Pressure required to increase the density of water by about 1% is __________ atmosphere.
(A) 10
(B) 50
(C) 200
(D) 1000

1 Answer

Answer :

(C) 200

Related questions

Description : The earth's atmosphere is an envelope of gases present upto a height of about __________ kms. (A) 10 (B) 200 (C) 1000 (D) 2000

Last Answer : (B) 200

Description : In a precise diet and nutrition study, you need to determine the average weight and average height of a group each to a precision of 1%. The minimum sample size required is w) 10 x) 100 y) 1000 z) 10,000 

Last Answer : ANSWER: Z -- 10,000 

Description : A rectangle-shaped open-to-sky tank of water has a length of 2 m and a width of 1 m. If the atmospheric pressure is assumed to be 100 kPa and thickness of the tank walls is assumed to be negligible, the force exerted by ... of water is A. 20 kN B. 50 kN C. 100 kN D. 200 kN

Last Answer : 200 kN

Description : In catalytic cracking process, olefins crack __________ times faster than in thermal cracking process. (A) 100 (B) 200-300 (C) 1000-10000 (D) 10

Last Answer : (C) 1000-10000

Description : For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of __________ microns (1 mm = 1000 microns). (A) 1-5 (B) 10-60 (C) 200-300

Last Answer : (B) 10-60

Description : Brownian movement is prominent in the particle size range of __________ microns in case of settling of a particle in a fluid. (A) 2 to 3 (B) 0.01 to 0.10 (C) 200 to 300 (D) 100 to 1000

Last Answer : A) 2 to 3

Description : Threshold limit value (TLV) i.e., the maximum permissible safe limit of phosgene gas which Hitler used to use to kill his enemies in 'gas chamber' is about __________ ppm. (A) < 1 (B) 10-100 (C) 100-200 (D) 100-1000

Last Answer : (A) < 1

Description : The amount of coproporphyrins excreted per day in feces is about (A) 10–50 µgs (B) 100–150 µgs (C) 200–250 µgs (D) 300–1000 µgs

Last Answer : Answer : D

Description : What would happen if gravity suddenly doubled on Earth, but the mass of the atmosphere did not change? (a) Surface pressure would stay the same but the density would increase. (b) Surface ... (d) Surface density and pressure would stay the same because the atmosphere is in hydrostatic balance.

Last Answer : Surface pressure and density would both increase.

Description : What percentage of the atmosphere consists of carbon dioxide? Is it approximately: a) .03% (read: three-hundredths of a percent) b) 1% c) 5% d) 7%

Last Answer : ANSWER: A -- .03%

Description : If the pressure on 100 c.c. of air is halved, then its volume (at the same temperature) would be __________ c.c. (A) 100 (B) 50 (C) 205 (D) 200

Last Answer : (D) 200

Description : A 3% downgrade curve is followed by a 1% upgrade curve and rate of change of grade adopted is 0.1% per 20 m length. The length of the respective vertical curve is : (a) 800 m (b) 200 m (c) 100 m (d) 400 m

Last Answer : (a) 800 m

Description : Energy produced in the nuclear fission is of the order of __________ MeV. (A) 20 (B) 200 (C) 1000 (D) 2000

Last Answer : (B) 200

Description : Molecular sieves are regenerated by heating to __________ °C. (A) < 150 (B) 200-330 (C) > 500 (D) > 1000

Last Answer : (B) 200-330

Description : A centrifugal pump has the following specifications: Power = 4 H.P.; Speed = 800 rpm Head = 8 metres Flow = 1000 litres/minutes. If its speed is halved, the new discharge will be __________ litres/minute. (A) 500 (B) 200 (C) 1000 (D) 750

Last Answer : (A) 500

Description : Optimum reaction temperature in steam reforming of naphtha is __________ °C. (A) 700 - 1000 (B) 300 - 450 (C) 1500-1700 (D) 100-200

Last Answer : (A) 700 - 1000

Description : Regeneration of molecular sieve requires it to be heated to a temperature of about __________ °C. (A) 80-120 (B) 200-300 (C) 600-800 (D) 1000-1100

