Description : An aircraft heading 017° (T) has a small island showing on the AWR at 45nm range on the 60° left azimuth line. To obtain a fix from this information you should plot: a. Range 45nm and QTE 060 from ... QTE 317 from the center of the island d. Range 45nm and QTE 137 from the center of the island
Last Answer : d. Range 45nm and QTE 137 from the center of the island
Description : Pilots are not allowed to use the indent function on their SSR, unless: a. They operate outside controlled airspace b. If asked by ATC c. Within controlled airspace d. They operate a transponder with mode C
Last Answer : b. If asked by ATC
Description : A basic 2D RNAV system will determine tracking information from: a. Twin DME b. VOR/DME c. Twin VOR d. Any of the above
Last Answer : b. VOR/DME
Description : The DME in an aircraft, cruising at FL210, fails to achieve a lock on a DME at MSL at a range of 210nm. The reason for this is: a. The beacon is saturated b. The aircraft is beyond ... is beyond line of sight range d. The aircraft signal is too weak at the range to trigger a response
Last Answer : c. The aircraft is beyond line of sight range
Description : The DME counters are rotating continuously. This indicates that: a. The DME is unserviceable b. The DME is trying to lock onto range c. The DME is trying to lock onto frequency d. The DME is receiving no response from the ground station
Last Answer : b. The DME is trying to lock onto range
Description : An aircraft is attempting to home to a VOR on the 064 radial. The CDI shows 4 dots fly right with a TO indication. At the same time the co-located DME shows a range of 45nm. Where is the aircraft in relation ... right of track b. 3nm right of track c. 6nm left of track d. 3nm left of track
Last Answer : c. 6nm left of track
Description : Which of the following would give the best indication of speed? a. A VOR on the flight plan route b. A VOR off the flight plan route c. A DME on the flight plan route d. A DME off the flight plan route
Last Answer : c. A DME on the flight plan route
Description : DME and VOR are “frequency paired” because: a. The same receiver can be used for both aids b. The VOR transmitter is easily converted to the required DME frequency c. Cockpit workload is reduced d. Both ground transmitter aerials can be placed on the same site if required
Last Answer : c. Cockpit workload is reduced
Description : The IRS position can be updated: a. On the ground only b. At designated positions en-route and on the ground c. On the ground and overhead VOR/DME d. At selected waypoints and on the ground
Last Answer : a. On the ground only
Description : A typical DME frequency is: a. 1000 MHz b. 1300 MHz c. 1000 kHz d. 1575 MHz
Last Answer : a. 1000 MHz
Description : The range indicated by DME is considered to be accurate within: a. 3% of range b. 1.25% of range c. 0.5nm d. ±0.25nm ±1.25% of range
Last Answer : d. ±0.25nm ±1.25% of range
Description : What is required for navigation in IMC? a. Radio equipment and equipment for guidance until visual point b. Anti-icing equipment c. A serviceable weather radar d. One VHF box and one HF box
Last Answer : a. Radio equipment and equipment for guidance until visual point
Description : The callsign suffix for an airfield without radar would be: a. APPROACH b. CENTRE c. INFORMATION d. RADIO
Last Answer : a. APPROACH
Description : An aircraft is allowed to descend below the MSA if: a. The pilot follows the published approach procedures b. The aircraft receives radar vectors c. The pilot has visual contact with the runway and surrounding terrain and is able to maintain visual contact d. All of the above
Last Answer : d. All of the above
Description : What if, after the collapse of the Soviet union, the SSR of Russia split in 2? How would a European and Asian Russia affect the world today? What would Putin do?
Last Answer : I suspect European Russia would be similar to Belarus: the same dysfunctional political and corrupt legal systems but without the wealth of the raw materials in the east. The Asian side would perhaps ... . But perhaps less belligerent without a direct border with Western countries. That's my guess.
Description : Where can I buy a Chevrolet 2003 SSR?
