponding paraffins (C) Hydrocarbons of low ... of high specific gravity (e.g., aromatics) possess the maximum thermal energy per unit weight
Last Answer : (B) Aromatics have lower specific gravity than corresponding paraffins
Description : What is the difference between paraffins and olefins?
Last Answer : Need answer
Description : Which of the following is the lightest and most volatile liquid fuel A. diesel B. kerosene C. fuel oil D. gasoline
Last Answer : ANSWER : D
Description : Which of the following is the lightest and most volatile liquid fuel? a. diesel b. kerosene c. gasoline d. fuel oil
Last Answer : ANSWER c. gasoline
Description : Which one of the following petroleum refinery products has the lowest boiling point? (1) Kerosene (2) Gasoline (3) Diesel (4) Lubricating oil
Last Answer : (4) Lubricating oil Explanation: Lubricating oil is the most commonly used lubricant because of its wide range of possible applications. The two basic categories of lube oil are mineral and synthetic.
Description : Octane number is related to (a) Gasoline (b) Kerosene oil (c) Diesel oil (d) Lubricating oi
Last Answer : Gasoline
Description : For rapid curing cutbacks, the oil used is (A) Gasoline (B) Kerosene oil (C) Light diesel (D) Heavy diesel
Last Answer : Answer: Option A
Description : Which of the following reactions is undesirable in the production of catalytically reformed gasoline? (A) Dehydrogenation of Naphthene (B) Dehydrogenation of lower paraffins (C) Dehydrocyclization of higher paraffins (D) Isomerisation of paraffins
Last Answer : (B) Dehydrogenation of lower paraffins
Description : Liquefied Petroleum Gas (LPG) is mainly a mixture of (A) Propane & butane (B) Methane & ethane (C) High boiling olefins (D) High boiling naphthenes
Last Answer : (A) Propane & butane
Description : Carbon/hydrogen ratio (by weight) is maximum (out of following) for (A) Gasoline (B) Kerosene (C) Light gas oil (D) Heavy fuel oil
Last Answer : (A) Gasoline
Description : Catalytic desulphurisation process used for sweetening of straight run gasoline and kerosene uses __________ as catalyst. (A) Bauxite (B) Fuller’s earth (C) Activated clay (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : Clay treatment of petroleum products (A) Decolorizes & stabilises cracked gasoline (B) Desulphurise straight run gasoline & kerosene (C) Adsorb arsenic from feedstock to catalytic reforming (D) All (A), (B) & (C)
Description : Gasoline is 1. Same as diesel oil 2. Same as petrol 3. Obtained from natural gas 4. Obtained from crude oil The correct answers are: (a) 1 and 3 (b) 2 and 4 (c) 3 and 4 (d) 1 and 4
Last Answer : Ans:(b)
Description : Choose the correct statement regarding thermal cracking. (A) Moderate changes in operating temperature does not change the depth of cracking (B) Increased residence time results in the decreased ... of lighter hydrocarbons are more (D) Greater depth of cracking gives lower octane number gasoline
Last Answer : (D) Greater depth of cracking gives lower octane number gasoline