The air-fuel ratio of the petrol engine is governed by A. fuel pump B. governor C. carburetor D. injector  

1 Answer

Answer :

ANSWER : C

Related questions

Description : The fuel air ratio in a petrol engine fitted with suction carburetor, operating with dirty air filter as compared to clean filter will be A. higher B. lower C. remain unaffected D. unpredictable

Last Answer : ANSWER : A

Description : Mixing of air and fuel in the diesel engine occurs in a. injection pump b. carburetor c. engine cylinder d. inlet manifold

Last Answer : ANSWER c. engine cylinder

Description : Rate of burning in the compression ignition engine can be controlled by a. rate of injection of fuel b. rate of air taken into carburetor c. both a. and b. d. none of the above

Last Answer : ANSWER a. rate of injection of fuel

Description : Which of the following is not related to spark ignition engine? a. fuel injector b. spark plug c. flywheel d. distributor

Last Answer : ANSWER a. fuel injector

Description : In a simple carburetor, the air-fuel ratio increases when the A. density of air increases B. velocity of air increases C. velocity of air decreases D. density of air decreases

Last Answer : ANSWER : B

Description : Vapour lock is a. complete or partial stoppage of fuel supply due to vaporization of the fuel b. locking of carburetor due to high vapor pressure c. excess fuel supply to the engine d. supply of liquid fuel to the engine

Last Answer : ANSWER a. complete or partial stoppage of fuel supply due to vaporization of the fuel

Description : Air fuel ratio at which a petrol engine cannot work is A. 8:1 B. 12:1 C. 15:1 D. 20:1 and less

Last Answer : ANSWER : D

Description : Air fuel ratio for idling speed of a petrol engine is approximately A. 1:1 B. 5:1 C. 20:1 D. 10:1

Last Answer : ANSWER : D

Description : The theoretically correct air fuel ratio of a petrol engine is of the order of A. 6:1 B. 10:1 C. 15:1 D. 20:1

Last Answer : ANSWER : C

Description : Air fuel ratio at which a petrol engine cannot work is a. 8:1 b. 10:1 c. 20:1 and less d. 15:1

Last Answer : ANSWER c. 20:1 and less

Description : The theoretically correct air fuel ratio for petrol engine is of the order of a.6 : 1 b. 9 : 1 c. 12 : 1 d. 15 : 1

Last Answer : Answer d. 15:1

Description : (i) Describe the principle of mechanical governor in fuel injection pump. (ii) State four types of injector nozzles

Last Answer : (i) Working Principal of mechanical governor of FIP: The working principle of mechanical governor is illustrated in figure. When the engine speed tends to exceed the limit the weights fly apart. This causes ... ) Multi-hole nozzle 3) Long stem nozzle 4) Pintle nozzles 5) Pintuax nozzles 

Description : In _____________ injection system only one pump is sufficient for multi-cylinder engine. a) air b) mechanical c) compression fuel d) common rail

Last Answer : Answer: d Explanation: None.

Description : In a carburetor the level of the fuel in the float chamber as compared to the level of the main jet in the venture is A. lower B. same C. higher D. same or higher

Last Answer : ANSWER : A

Description : The stoichiometric air fuel ration for petrol is 15:1 . What is the air fuel ratio required for maximum power? (a) 16:1 – 18:1 (b) 15:1 (c) 12:1 – 14:1 (d) 9:1 – 11:1

Last Answer : Ans :c

Description : The air fuel ratio in petrol engines is controlled by a. valve opening / closing b. governing c. carburetion d. scavenging

Last Answer : ANSWER c. carburetion

Description : The specific fuel consumption of a petrol engine compared to diesel engine of same H.P is A. same B.more C. less D. unpredictable

Last Answer : ANSWER : B

Description : The specific fuel consumption per BHP hour for petrol engine is approximately a. 0.1 kg b. 0.2 kg c. 0.25 kg d. 0.35 kg

Last Answer : ANSWER c. 0.25 kg

Description : Which of the following is a device used on a tractor or stationary engine for maintaining nearly constant engine speed under varying loads? 1. Volatility of fuel 2. Governor 3. Pre-ignition 4. carburetor

Last Answer : <!-- [if !supportLists] -->1.   <!-- [endif] -->ans 2  

Description : Which of the following is normally not found in both the S.I. (petrol) & C.I. (diesel) engines? (A) Air filter (B) Fuel injector (C) Exhaust silencer (D) Battery

Last Answer : Option B

Description : In _____________ sensor, output voltage changes in proportion to air-fuel ratio. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature

Last Answer : Answer: b Explanation: Only in exhaust gas sensor, output voltage changes in proportion to air-fuel ratio.

Description : _____________ senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio. a) Engine temperature b) Exhaust gas c) Air flow d) Air inlet temperature

Last Answer : Answer: b Explanation: Exhaust gas senor senses the amount of oxygen in the engine exhaust and calculates airfuel ratio while engine temperature sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting.

Description : If the performance of diesel engine of different sizes, cylinder dimensions and power rating are to be compared, which of the following parameters can be used for such comparison? (a) Swept volume (b) Air fuel ratio (c) Specific brake fuel consumption (d) Volumetric efficiency

Last Answer : Ans :c

Description : The air requirement of a petrol engine during starting compared to the theoretical air requirement for complete combustion is A. more B.unpredictable C. same D. less

Last Answer : ANSWER : D

Description : The air requirement of a petrol engine during starting compared to theoretical air required for complete combustion is a. more b. less c. same d. may be more or less depending on engine capacity

Last Answer : ANSWER b. less

Description : _______________ is used to enable cold starting, with out the use of a heater plug. a) Pintaux nozzle b) Multi hole injector c) Long stem injector d) Pintle nozzle

Last Answer : Answer: a Explanation: Generally, intaux nozzle is used to enable cold starting, with out the use of a heater plug.