Last Answer : Go to any of your local auto classifieds. You should be able to find an used Chevrolet 2003 SSR car for sale. This link may be useful to you - http://www.motortrend.com/used_cars/11/chevrolet/ssr/index.html
Description : During a slow decompression, passengers will occur: a. The cabin temperature will fall as pressure reduces b. Body cavities (sinuses, ears, etc.) will become pressurised and may require assistance in ... will operate d. No contra effects, as slow decompression has no effect on the human body
Last Answer : b. Body cavities (sinuses, ears, etc.) will become pressurised and may require assistance in venting
Description : What is the system minimum for an NDB approach? a. 200ft b. 250ft c. 300ft d. 350ft
Last Answer : c. 300ft
Description : The message “CHECK” to an aircraft means that you should: a. Confirm that you received and understood the last message b. Pass the required information to ATC c. Stay where you are d. Examine a system or procedure
Last Answer : d. Examine a system or procedure
Description : The excess cabin altitude alerting system must operate to warn the crew at: a. 8,000ft b. 10,000ft c. 13,000ft d. 14,000ft
Last Answer : b. 10,000ft
Description : The purpose of an accumulator is to: a. Relieve excess pressure b. Store fluid under pressure c. Store compressed gas for tyre inflation d. Remove air from the system
Last Answer : b. Store fluid under pressure
Description : What type of autoland system would be required for the landing to continue following a single failure below alert height? a. Fail soft b. Fail passive c. Fail operational or fail active d. Land 2 system
Last Answer : D. All of the above
Description : With air in the hydraulic system, you would: a. Ignore it because normal operation would remove it b. Bleed the air out of the system c. Allow the accumulator to auto
Last Answer : b. Bleed the air out of the system
Description : At an aircraft taxiing speed of 10mph, the anti-skid braking system is: a. Inoperative b. Operative c. Operative only on the nosewheel brakes d. Operative only on the main wheel brakes
Last Answer : a. Inoperative
Description : A nose wheel control system a. Prevents the nosewheel from castering at all times b. Allows the nosewheel to caster within preset limits about the neutral position c. Allows the nosewheel to ... freely at all times d. Prevents the nose gear from lowering if the nosewheels are not centralised
Last Answer : b. Allows the nosewheel to caster within preset limits about the neutral position
Description : A shuttle valve will: a. Allow the accumulator to be emptied after engine shut down b. Reduce pump loading when normal system pressure is reached c. Automatically switched to a more appropriate source of hydraulic supply d. Operate on a rising pressure, higher than the Full Flow relief valve
Last Answer : c. Automatically switched to a more appropriate source of hydraulic supply
Description : With a gas turbine engine, engine anti-icing should be selected ON': a. Whenever the igniters are on b. Whenever the IOAT is +10°C or below and the air contains visible moisture c. Whenever ... is +10°C or below and it is raining d. Whenever the ice detector system warning light comes on
Last Answer : b. Whenever the IOAT is +10°C or below and the air contains visible moisture
Description : Which is more accurate, the display on my speedometer, or the speed display on my GPS? And, which one will be closer to the cop's radar?
Last Answer : Assume you’re driving as fast as the faster readout.
Description : If the weight of an aircraft is increased the maximum gliding range: a. Decreases b. Increases c. Remains the same, and rate of descent is unchanged d. Remains the same, but rate of descent increases
Last Answer : d. Remains the same, but rate of descent increases
Description : The advantage of a constant speed propeller over a fixed pitch propeller is: a. Higher maximum thrust available b. Higher maximum efficiency c. More blade surface area available d. Nearly maximum efficiency over wide speed range
Last Answer : d. Nearly maximum efficiency over wide speed range
Description : If the ailerons are deflected to 10°, compared to 5°, this will cause: a. An increased angle of bank b. An increased rate of roll c. No change to either bank angle or roll rate d. A reduction in the adverse yawing moment
Last Answer : b. An increased rate of roll
Description : If airbrakes are extended during a glide, and speed maintained, the rate of descent will: a. Increase and glide angle will be steeper b. Increase but glide angle will remain the same c. Decrease d. Remain the same
Last Answer : a. Increase and glide angle will be steeper
Description : An aircraft has a L/D ratio of 15:1 at 50kts in calm air. What would the L/D ratio be with a direct headwind of 25kts? a. 30:1 b. 15:1 c. 25:1 d. 7.5:1
Last Answer : b. 15:1