Last Answer : (D) 1000-1100

Description : Insensible loss of body water of normal adult is about (A) 50–100 ml (B) 100–200 ml (C) 300–500 ml (D) 600–1000 ml

Last Answer : Answer : D

Description : Steam side heat transfer co-efficient in an evaporator is in the range of __________ kcal/hr.m2°C. (A) 10-50 (B) 100-500 (C) 1000-1500 (D) 5000-15000

Last Answer : (D) 5000-15000

Description : Electro-magnetic spectrum range, which is important for radiation varies from __________ microns. (A) 1 to 100 (B) 0.5 to 50 (C) 10 to 100 (D) 100 to 1000

Last Answer : (B) 0.5 to 50

Description : A hydraulic press has a ram of 10 cms in diameter and a plunger of 1 cm in diameter. The force required on the plunger to raise a weight of 10 tons on the ram is __________ kg. (A) 10 (B) 100 (C) 1000 (D) 10000

Last Answer : (B) 100

Description : Minimum isolation distance maintained for foundation seed production in Cotton is — m a. 1000 b. 100 c. 50 d. 200

Last Answer : c. 50

Description : If 99% of the program is written in FORTRAN and the remaining 1% in assembly language, the percentage increase in the programming time compared to writing the entire program in FORTRAN and rewriting the 1% in assembly language is ? 10 5 13 8

Last Answer : 5

Description : Power required for a train weighing 200 Mg to move at a uniform speed of 60 Kmph up an incline of 1 in 200 is (Resistance due to friction is negligible) a.16.67 KW b.163.5 KW c.1000 KW d.9810 KW e.Tapered bearing

Last Answer : b. 163.5 KW

Description : An HFC is required to have Minimum net owned fund of ______ A. Rs. 100 lakhs B. Rs. 200 lakhs C. Rs. 500 lakhs D. Rs. 1000 lakhs E. None of the Above

Last Answer : D. Rs. 1000 lakhs Explanation: For commencing the housing finance business, an HFC is required to have the following in addition to the requirements under the Companies Act, 1956: ♦ Certificate of registration from NHB ♦ Minimum net owned fund of Rs. 1000 lakhs

Description : The amount of liquid required for spraying of plantation crops is : a.) 200-400L/ha b.) 400-600L/ha c.) 600-800L/ha d.) 1000-1200L/ha

Last Answer : d.) 1000-1200L/ha

Description : he amount of liquid required for ground spraying of agricultural crops is : a.) 400-600L/ha b.) 200-400L/ha c.) 1000-2000L/ha d.) 600-800L/ha

Last Answer : a.) 400-600L/ha

Description : Which of the below options are called as appropriate Keyword Density?  A. 0.1-3%  B.01-0.1%  C.7-9.5%  D.3-4%

Last Answer : D.3-4%

Description : The ozone layer in the atmosphere is at a height of about ______. (1) 25 km (2) 50 km (3) 100 km (4) 200 km

Last Answer : (2) 50 km Explanation: Ozone is mainly found in two regions of the Earth's atmosphere. Most ozone (about 90%) resides in a layer that begins between 10 to 17 kilometers above the Earth's surface and extends up to about 50 kilometers

Description : Bulk density of pulverised coal may be about __________ kg/m3 . (A) 100 (B) 500 (C) 1000 (D) 1500

Last Answer : (B) 500

Description : . A 0.5 m high bed made up of a 1 mm dia glass sphere (density 2500 kg/m3 ) is to be fluidised by water (density 1000 kg/m3 ). If at the point of incipient fluidisation, the bed voidage is 40%, the pressure drop across the bed is (A) 4.4 KPa (B) 2.94 KPa (C) 3.7 KPa (D) None of these

Last Answer : (A) 4.4 KPa

Description : Presence of even very minute amount (say 0.1%) of __________ in copper, reduces its electrical conductivity very seriously. (A) Bismuth (B) Arsenic (C) Antimony (D) Both (B) and (C)

Last Answer : (D) Both (B) and (C)