Description : In pre-chamber and swirl type of combustion system ______________ is used. a) single hole injector b) multi hole injector c) long stem injector d) pintle nozzle

Last Answer : Answer: d Explanation: In pre-chamber and swirl type of combustion system pintle nozzle is used and not the other nozzles.

Description : The usual types of diesel injectors are : a) single hole injector b) multi hole injector c) long stem injector d) all of the mentioned

Last Answer : Answer: d Explanation: The types of diesel injectors are single hole injector, multi hole injector and long stem injector.

Description : iesel engine has less reserve torque then spark ignition because ∙ Torque-speed curve is governed by volumetric efficiency of fuel pump and engine cylinder ∙ Torque is a function of thermal efficiency ∙ Diesel engine has generally low speed engine ∙ None of the above

Last Answer : ∙ Torque is a function of thermal efficiency

Description : In a naturally aspirated diesel engine, the air is supplied by a A. supercharger B. centrifugal pump C. movement of engine piston D. reciprocating pump

Last Answer : ANSWER : C

Description : HUCR is the highest compression ratio at which the A. engine can be run B. engine gives maximum output C. engine is most efficient D. fuel can be used in a test engine without detonation

Last Answer : ANSWER : D

Description : The tendency of a diesel engine to knock increases if a. engine speed is increased b. engine power is increased c. cetane number of the fuel is increased d. compression ratio is increased

Last Answer : ANSWER d. compression ratio is increased

Description : Use of gasoline blend like tetraethyl lead in internal combustion engine a. increases the octane rating of the fuel b. allows engine to operate at higher compression ratio c. avoids auto-ignition of fuel d. all of the above

Last Answer : ANSWER d. all of the above

Description : The compression ratio cannot be increased beyond certain limit as it results in a. auto-ignition of fuel b. detonation c. engine knocking d. all the above

Last Answer : ANSWER d. all the above

Description : A fuel of cetane number 40 has the same ignition quality as a mixture of a) 40% cetane and 60% alpha methyl naphthalene b) 40% alpha methyl naphthalene and 60% cetane c) 40% petrol and 60% diesel d) 40% diesel and 60% petrol

Last Answer : Answer: a Explanation: A fuel of cetane number 40 has the same ignition quality as a mixture of 40% cetane and 60% alpha methyl naphthalene as cetane number is counted on cetane percentage.

Description : A fuel of an octane number rating of 75 matches in knocking intensity as a mixture of a) 75% iso-octane and 25% normal heptane b) 75% normal heptane and 25% iso-octane c) 75% petrol and 25% diesel d) 75% diesel and 25% petrol

Last Answer : Answer: a Explanation: None.

Description : The self-ignition temperature of diesel oil compared to petrol is a. higher b. lower c. same d. depends on the quality of fuel

Last Answer : ANSWER a. higher

Description : The actual volume of fresh charge admitted in 4-stroke petrol engine is A. equal to stroke volume B. equal stroke volume and clearance volume C. less than stroke volume D. more than stroke volume

Last Answer : ANSWER : C

Description : A diesel engine compared to petrol engine, running at full load is A. less efficient B. equally efficient C. more efficient D. other factors will decide it

Last Answer : ANSWER : C

Description : If diesel is used in a petrol engine a. engine will not run b. engine detonates c. engine gives smoke d. engine knocks

Last Answer : ANSWER a. engine will not run

Description : The back pressure of petrol engine is usually a. 1 ata b. 1.2 ata c. 0.8 ata d. 2 ata.

Last Answer : ANSWER b. 1.2 ata

Description : For low load operation more economical engine is a. petrol engine b. diesel engine c. muticylinder engine d. two stroke engine

Last Answer : ANSWER b. diesel engine

Description : If petrol is used in a diesel engine a. higher knocking will occur b. efficiency will be low c. low power will be obtained d. black smoke will be produced

Last Answer : ANSWER a. higher knocking will occur

Description : In a petrol engine, which of the following gas gets exhausted out without burning and without transformation? a. CO2 b. CO c. O2 d. N2

Last Answer : ANSWER d. N2

Description : The tendency of a petrol engine to knock increases by a. supercharging b. scavenging c. increasing the engine horse power d. reducing the spark advance

Last Answer : ANSWER a. supercharging

Description : Which of the following is not an internal combustion engine? a. petrol engine b. steam turbine c. diesel engine d. gas turbine

Last Answer : ANSWER b. steam turbine

Description : A spark plug is used in a. petrol engine b. diesel engine c. gas engine d. steam engine

Last Answer : ANSWER a. petrol engine

Description : Solid injection in CI engine means injection of A. solid fuel only B. liquid fuel only C. liquid fuel and air D. solid fuel and air

Last Answer : ANSWER : B

Description : In diesel engine the fuel injected would burn instantaneously at about compressed air temperature of A. 1000°C B. 250°C C. 450°C D. 2000°C

Last Answer : ANSWER : A

Description : Which of the following is compressed in a diesel engine cylinder A. air B. fuel C. air and fuel D. air and lub oil

Last Answer : ANSWER : A