Description : Sum of tread and rise must lie between (A) 300 to 350 mm (B) 400 to 450 mm (C) 500 to 550 mm (D) 600 to 650 mm
Last Answer : Answer: Option B
Description : The cost of the earthwork in excavation for the surface drain of cross-section shown in the given figure for a total length of 5 metres @ Rs. 450% cum, is (A) Rs. 400 (B) Rs. 425 (C) Rs. 450 (D) Rs. 500
Last Answer : (C) Rs. 450
Description : Number of bricks required for one cubic metre of brick masonry is (A) 400 (B) 450 (C) 500 (D) 550
Last Answer : Answer: Option C
Description : Hot extrusion of aluminium is done in the temperature range of __________ °C. (A) 550-600 (B) 450-500 (C) 350-400 (D) 250-300
Last Answer : (C) 350-400
Description : Number of bricks required for 1 cubic meter of brick masonry is a)400 b) 450 c) 500* d) 550
Last Answer : c) 500*
Description : Side face reinforcement is provided when the depth of beam exceeds [ A ] 250 mm [ B ] 450 mm [ C ] 550 mm [ D ] 750 mm
Last Answer : [ D ] 750 mm
Description : Maximum root zone depth for Maize (a) 200-300 mm (b) 400-600 mm (c) 500-600 mm (d) 350- 450 mm
Last Answer : (b) 400-600 mm
Description : Pick up the wrong nominal internal diameter of cast iron (spun) pipes in mm from the following: (A) 300 (B) 400 (C) 550 (D) 650
Last Answer : (C) 550
Description : The Maximum spacing of the longitudinal bars measured long the periphery of the column should be [ A ] 250 mm [ B ] 300 mm [ C ] 400 mm [ D ] 450 mm
Last Answer : [ B ] 300 mm
Description : The value of 'A' of Indian type W.C. shown in the given figure is: (A) 25 cm (B) 30 cm (C) 40 cm (D) 45 cm
Last Answer : (B) 30 cm
Description : The value of 'B' of Indian type W.C. shown in the given figure is: (A) 45 cm (B) 50 cm (C) 30 cm (D) 25 cm
Last Answer : (A) 45 cm
Description : To pump water from a water reservoir 3 m deep and maximum water level at 135 m, a pump is installed to lift water up to R.L. 175 m at a constant rate of 36,00,000 litres per hour. If the length of the ... the water horse power of the pump is (A) 400 (B) 450 (C) 500 (D) 600
Last Answer : (D) 600
Description : For one cubic metre of brick masonry, number of bricks required, is (A) 400 (B) 425 (C) 450 (D) 500
Last Answer : Answer: Option D
Description : The maximum spacing of main steel in slabs has been limited to [ A ] 250 mm [ B ] 300 mm [ C ] 450 mm [ D ] 500 mm
Description : While placing of concrete the thickness of each layer for R.C.C. is [ A ] 150 to 300 mm [ B ] 450 mm [ C ] 500 to 750 mm [ D ] 500 mm
Last Answer : [ A ] 150 to 300 mm
Description : 74 Total iron ore reserves in Pakistan are _______ A. 400 million tonnes B. 500 million tonnes C. 550 million tonnes D. 590 million tonnes
Last Answer : ANSWER: B
Description : Total iron ore reserves in Pakistan are _______ A. 400 million tonnes B. 500 million tonnes C. 550 million tonnes D. 590 million tonnes
Description : Speed of the cutter bar in case of combine (grain) is (a)400-550 rpm (b) 500-800rpm (c)800-1000rpm (d) 1000-1200rpm
Last Answer : a)400-550 rpm
Description : Speed of the cutter bar in case of combine (grain) is :- a) 400 – 550 rpm b) 500 – 800 rpm C) 800 - 1000 rpm d) 1000 – 1200 rpm
Last Answer : a) 400 – 550 rpm
Description : The monthly incomes of A and B are in the ratio 4:5, their expenses are in the ratio 5 : 6. If 'A' saves Rs.25 per month and 'B' saves Rs.50 per month, what are their respective incomes? A) Rs.400 and Rs.500 B) Rs.240 and Rs.300 C) Rs.320 and Rs.400 D) Rs.440 and Rs.550 E) NONE
Last Answer : Answer: A Let AA's income be = 4x AA's expenses, therefore = 4x–25 Let BB's income be = 5x BB's expenses, therefore = 5x–50 We know that the ratio of their expenses = 5:6 ⇒24x−150=25x−250 ⇒ Therefore, x=100 A's income =4x=400 and B's income =5x=500
Description : According to IS: 456-2000, the maximum cement content exclusive of admixtures is [ A ] 200 kg/m3 [ B ] 300 kg/m3 [ C ] 450 kg/m3 [ D ] 550 kg/m3
Last Answer : [ C ] 450 kg/m3
Description : According to IS:456 minimum cement content inclusive of admixtures is [ A ] 200 kg/m3 [ B ] 300 kg/m3 [ C ] 450 kg/m3 [ D ] 550 kg/m3
Last Answer : [ B ] 300 kg/m3
Description : In Dry farming, what is the annual rainfall (in mm) available? a. A Less than 550 mm b. B Less than 500 mm c. C Less than 950 mm d. D Less than 750 mm
Last Answer : d. D Less than 750 mm
Description : Is 450 closer to 400 or 500?
Last Answer : Technically, it's closer to neither, but as a rule of rounding, if it's halfway, you round up, so you would round it to 500.
Description : As per the Constitution of India, what is the limit prescribed for the number of members in the Legislative Assembly of a State? (1) 350 members (2) 400 members (3) 450 members (4) 500 members
Last Answer : (4) 500 members Explanation: The number of members ranges between 60 and 500.
