Description : The fuel air ratio in a petrol engine fitted with suction carburetor, operating with dirty air filter as compared to clean filter will be A. higher B. lower C. remain unaffected D. unpredictable
Last Answer : ANSWER : A
Description : If the intake air temperature of Internal combustion engine increases, its efficiency will a. increase b. decrease c.remains same d unpredictable
Last Answer : ANSWER b. decrease
Description : The air requirement of a petrol engine during starting compared to the theoretical air requirement for complete combustion is A. more B.unpredictable C. same D. less
Last Answer : ANSWER : D
Description : If the temperature of intake air in internal combustion engine is lowered, the efficiency will a. increase b. decrease c. remains same d. increases upto certain limit and then decrease
Last Answer : ANSWER a. increase
Description : The efficiency of a internal combustion engine normally is of the order of a. 15-20 % b. 20-25% c. 25-30% d. 30-35%
Last Answer : ANSWER d. 30-35%
Description : In four stroke engine which of the following is also known as power stroke a. Suction stroke b. Compression stroke c. Expansion stroke d. Exhaust stroke (Ans:c) Measurements of fuel and air ... into IC engine,___________its efficiency A. increase B. decrease C. does not alter D. unpredictable on
Last Answer : ANSWER : B
Description : Use of gasoline blend like tetraethyl lead in internal combustion engine a. increases the octane rating of the fuel b. allows engine to operate at higher compression ratio c. avoids auto-ignition of fuel d. all of the above
Last Answer : ANSWER d. all of the above
Description : For same power output and same r, as compared to 2- stroke engines, four stroke SI engines have (a) Higher fuel consumption (b) Lower thermal efficiency (c) Highest exhaust temperatures (d) Higher thermal efficiency
Last Answer : Ans :d
Description : The compressor performance at higher altitude compare to sea level will be A. Same B. Higher C. Lower D. Unpredictable
Last Answer : ANSWER : C
Description : The condensing pressure due to the presence of non-condensable gases, as compared to that actually required forcondensing temperatures without non-condensable gases, (a) will be higher (b) will be ... remain unaffected (d) may be higher or lower depending upon the nature of non-condensable gases
Last Answer : Ans: a
Description : For same compression ratio a. Diesel cycle has lower efficiency than Otto cycle b. Diesel cycle has higher efficiency than Otto cycle c. Diesel cycle and Otto cycle have equal efficiencies d. Depends upon the load on engine
Last Answer : Answer a. Diesel cycle has lower efficiency than Otto cycle
Description : For spark ignition engine, the equivalence ratio of mixture entering the combustion chamber has values (A) for idling and for peak power conditions (B) for both idling and peak power conditions (C) for idling and for peak power conditions (D) for both idling and peak power conditions
Last Answer : ANSWER (B) for both idling and peak power conditions
Description : The most popular firing order in a 4-cylinder inline internal combustion engine is a. 1-2-3-4 b. 1-3-2-4 c. 1-3-4-2 d. 1-2-4-3
Last Answer : ANSWER b. 1-3-4-2
Description : Which of the following is not an internal combustion engine? a. petrol engine b. steam turbine c. diesel engine d. gas turbine
Last Answer : ANSWER b. steam turbine
Description : Volumetric efficiency of a compressor without clearance volume A. Increases with increase in compression ratio B. Decreases wit increase in compression ratio C. Not dependent upon compression ratio D. Unpredictable
Description : Supercharging of an IC engine is done so that the A. thermal efficiency increases B. power output increases C. speed of the engine increases D. power output decreases
Description : An engine produces 10 kW brake power while working with a brake thermal efficiency of 30%. If the calorific value of the fuel used is 40000 kJ/kg, then what is the fuel consumption? (a) 1.5 kg/hour (b) 3 kg/hour (c) 0.3 kg/hour (d) 1 kg/hour
Last Answer : Ans :b
Description : Ratio of actual indicated work to hypothetical indicated work in a steam engine is the (a) Indicated thermal efficiency (b) Friction factor (c) Mechanical efficiency (d) Diagram factor
Last Answer : Ans : d
Description : The thermal efficiency of a diesel engine is of the order of a. 92% b. 68% c. 34% d. 25%
Last Answer : ANSWER c. 34%
Description : A gas engine has a volume of 300 cc and clearance volume of 25 cc. Its volumetric efficiency is 0.8 and mech efficiency is 0.9. What is the volume of the mixture taken in per stroke? (a) 248 cc (b) 252 cc (c) 264 cc (d) 286 cc
Last Answer : Ans : c
Description : The specific fuel consumption of a petrol engine compared to diesel engine of same H.P is A. same B.more C. less D. unpredictable
Description : If petrol is used in a diesel engine a. higher knocking will occur b. efficiency will be low c. low power will be obtained d. black smoke will be produced
Last Answer : ANSWER a. higher knocking will occur
Description : A diesel engine is usually more efficient than a spark ignition engine because a. Diesel being a heavier hydrocarbon, release more heat per kg than gasoline b. The air standard efficiency of diesel ... an Spark ignition engine d.Self ignition temperature of diesel is higher than that of gasoline.