Description : What true airspeed and angle of attack should be used to generate the same amount of lift as altitude is increased? a. A higher true airspeed for any given angle of attack b. The same true ... c. A lower true airspeed and higher angle of attack d. A constant angle of attack and true airspeed
Last Answer : a. A higher true airspeed for any given angle of attack
Description : How can the pilot increase the rate of turn and decrease the radius at the same time? a. Shallow the bank and increase airspeed b. Steeper bank and increase airspeed c. Steeper bank and decrease airspeed
Last Answer : c. Steeper bank and decrease airspeed
Description : To maintain altitude, what must be done as Indicated Airspeeed (IAS) is reduced? a. Decrease angle of attack to reduce the drag b. Increase angle of attack to maintain the correct lift force c. Deploy the speed brakes to increase drag d. Reduce thrust
Last Answer : b. Increase angle of attack to maintain the correct lift force
Description : Which wind-shear condition results in a loss of airspeed? a. Decreasing headwind or tailwind b. Increasing headwind and decreasing tailwind c. Decreasing headwind and increasing tailwind d. Increasing headwind or tailwind
Last Answer : c. Decreasing headwind and increasing tailwind
Description : What flight condition should be expected when an aircraft leaves ground effect? a. A decrease in parasite drag permitting a lower angle of attack b. An increase induced drag and a requirement ... increase in dynamic stability d. A decrease in induced drag requiring a smaller angle of attack
Last Answer : b. An increase induced drag and a requirement for a higher angle of attack
Description : An aircraft has a stalling speed in level flight of 70kt IAS. In a 60° balanced turn, the stalling speed would be: a. 76kt b. 84kt c. 99kt d. 140kt
Last Answer : c. 99kt
Description : A yaw damper: a. Increases rudder effectiveness b. Must be disengaged before making a turn c. Augments stability d. Increases the rate of yaw
Last Answer : c. Augments stability
Description : If flaps are lowered during the take-off run: a. The lift would not change until the aircraft is airborne b. The lift would increase when the flaps are lowered c. The lift would decrease d. The acceleration would increase
Last Answer : b. The lift would increase when the flaps are lowered
Description : What is the recommended technique to counter the loss of airspeed and resultant lift from wind shear? a. Maintain, or increase, pitch attitude and accept the lower-than-normal airspeed ... shaker, and apply maximum power d. Accelerate the aircraft to prevent a stall by sacrificing altitude
Last Answer : c. Avoid overstressing aircraft, pitch to stick shaker, and apply maximum power
Description : If a landing is to be made without flaps, the landing speed must be: a. reduced b. increased c. the same as for landing with flaps d. the same as for landing with flaps but with a steeper approach
Last Answer : b. increased
Description : t higher elevation airports the pilot should know that indicated airspeed: a. will be unchanged but ground speed will be faster b. will be higher but ground speed will be unchanged c. should be increased to compensate for the thinner air d. should be higher to obtain a higher landing speed
Last Answer : a. will be unchanged but ground speed will be faster
Description : Which statement best describes the operating principle of a constant-speed propeller? a. As throttle setting is changed by the pilot, the prop governor causes pitch angle of the propeller blades to ... the pilot, the RPM of the engines remains constant as the pitch angle of the propeller changes
Last Answer : b. The propeller control regulates the engine RPM and in turn the propeller RPM
Description : The control surface which gives longitudinal control is: a. The rudder b. The ailerons c. The elevators d. The flaps
Last Answer : c. The elevators
Description : To cover the greatest distance when gliding, the gliding speed must be: a. Near to the stalling speed b. As high as possible within VNE limits c. About 30% faster than Vmd d. The one that gives the highest L/D ratio
Last Answer : d. The one that gives the highest L/D ratio
Description : To give the best obstacle clearance on take-off, take-off should be made with: a. Flaps partially extended and at best rate of climb speed (Vy) b. Flaps partially extended and at best angle of climb ... at best rate of climb speed (Vy) d. Flaps retracted and at best angle of climb speed (Vx)
Last Answer : d. Flaps retracted and at best angle of climb speed (Vx)
Description : By changing the angle of attack of a wing, the pilot can control the aeroplane’s: a. Lift and airspeed, but not drag b. Lift, gross weight and drag c. Lift, airspeed and drag d. Lift and drag, but not airspeed
Last Answer : c. Lift, airspeed and drag