Description : A vibrating machine of 100 kg is mounted on a rubber pad which has stiffness of 500 N/m. Determine force transmitted to the foundation if the unbalanced force 500 N acts on it. The frequency ratio (ω/ω n ) is 1.5 and ξ = 0.5 A. 461.62 N B. 400.23 N C. 450 N D. Insufficient data
Last Answer : A. 461.62 N
Description : What is the range of the visible light cure beam: A. 100-120 nm B. 200-300 nm C. 400-430 nm D. 470 nm or 450-500 nm
Last Answer : D. 470 nm or 450-500 nm
Description : What is the clear distance between two consecutive steel channel sleepers on Girder bridges? (a) 450 mm* (b) 510 mm (c) 500 mm (d) 460 mm
Last Answer : (a) 450 mm*
Description : What is the clear distance between two consecutive bridge Timbers or Girder bridge? (a) 450 mm (b) 510 mm* (c) 500 mm (d) 520 mm
Last Answer : (b) 510 mm*
Description : n Girder and Slab Bridges Danger level should be marked below bottom of girders/slabs for water way is > 12.20 < 30.5 m a) 300 mm b) 600 mm* c) 500 mm d) 450 mm
Last Answer : b) 600 mm*
Description : In Girder and Slab Bridges Danger level should be marked below bottom of girders/slabs for water way is > 6.10 < 12.2 m a) 300 mm b) 600 mm c) 450 mm* d) 500 mm
Last Answer : c) 450 mm*
Description : Clear distance between consecutive sleepers not to exceed on bridges in BG is a) 450 mm* b) 600 mm c) 510 mm d) 500 mm
Last Answer : a) 450 mm*
Description : In cement pressure grouting holes should be drilled at spacing in both direction at a) 150 – 500 mm b) 450 mm c) 500 – 750 mm* d) 1000 mm
Last Answer : c) 500 – 750 mm*
Description : What is the electric field intensity at a distance of 20cm from a charge 2 X 10 -6 C in vacuum? a) 250,000 b) 350,000 c) 450,000 d) 550,000
Last Answer : c) 450,000
Description : The temperature at which plastic layer formation takes place during carbonisation of coal varies from __________ °C. (A) 100 to 150 (B) 350 to 450 (C) 550 to 650 (D) 700 to 850
Last Answer : (B) 350 to 450
Description : In tractor transmission oil and oil from the steering worm and sector housing should be changed after how many working hours? 1.450 2. 550 3. 650 4. 750
Last Answer : ans 4
Description : The labelled price of a product is Rs 750. If it is sold at a 20% discount, the dealer earns a 25% profit. What is the cost price? 1. Rs 550 2. Rs 450 3. Rs 435 4. Rs 480
Last Answer : 1. Rs 550
Description : Three electric bulbs of 200 W, 200 W and 400 W are connected as shown in figure. The resultant power of the combination is
Last Answer : Three electric bulbs of 200 W, 200 W and 400 W are connected as shown in figure. The resultant power of the ... W B. 400 W C. 200 W D. 600 W
Description : As per IS:1139, the characteristic yield strength for cold twisted deformed bars is [ A ] 250 N/mm2 [ B ] 415 N/mm2 [ C ] 500 N/mm2 [ D ] 550 N/mm2
Last Answer : [ C ] 500 N/mm2
Description : As per IS:1139, the characteristic yield strength for hot rolled High yield strength deformed bars is [ A ] 250 N/mm2 [ B ] 415 N/mm2 [ C ] 500 N/mm2 [ D ] 550 N/mm2
Last Answer : [ B ] 415 N/mm2
Description : Match the items given in column I with those in column II and select the correct option given below. Column I Column II (A) Tidal volume (i) 2500 - 3000 mL (B) Inspiratory reserve (ii) 1100 - 1200 mL volume (C) Expiratory reserve (iii ... i) (iv) (ii) (c) (i) (iv) (ii) (iii) (d) (iv) (iii) (ii) (i)
Last Answer : (b) (iii) (i) (iv) (ii)
Description : Water requirement in Maize (a) 400-500mm (b) 600- 800 mm (c) 500- 800 mm (d) 600- 700 mm
Last Answer : (c) 500- 800 mm
Description : A square object of 4 mm is subjected to a force of 3000 N. What is the maximum allowable shear stress acting on it? a. 250.14 mm2 b. 281.25 mm2 c. 400.32 mm2 d. 500 mm2
Last Answer : b. 281.25 mm2
Description : The size of a plane table is (A) 750 mm × 900 mm (B) 600 mm × 750 mm (C) 450 mm × 600 mm (D) 300 mm × 450 mm
Last Answer : (B) 600 mm × 750 mm
Description : In slabs the Maximum horizontal distance between parallel main reinforcement should not exceed i.Three times effective depth ii Five times effective depth iii 300mm iv 450 mm [ A ] i and iii [ B ] i and iv [ C ] ii and iii [ D ] ii and iv
Last Answer : [ A ] i and iii
Description : The Maximum spacing of Secondary reinforcement in slabs should be [ A ] Less than 450 mm [ B ] Less than 300 mm [ C ] Smaller of three times the effective depth and 450 mm [ D ] Smaller of five times the effective depth and 450 mm
Last Answer : [ D ] Smaller of five times the effective depth and 450 mm
Description : According to IS: 456-2000 Maximum spacing of shear reinforcement in no case shall not exceed [ A ] 250 mm [ B ] 300 mm [ C ] 350 mm [ D ] 450 mm
Description : According to IS: 456-2000 spacing of vertical stirrups for shear reinforcement has been limited to [ A ] 0.75 d [ B ] 450 mm [ C ] lesser of 0.75 d or 300 mm [ D ] lesser of 0.75d or 450 mm
Last Answer : [ C ] lesser of 0.75 d or 300 mm