Last Answer : ANSWER c. The compression ratio of a diesel engine is higher than that of an S.I engine
Description : . Thermal efficiency of an internal combustion engine is around __________ percent. (A) 8 (B) 35 (C) 65 (D) 80
Last Answer : Option B
Description : Thermal efficiency of an internal combustion engine is around __________ percent. (A) 8 (B) 35 (C) 65
Description : Combustion of pulverised coal compared to the lumpy coal (A) Provides better control of furnace temperature (B) Facilitates combustion with lower excess air (C) Provides higher thermal efficiency & flame temperature (D) All (A), (B) & (C)
Last Answer : (D) All (A), (B) & (C)
Description : For the same capacity engines, the compression ratio of diesel engine a. is lower than the compression ratio of SI engine b. is higher than the compression ratio of SI engine c. is same as the compression ratio of SI engine d. cannot say
Last Answer : ANSWER b. is higher than the compression ratio of SI engine
Description : In a 4 S diesel engine, the term ‘squish’ refers to the (a) Injection of fuel in the precombustion chamber (b) Discharge of gases from the precombustion chamber (c) Entry of air into the combustion chamber (d) Stripping of fuel from the core
Last Answer : Ans :c
Description : The air requirement of a petrol engine during starting compared to theoretical air required for complete combustion is a. more b. less c. same d. may be more or less depending on engine capacity
Last Answer : ANSWER b. less
Description : Combustion in compression ignition engine is a. homogeneous b. heterogeneous c. laminar d. turbulent
Last Answer : ANSWER b. heterogeneous
Description : Scavenging air in diesel engine means a. air used for combustion under pressure b. forced air for cooling the cylinder c. burnt air containing products of combustion d. air used for forcing burnt gases out of the engines cylinder during the exhaust stroke
Last Answer : ANSWER d. air used for forcing burnt gases out of the engines cylinder during the exhaust stroke
Description : In diesel engine, the fuel is ignited by a. spark b. injected fuel c. heat resulting from compressing air that is supplied for combustion d. ignitor
Last Answer : ANSWER c. heat resulting from compressing air that is supplied for combustion
Description : As a result of detonation in Internal combustion engines the following parameter attains very high value. a. peak pressure b. rate of rise of pressure c. rate of rise of temperature. d. peak temperature.
Last Answer : ANSWER b. rate of rise of pressure
Description : The ratio of indicated thermal efficiency to the corresponding air standard cycle efficiency is called a. net efficiency b. efficiency ratio c. relative efficiency d. overall efficiency
Last Answer : ANSWER c. relative efficiency
Description : Scavenging is usually done to increase the a. thermal efficiency b. speed c. power output d. fuel consumption
Last Answer : ANSWER c. power output
Description : The thermal efficiency of a diesel cycle having fixed compression ratio with increase in cut-off ratio will a. increase b. decrease c. independent d. increase or decrease depending upon other factors
Description : An ideal air standard Otto cycle has a compression ratio of 8.5. If the ratio of the specific heats is 1.4, then what is thermal efficiency (in percentage) of the Otto cycle? a. 57.5% b. 45.7% c. 52.5% d. 95%
Last Answer : ANSWER a. 57.5%
Description : The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P. (a) more (b) less (c) equally. (d) unpredictable
Description : When the rate of evaporation of water is zero, the relative humidity of the air is A. 0% B. 100% C. 50% D. unpredictable
Description : When the dew point temperature is equal to the air temperature then the relative humidity is A. 0% B. 50% C. 100% D. unpredictable
Description : The capacity of the compressor will be highest when its intake temperature is A. Lowest B. highest C. Atmospheric D. Unpredictable
Description : The area of actual indicator diagram on an air compressor as compared to area of ideal indicator diagram is A. Less B. More C. Same D. Unpredictable
Description : Compressor at high altitude will draw A. More power B. Less power C. Same power D. Unpredictable
Description : The C.O.P. of a refrigeration cycle with lowering of condenser temperature, keeping the evaporator temperatureconstant, will (a) increase (b) decrease (c) may increase or decrease depending on the type of refrigerant used (d) remain unaffected
Description : The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature constant, will (a) increase (b) decrease (c) remain unaffected (d) may increase or decrease depending on the type of refrigerant used
Description : Air at dry bulb temperature Td1 is passed through the heating coil and some amount of air is by passed unaffected and leaves with dry bulb temperature Tb2 and the temperature of heated air is Td3 (where Td2 < Td3), what is the ... - Td1) / (Td2 - Td3) D. Bypass Factor = (Td2 - Td3) / (Td2 - Td1)
Description : With the increase in speed of the vehicle, the back pressure will a. decrease b. increase c. remains unaffected d. depends on other factors
Last Answer : ANSWER b. increase
Description : Efficiency of a Carnot engine is given as 80%. If the- cycle direction be reversed, what will be the value of COP ofreversed Carnot cycle (a) 1.25 (b) 0.8 (c) 0.5 (d) 0.25
Last Answer : Ans: d
Description : The reason for supercharging in any engine is to be A. increase efficiency B. increase power C. effect fuel economy D. reduce weight and bulk for a given output
Description : Morse test is conducted on the engine to calculate the mechanical efficiency of A. single cylinder CI engine B. single cylinder SI engine C. only on two stroke engines D. multi cylinder engine