Description : In a 75 cc engine the parameter cc indicates a. fuel tank capacity b. lubricating oil capacity c. swept volume d. cylinder volume
Last Answer : ANSWER c. swept volume
Description : A gas engine has a volume of 300 cc and clearance volume of 25 cc. Its volumetric efficiency is 0.8 and mech efficiency is 0.9. What is the volume of the mixture taken in per stroke? (a) 248 cc (b) 252 cc (c) 264 cc (d) 286 cc
Last Answer : Ans : c
Description : An engine working on air standard Otto cycle has a cylinder diameter of 10 cm and stroke length of 15 cm. The ratio of specific heats for air is 1.4. If the clearance volume is 196.3 cc and the heat supplied per kg of air per ... kg of air is a. 879.1 kJ/ b. 890.2 kJ c. 895.3 kJ d. 973.5 kJ
Last Answer : ANSWER d. 973.5 kJ
Description : Air fuel ratio at which a petrol engine cannot work is A. 8:1 B. 12:1 C. 15:1 D. 20:1 and less
Last Answer : ANSWER : D
Description : Air fuel ratio for idling speed of a petrol engine is approximately A. 1:1 B. 5:1 C. 20:1 D. 10:1
Description : The theoretically correct air fuel ratio of a petrol engine is of the order of A. 6:1 B. 10:1 C. 15:1 D. 20:1
Last Answer : ANSWER : C
Description : The reason for supercharging in any engine is to be A. increase efficiency B. increase power C. effect fuel economy D. reduce weight and bulk for a given output
Description : The fuel air ratio in a petrol engine fitted with suction carburetor, operating with dirty air filter as compared to clean filter will be A. higher B. lower C. remain unaffected D. unpredictable
Last Answer : ANSWER : A
Description : HUCR is the highest compression ratio at which the A. engine can be run B. engine gives maximum output C. engine is most efficient D. fuel can be used in a test engine without detonation
Description : Solid injection in CI engine means injection of A. solid fuel only B. liquid fuel only C. liquid fuel and air D. solid fuel and air
Last Answer : ANSWER : B
Description : The specific fuel consumption of a petrol engine compared to diesel engine of same H.P is A. same B.more C. less D. unpredictable
Description : In diesel engine the fuel injected would burn instantaneously at about compressed air temperature of A. 1000°C B. 250°C C. 450°C D. 2000°C
Description : The air-fuel ratio of the petrol engine is governed by A. fuel pump B. governor C. carburetor D. injector
Description : Which of the following is compressed in a diesel engine cylinder A. air B. fuel C. air and fuel D. air and lub oil
Description : The output of a diesel engine can be increased without increasing the engine speed or size in the following way A. feeding more fuel B. increasing the flywheel size C. heating intake air D. supercharging
Description : If one cylinder of a diesel engine receives more fuel than others , then for that cylinder the A. exhaust will be smoky B. scavenging occurs C. exhaust temperature will be high D. engine starts overheating
Description : The specific fuel consumption for diesel engine is approximately A. 0.15 kg/kWh B. 0.2 kg/kWh C. 28 kg/kWh D. 0.36 kg/kWh
Description : In four stroke engine which of the following is also known as power stroke a. Suction stroke b. Compression stroke c. Expansion stroke d. Exhaust stroke (Ans:c) Measurements of fuel and air ... into IC engine,___________its efficiency A. increase B. decrease C. does not alter D. unpredictable on
Description : In _____________ injection system only one pump is sufficient for multi-cylinder engine. a) air b) mechanical c) compression fuel d) common rail
Last Answer : Answer: d Explanation: None.
Description : The _____________ sensor, monitors mass or volume of air flowing into the intake manifold for adjusting the quantity of fuel. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: c Explanation: The air flow sensor, monitors mass or volume of air flowing into the intake manifold for adjusting the quantity of fuel while exhaust gas senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio.
Description : In _____________ sensor, output voltage changes in proportion to air-fuel ratio. a) engine temperature b) exhaust gas c) air flow d) air inlet temperature
Last Answer : Answer: b Explanation: Only in exhaust gas sensor, output voltage changes in proportion to air-fuel ratio.
Description : _____________ senor senses the amount of oxygen in the engine exhaust and calculates air-fuel ratio. a) Engine temperature b) Exhaust gas c) Air flow d) Air inlet temperature
Last Answer : Answer: b Explanation: Exhaust gas senor senses the amount of oxygen in the engine exhaust and calculates airfuel ratio while engine temperature sensor senses the temperature of the engine coolant, and from this data the computer adjusts the mixture strength to rich side for cold starting.
Description : Disadvantage of hydrogen as a fuel in IC engine is a) storage is safe b) low NOx c) detonating tendency d) easy handling
Last Answer : Answer: c Explanation: None.