Description : Acid dew point temperature (ADT) of a flue gas produced by the combustion of a fuel containing 1% sulphur may be about __________ °C. (A) 80 (B) 130 (C) 180 (D) 250

Last Answer : (B) 130

Description : The pressure (kg/cm2 ) and temperature (°C) maintained in electrical desalters for crude oil are respectively (A) 10 and 120 (B) 1 and 200 (C) 50 and 250 (D) 10 and 300

Last Answer : (B) 1 and 200

Description : The maximum delivery pressure of compressors can be upto __________ atmospheres. (A) 10 (B) 100 (C) 250 (D) 1000

Last Answer : (D) 1000

Description : A Firm is considering undertaking a project that would yield annual profits (after  depreciation) of Rs 68,000 for 5 years. The initial outlay of the project would be Rs  800,000 and the project's assets would have ... accounting rate of return for this project?  A 16%  B 8.5%  C 8.0%  D 9.1%

Last Answer : A 16%

Description : If the expected time of completion of a project is 60 weeks with a standard deviation of 5 weeks, the probability of completing the project in 50 weeks and 65 weeks respectively will be (A) 2.3% and 84.1% (B) 97.7% and 84.1% (C) 97.7 % and 15.9% (D) 15.9% and 97.7%

Last Answer : (A) 2.3% and 84.1%

Description : Presence of carbon monoxide in atmosphere produced by decomposition of chlorophyll and haemoglobin breakdown of some animals, beyond TLV (>50 ppm) (A) Acts as a green house gas thereby raising earth's ... (B) Causes asphyxia (C) Causes increase in sea level (D) Enhances the green house effect

Last Answer : (B) Causes asphyxia

Description :  Minimum number of bits required to represent maximum value of given analogue signal with 0.1% accuracy is: a. 8 bits b. 9 bits c. 10 bits d. 12 bits

Last Answer : 10

Description : The range of electromagnetic spectrum important in heat transfer by radiation is __________ microns. (A) 0.38-0.78 (B) 0.5-50 (C) 100-1000 (D) 5-50

Last Answer : (B) 0.5-50

Description : Tolerable concentration of toxic carbon monoxide in atmospheric air is about __________ ppm. (A) 50 (B) 1000 (C) 5000 (D) 10000

Last Answer : (A) 50

Description : Conversion of yellow phosphorous to red phosphorous is done by heating it in covered retorts at __________ °C in absence of air. (A) 50-80 (B) 250-400 (C) 1000-1200 (D) 800-900

Last Answer : (B) 250-400

Description : Maximum allowable concentration of CO2 in air for safe working is __________ ppm (parts per million). (A) 50 (B) 1000 (C) 2000 (D) 5000

Last Answer : (D) 5000

Description : If carbon monoxide content in atmospheric air exceeds __________ ppm, death is bound to occur. (A) 50 (B) 500 (C) 1000 (D) 3000 (i.e. 0.3%

Last Answer : (D) 3000 (i.e. 0.3%

Description : If 99% of the program is written in FORTRAN and the remaining 1% in assembly language the percentage increase in the execution time, compared to writing the 1% in assembly language is ? 0.9 0.1 1 0

Last Answer : 0

Description : If the entire program is written in FORTRAN, the percentage increase in the execution time, compared to writing the entire program in FORTRAN and rewriting the 1% in assembly language is ? 0.9 0.8 8 9

Last Answer : 0.8

Description : The population of city S increased from 650,000 in 2000 to 700,000 in 2010, and it is projected that the population will increase by the same number from 2010 to 2020. Approximately what is the projected percent increase in population from 2010 to 2020 ? a) 7.1% b) 7.7% c) 8.3% d) 14.3% e) 15.3%

Last Answer : Required percentage = (750000 - 700000)/700000 * 100 = 7.14% Answer: a)

Description : An oil fired boiler is retrofitted to fire coconut shell chips. Boiler thermal efficiency drops from 82% to 70%. What will be the percentage change in energy consumption to generate the same output a) 12% increase b) 14.6% increase c) 17.1% decrease d) 17.1% increase

Last Answer : d) 17.1% increase