Description : An engine produces 10 kW brake power while working with a brake thermal efficiency of 30%. If the calorific value of the fuel used is 40000 kJ/kg, then what is the fuel consumption? (a) 1.5 kg/hour (b) 3 kg/hour (c) 0.3 kg/hour (d) 1 kg/hour
Last Answer : Ans :b
Description : If the performance of diesel engine of different sizes, cylinder dimensions and power rating are to be compared, which of the following parameters can be used for such comparison? (a) Swept volume (b) Air fuel ratio (c) Specific brake fuel consumption (d) Volumetric efficiency
Last Answer : Ans :c
Description : The tendency of knocking in CI engine reduces by (a) High self ignition temperature of fuel (b) Decrease in jacket water temperature (c) Injection of fuel just before TDC (d) Decrease in injection pressure
Description : In a 4 S diesel engine, the term ‘squish’ refers to the (a) Injection of fuel in the precombustion chamber (b) Discharge of gases from the precombustion chamber (c) Entry of air into the combustion chamber (d) Stripping of fuel from the core
Description : Velocity of flame propagation in SI engine is maximum for a fuel air mixture which is (a) 10% richer than stoichiometric (b) Equal to stoichiometric (c) More than 10% richer than stoichiometric (d) 10% leaner than stoichiometric
Last Answer : Ans :a
Description : The fuel in diesel engine is normally injected at pressure of a. 5-10 kg/cm2 b. 20-25 kg/cm2 c 60-80 kg/cm2 d. 90-130 kg/cm2
Last Answer : ANSWER d. 90-130 kg/cm2
Description : Air fuel ratio at which a petrol engine cannot work is a. 8:1 b. 10:1 c. 20:1 and less d. 15:1
Last Answer : ANSWER c. 20:1 and less
Description : Which of the following is not related to spark ignition engine? a. fuel injector b. spark plug c. flywheel d. distributor
Last Answer : ANSWER a. fuel injector
Description : Vapour lock is a. complete or partial stoppage of fuel supply due to vaporization of the fuel b. locking of carburetor due to high vapor pressure c. excess fuel supply to the engine d. supply of liquid fuel to the engine
Last Answer : ANSWER a. complete or partial stoppage of fuel supply due to vaporization of the fuel
Description : A engine will generate maximum torque when it a. runs at maximum speed b. develops maximum power c. runs at lowest speed d. consumes more fuel
Last Answer : ANSWER c. runs at lowest speed
Description : Mixing of air and fuel in the diesel engine occurs in a. injection pump b. carburetor c. engine cylinder d. inlet manifold
Last Answer : ANSWER c. engine cylinder
Description : The tendency of a diesel engine to knock increases if a. engine speed is increased b. engine power is increased c. cetane number of the fuel is increased d. compression ratio is increased
Last Answer : ANSWER d. compression ratio is increased
Description : The theoretically correct air fuel ratio for petrol engine is of the order of a.6 : 1 b. 9 : 1 c. 12 : 1 d. 15 : 1
Last Answer : Answer d. 15:1
Description : Which of the following medium is compressed in a diesel engine cylinder? a. air b. air and fuel c. air and lubricating oil d. fuel
Last Answer : ANSWER a. air
Description : The output of a diesel engine can be increased without increasing the engine size in following way a. injecting more fuel b. increasing flywheel size c. scavenging d. supercharging
Last Answer : ANSWER d. supercharging
Description : The specific fuel consumption per BHP hour for petrol engine is approximately a. 0.1 kg b. 0.2 kg c. 0.25 kg d. 0.35 kg
Last Answer : ANSWER c. 0.25 kg
Description : The specific fuel consumption per BHP hour for diesel engine is approximately a. 0.1 kg b. 0.2 kg c. 0.3 kg d. 0.4 kg
Last Answer : ANSWER b. 0.2 kg
Description : Supercharging is the process of a. supplying the engine with air at a density greater than the density of the surrounding atmosphere b. providing forced cooling air c. injecting excess fuel d. raising the exhaust pressure
Last Answer : ANSWER a. supplying the engine with air at a density greater than the density of the surrounding atmosphere
Description : In diesel engine, the fuel is ignited by a. spark b. injected fuel c. heat resulting from compressing air that is supplied for combustion d. ignitor
Last Answer : ANSWER c. heat resulting from compressing air that is supplied for combustion
Description : Rate of burning in the compression ignition engine can be controlled by a. rate of injection of fuel b. rate of air taken into carburetor c. both a. and b. d. none of the above
Last Answer : ANSWER a. rate of injection of fuel
Description : Use of gasoline blend like tetraethyl lead in internal combustion engine a. increases the octane rating of the fuel b. allows engine to operate at higher compression ratio c. avoids auto-ignition of fuel d. all of the above
Last Answer : ANSWER d. all of the above
Description : The compression ratio cannot be increased beyond certain limit as it results in a. auto-ignition of fuel b. detonation c. engine knocking d. all the above
Last Answer : ANSWER d. all the above
Description : How much is the clearence between motherboard tray and side panel on Lian Li a10 case (concerning cable managment) ?
Last Answer : Which side panel? There appears to be the standard space around the mobo as seen in these pictures .
Description : Which of the following is the lightest and most volatile liquid fuel A. diesel B. kerosene C. fuel oil D. gasoline
Description : In a simple carburetor, the air-fuel ratio increases when the A. density of air increases B. velocity of air increases C. velocity of air decreases D. density of air decreases
Description : In a carburetor the level of the fuel in the float chamber as compared to the level of the main jet in the venture is A. lower B. same C. higher D. same or higher
Description : Motoring test is conducted on IC engines to determine A. brake power B. indicated power C. friction power D. fuel consumption at full load